GeAs is a layered material of the IV–V groups that is attracting growing attention for possible applications in electronic and optoelectronic devices. In this study, exfoliated multilayer GeAs nanoflakes are structurally characterized and used as the channel of back-gate field-effect transistors. It is shown that their gate-modulated p-type conduction is decreased by exposure to light or electron beam. Moreover, the observation of a field emission (FE) current demonstrates the suitability of GeAs nanoflakes as cold cathodes for electron emission and opens up new perspective applications of two-dimensional GeAs in vacuum electronics. FE occurs with a turn-on field of ∼80 and attains a current density higher than 10 , following the general Fowler–Nordheim model with high reproducibility.
We propose a simple method to fabricate a photodetector based on the carbon nanotube/silicon nitride/silicon (CNT/Si3N4/Si) heterojunction. The device is obtained by depositing a freestanding single-wall carbon nanotube (SWCNT) film on a silicon substrate using a dry transfer technique. The SWCNT/Si3N4/Si heterojunction is formed without the thermal stress of chemical vapor deposition used for the growth of CNTs in other approaches. The CNT film works as a transparent charge collecting electrode and guarantees a uniform photocurrent across the sensitive area of the device. The obtained photodetector shows a great photocurrent that increases linearly with the incident light intensity and grows with the increasing wavelength in the visible range. The external quantum efficiency is independent of the light intensity and increases with the wavelength, reaching 65% at 640 nm.
Photodetectors based on vertical multi-walled carbon nanotube (MWCNT) film-Si heterojunctions are realized by growing MWCNTs on n-type Si substrates with a top surface covered by Si3N4 layers. Spatially resolved photocurrent measurements reveal that higher photo detection is achieved in regions with thinner MWCNT film, where nearly 100% external quantum efficiency is achieved. Hence, we propose a simple method based on the use of scotch tape with which to tune the thickness and density of as-grown MWCNT film and enhance device photo-response.
Clean water is vital for healthy ecosystems, for human life and, in a broader sense, it is directly linked to our socio-economic development. Nevertheless, climate change, pollution and increasing world population will likely make clean water scarcer in the near future. Consequently, it becomes imperative to develop novel materials and more efficient ways of treating waste and contaminated water. Carbon nanotube (CNT) sponges, for example, are excellent in removing oleophilic contaminants; however, due to their super-hydrophobic nature, they are not as efficient when it comes to absorbing water-soluble substances. Here, by means of a scalable method consisting of simply treating CNT sponges at mild temperatures in air, we attach oxygen-containing functional groups to the CNT surface. The functionalized sponge becomes hydrophilic while preserving its micro- and macro-structure and can therefore be used to successfully remove toxic contaminants, such as pesticides, that are dissolved in water. This discovery expands the current range of applications of CNT sponges to those fields in which a hydrophilic character of the sponge is more suitable.
13 May 2022 in Physical Chemistry Chemical Physics
In this work devices based on a MWCNTs-Si heterojunction were realized growing MWCNTs, by chemical vapor deposition, on an n-type Si substrate with the top and bottom surfaces covered by 140 nm thick Si3N4 layers. Two metal contacts, realized on the top and back of the Si surface, were used to perform I-V measurements of the vertical heterostructure. The photocurrent behavior, obtained by light illumination, was studied as a function of the thickness of the MWCNTs layer. A planar quantum efficiency map of the device was obtained by I-V measure when the active area of the device was rastered by a 1 mm diameter light spot. The thickness reduction of the MWCNTs was realized by adhesive tape. We found that the photocurrent intensity increased when the density of the MWCNTs layer was decreased. To check the substrate coverage by the MWCNTs, scanning electron microscope images were taken.