Oxygen vacancies are a major factor that controls the electrical characteristics of the amorphous indium-gallium-zinc oxide transistor (a-IGZO TFT). Oxygen vacancies are affected by the composition ratio of the a-IGZO target and the injected oxygen flow rate. In this study, we fabricated three types of a-IGZO TFTs with different oxygen flow rates and then investigated changes in electrical characteristics. Atomic force microscopy (AFM) was performed to analyze the surface morphology of the a-IGZO films according to the oxygen gas rate. Furthermore, X-ray photoelectron spectroscopy (XPS) analysis was performed to confirm changes in oxygen vacancies of a-IGZO films. The optimized a-IGZO TFT has enhanced electrical characteristics such as carrier mobility (μ) of 12.3 cm2/V·s, on/off ratio of 1.25 × 1010 A/A, subthreshold swing (S.S.) of 3.7 V/dec, and turn-on voltage (Vto) of −3 V. As a result, the optimized a-IGZO TFT has improved electrical characteristics with oxygen vacancies having the highest conductivity.
30 April 2015 in JOURNAL OF SEMICONDUCTOR TECHNOLOGY AND SCIENCE
In this paper, ZnO films were prepared by atomic layer deposition (ALD) and CdS films were deposited using chemical bath deposition (CBD) to form ZnO/CdS heterojunction. More accurate mapping of band
We investigate the gate bias-stress-induced instabilities of p-type copper oxide (Cu 2 O) thin-film transistors (TFTs). Transfer curves measured before and after the application of constant gate bias stress under air and vacuum environments show that the partial pressure of the oxygen in the environment does not much affect the transfer characteristics and bias-stress-induced instabilities of the Cu 2 O TFTs. During the negative gate bias stresses, the transfer curves shift to the negative direction without a significant variation of the shape, which is attributed to the hole trapping in the interface or bulk dielectric layers with a negligible creation of additional interface trap states. During the positive gate bias stresses, a threshold voltage hardly moves to the positive direction because of the lack of free electron inside the p-type Cu 2 O, but a notable degradation of the subthreshold slope is observed. From the recovery characteristics, the generated traps during the positive gate bias stress are estimated to be metastable ones in p-type Cu 2 O TFTs.
Bottom-gate thin-film transistors (TFTs) with n-type amorphous indium-gallium-zinc oxide (a-IGZO) active channels and indium-tin oxide (ITO) source/drain electrodes were fabricated. Then, an ultraviolet (UV) nanosecond pulsed laser with a wavelength of 355 nm was scanned to locally anneal the active channel at various laser powers. After laser annealing, negative shifts in the threshold voltages and enhanced on-currents were observed at laser powers ranging from 54 to 120 mW. The energy band gap and work function of a-IGZO extracted from the transmittance and ultraviolet photoelectron spectroscopy (UPS) measurement data confirm that different energy band structures for the ITO electrode/a-IGZO channel were established depending on the laser annealing conditions. Based on these observations, the electron injection mechanism from ITO electrodes to a-IGZO channels was analyzed. The results show that the selective laser annealing process can improve the electrical performance of the a-IGZO TFTs without any thermal damage to the substrate.