Cu nanoparticles were produced by using solid-state dewetting (dry) of a 1.3 nm Cu layer or laser ablation of a Cu solid target (wet) in acetone and methanol. The morphology and chemical composition of the nanoparticles were investigated as a function of the synthesis methods and their key parameters of the annealing temperature (200–500 °C) and the liquid environment during the ablation. Cu nanoparticles were then embedded in transparent conductive oxide (TCO) films as aluminum-doped zinc oxide (AZO) or zirconium-doped indium oxide (IZrO); the TCObott/Cu nanoparticle/TCOtop structures were synthesized with all combinations of AZO and IZrO as the top and bottom layers. The goal was to achieve a plasmonic and conductive structure for photovoltaic applications via a comparison of the involved methods and all fabricated structures. In particular, solid-state dewetting produced faceted or spherical (depending on the annealing temperature) nanoparticles with an average size below 150 nm while laser ablation produced spherical nanoparticles below 250 nm. Dry and wet plasmonic conductive structures as a function of the TCOs employed and the temperature of annealing could reach a sheet resistance of 86 Ω/sq. The energy band-gap Egap, absorbance, transmittance, and reflectance of the plasmonic conductive structures were investigated in the UV–vis–NIR range. They showed a dependence on the sequence of the top and bottom TCO, with best transmittances of 89.4% for the dry plasmonic conductive structure and 84.7% for the wet plasmonic conductive structure. The latter showed a higher diffused transmittance of between 10–20% in the visible range.
Indium oxide (In2O3) is one of the most used materials for the synthesis of transparent electronics devices and currently tin-doped indium oxide (ITO) dominates the field of Transparent Conductive Oxides for most applications, from ICT to photovoltaics. In this work we present a study on the responses of indium oxide upon the formation, and stabilization, of point defects induced with different methods. After the deposition of In2O3 thin films via RF magnetron sputtering, treatments such as Ion Implantation (I.I.), Ultraviolet (UV) irradiation and Sun exposure were employed to generate oxygen vacancies as intrinsic dopants. Both I.I. and UV irradiations significantly improved the electrical conductivity of films, increasing the carrier density by up to 3 orders of magnitude. Moreover, after I.I. also the crystalline quality of the films was enhanced. To monitor the stability of oxygen vacancies upon exposure to ambient atmosphere, the ageing of samples was followed and recorded for a couple of weeks, reporting a fast and strong degradation of electrical properties. As a facile strategy to counteract the sheet resistance increase, samples were encapsulated in an ultra-thin (≈10 nm) SiO2 layer deposited via sputtering. Irradiated and encapsulated films retained a much lower sheet resistance throughout the observation time, preserving the samples conductivity.