In this work, we present power and quality measurements of four transmissions using different emission technologies in an indoor environment, specifically a corridor, at the frequency of 868 MHz under two non-line-of-sight (NLOS) conditions. A narrowband (NB) continuous wave (CW) signal has been transmitted, and its received power has been measured with a spectrum analyzer, LoRa and Zigbee signals have also been transmitted, and their Received Signal Strength Indicator (RSSI) and bit error rate (BER) have been measured using the transceivers themselves; finally, a 20 MHz bandwidth 5G QPSK signal has also been transmitted and their quality parameters, such as SS-RSRP, SS-RSRQ and SS-RINR, have been measured using a SA. Thereafter, two fitting models, the Close-in (CI) model and the Floating-Intercept (FI) model, were used to analyze the path loss. The results show that slopes below 2 for the NLOS-1 zone and above 3 for the NLOS-2 zone have been found. Moreover, the CI and FI model behave very similarly in the NLOS-1 zone, while in the NLOS-2 zone, the CI model has poor accuracy in contrast to the FI model, which achieves the best accuracy in both NLOS situations. From these models, the power predicted with the FI model has been correlated with the measured BER value, and power margins have been established for which LoRa and Zigbee would each reach a BER greater than 5%; likewise, −18 dB has been established for the SS-RSRQ of 5G transmission.
The metabolic disease Type 1 Diabetes Mellitus (DM1) is caused by a reduction in the production of pancreatic insulin, which causes chronic hyperglycemia. Patients with DM1 are required to perform multiple blood glucose measurements on a daily basis to monitor their blood glucose dynamics through the use of capillary glucometers. In more recent times, technological developments have led to the development of cutting-edge biosensors and Continuous Glucose Monitoring (CGM) systems that can monitor patients’ blood glucose levels on a real-time basis. This offers medical providers access to glucose oscillations modeling interventions that can enhance DM1 treatment and management approaches through the use of novel disruptive technologies, such as Cloud Computing (CC), big data, Intelligent Data Analysis (IDA) and the Internet of Things (IoT). This work applies some advanced modeling techniques to a complete data set of glycemia-related biomedical features—obtained through an extensive, passive monitoring campaign undertaken with 25 DM1 patients under real-world conditions—in order to model glucose level dynamics through the proper identification of patterns. Hereby, four methods, which are run through CC due to the high volume of data collected, are applied and compared within an IoT context. The results show that Bayesian Regularized Neural Networks (BRNN) offer the best performance (0.83 R2) with a reduced Root Median Squared Error (RMSE) of 14.03 mg/dL.
The fading and correlation characteristics of virtual, yet realistic, line-of-sight (LOS) 4 × 2500 millimetric (mmW) massive MIMO channels are investigated at 94 GHz in an indoor office environment for three different Tx-Rx distance scenarios. The capability of the mmW massive MIMO channel to spatially decorrelate the users is evaluated with the computation of the channel correlation and other channel metrics, such as power-to-interference ratio and condition number. In particular, the correlation between channel vectors for a given user and its influence on receiving correlation is discussed. The results clearly demonstrate the capability of mmW massive MIMO systems to reach orthogonal Tx-Rx streams even for a small 7 × 7 antenna array subset with correlation between users <;0.2. Moreover, strong phase variations at Tx side at this frequency range are highlighted through channel phase correlation studies and were shown to contribute to the decorrelation at Rx side between close users, paving the way for further massive MIMO system enhancements.
While several mm‐wave and sub‐THz frequency bands are being proposed for next generation wireless systems to meet the increasing traffic demand, the electromagnetic properties of many common use materials at those frequencies still need to be determined. The evaluation of such properties is important for the design and deployment of future wireless networks. Recently, a simple method based on Fabry‐Pérot resonance has been proposed to address the need of easy material characterization at mm‐wave frequencies. In this study, the method has been improved and applied to the characterization of several materials at mm‐wave and sub‐THz frequencies, in order to assess its reliability, usability, and accuracy in practical cases. The method is shown to achieve a good accuracy level despite the very simple measurement setup and the great flexibility. However, some application limitations are highlighted and discussed in the paper. A method for electromagnetic material characterization based on an improved Fabry‐Pérot technique is presented.
8 February 2024 in IEEE Antennas and Wireless Propagation Letters
This letter presents wideband measurements and simulations ranging from 2 to 28 GHz conducted in a parking lot, with and without cars. The measurements have been carried out considering a transmitter placed in an elevated position, with an omnidirectional antenna. The receivers have been distributed in the parking area also using omnidirectional antennas. Furthermore, the OPAL open-source ray launching tool has been used to simulate the different propagation mechanisms. The CI, FI, CIF and ABC propagation models have been considered, showing a consistent behavior of the propagation path loss exponent with the frequency. The results suggest that the presence of cars has a minimal impact on the path loss along all frequencies.
18 December 2020 in IEEE Transactions on Antennas and Propagation
A hybrid uniform theory of diffraction-physical optics (UTD-PO) formulation for the analysis of the multiple-diffraction (MD) that takes place over rectangular-shaped obstacles (plateaus) when the latter are illuminated from a low source is presented. The solution, which is based on Babinet's principle, has been validated with measurements taken at 60 GHz on a scaled model of the environment under study and with additional measurements performed by other authors. Moreover, the proposed approach has been compared with the wide-angle Fourier split-step parabolic equation method, with the UTD-PO formulation showing better accuracy against the experimental data, especially when the distance between the transmitter and the receiver is increased. Furthermore, the main advantage of the proposed solution is that due to recursion, the calculations imply only single diffractions, thereby avoiding the need of higher order diffraction terms in the diffraction coefficients. The results and findings of this communication are particularly applicable to the planning of microcellular mobile communication systems when the transmitting antenna is located below the height of the surrounding buildings.