Mohd Gulfam Alam

Dr. Mohd Gulfam Alam

orcid

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 December 2020 in Polymers
Verified
Journal Article
Open access
PDF file
Javed IqbalJaved Iqbal
Javed Iqbal
MAMohammad Omaish Ansari
Mohammad Omaish Ansari
NANuman Arshid
Numan Arshid
WSWageh Swelm
Wageh Swelm
AAAhmed Al-Ghamdi
Ahmed Al-Ghamdi
ARAltaf Hussain Rajpar
Altaf Hussain Rajpar
In this study, ternary composites of polyaniline (PANI) with manganese dioxide (MnO2) nanorods and carbon nanotubes (CNTs) were prepared by employing a hydrothermal methodology and in-situ oxidative polymerization of aniline. The morphological analysis by scanning electron microscopy showed that the MnO2 possessed nanorod like structures in its pristine form, while in the ternary PANI@CNT/MnO2 composite, coating of PANI over CNT/MnO2, rods/tubes were evidently seen. The structural analysis by X-ray diffraction and X-ray photoelectron spectroscopy showed peaks corresponding to MnO2, PANI and CNT, which suggested efficacy of the synthesis methodology. The electrochemical performance in contrast to individual components revealed the enhanced performance of PANI@CNT/MnO2 composite due to the synergistic/additional effect of PANI, CNT and MnO2 compared to pure MnO2, PANI and PANI@CNT. The PANI@CNT/MnO2 ternary composite exhibited an excellent specific capacity of 143.26 C g−1 at a scan rate of 3 mV s−1. The cyclic stability of the supercapattery (PANI@CNT/MnO2/activated carbon)—consisting of a battery type electrode—demonstrated a gradual increase in specific capacity with continuous charge–discharge over ~1000 cycles and showed a cyclic stability of 119% compared to its initial value after 3500 cycles.

1 July 2015 in Journal of Saudi Chemical Society
Verified
Journal Article
Open access
SHShamsuzzaman
Shamsuzzaman
TSTabassum Siddiqui
Tabassum Siddiqui
MAMohd Gulfam Alam
Mohd Gulfam Alam
ADAyaz Mahmood Dar
Ayaz Mahmood Dar
In the present study steroidal derivatives, 3β-[5′-mercapto-1′,3′,4′-oxadiazole-2-yl]methoxy cholest-5-ene 2, 3β-[2′,5′-dimethylpyrrole-1-yl]aminocarbonylmethoxycholest-5-ene 3 and 3β-[3′,5′-dimethyl pyrazole-1-yl]carbonylmethoxycholest-5-ene 4 have been synthesized from cholest-5-en-3β-O-acetyl hydrazide 1 using CS2/KOH, acetonyl acetone and acetyl acetone, respectively as reagents and are characterized by IR, 1H NMR,13C NMR, MS and elemental analysis. Compounds 2–4 were also evaluated for anticancer activity against human leukemia cell line (HL-60) by MTT assay and compound 4 displayed the promising behavior by showing better anticancer activity

1 May 2015 in Journal of Organometallic Chemistry
Verified
Journal Article
Closed access
GNGeorge S. Nyamato
George S. Nyamato
MAMohd Gulfam Alam
Mohd Gulfam Alam
SOStephen O. Ojwach
Stephen O. Ojwach
MAMatthew P. Akerman
Matthew P. Akerman

10 October 2022 in Biosensors
Verified
Journal Article
Open access
PDF file
Faheem AhmedFaheem Ahmed
Faheem Ahmed
Prof. Thangavelu KokulnathanProf. Thangavelu Kokulnathan
Prof. Thangavelu Kokulnathan
AUAhmad Umar
Ahmad Umar
Sheikh AkbarSheikh Akbar
Sheikh Akbar
Shalendra KumarShalendra Kumar
Shalendra Kumar
Adil AlshoaibiAdil Alshoaibi
Adil Alshoaibi
Herein, we present an electrocatalyst constructed by zinc oxide hexagonal prisms/phosphorus-doped carbon nitride wrinkles (ZnO HPs/P-CN) prepared via a facile sonochemical method towards the detection of nitrofurantoin (NF). The ZnO HPs/P-CN-sensing platform showed amplified response and low-peak potential compared with other electrodes. The exceptional electrochemical performance could be credited to ideal architecture, rapid electron/charge transfer, good conductivity, and abundant active sites in the ZnO HPs/P-CN composite. Resulting from these merits, the ZnO HPs/P-CN-modified electrode delivered rapid response (2 s), a low detection limit (2 nM), good linear range (0.01–111 µM), high sensitivity (4.62 µA µM−1 cm2), better selectivity, decent stability (±97.6%), and reproducibility towards electrochemical detection of NF. We further demonstrated the feasibility of the proposed ZnO HPs/P-CN sensor for detecting NF in samples of water and human urine. All the above features make our proposed ZnO HPs/P-CN sensor a most promising probe for detecting NF in natural samples.

7 July 2025 in Inorganics
Verified
Journal Article
Open access
PDF file
TAThamer Alraddadi
Thamer Alraddadi
RARawan AL-Faze
Rawan AL-Faze
SPSaheed Popoola
Saheed Popoola
MAMohd Gulfam Alam
Mohd Gulfam Alam
SRSouad Rakass
Souad Rakass
FKFethi Kooli
Fethi Kooli
The treatment with an alkali (sodium hydroxide) solution of acid-activated montmorillonite clay minerals resulted in a reduction in specific surface area. However, a significant enhancement in the removal of basic blue-41 dye solution was achieved compared to acid-activated samples only (first step of activation) and to the raw montmorillonite clay. The obtained products were characterized using different techniques. The results indicated that the acid-activated montmorillonites exhibited different physicochemical properties than the starting raw montmorillonite, with a reduction in the cation exchange capacity and improvements in the specific surface area (from 5 m2/g to 274 m2/g) and total pore volume (from 0.031 cm3/g to 0.450 cm3/g) due to the formation of the amorphous silica phase. However, the treatment with NaOH solution was accompanied by significant reductions in the specific surface area (from 274 m2/g to 18 m2/g) and total pore volume (from 0.450 cm3/g to 0.02 cm3/g) due to the dissolution of the formed amorphous silica phase, as confirmed through 29Si MAS NMR and FTIR techniques. In addition, the SiO2/Al2O3 molar ratios were close to those of the starting montmorillonite clay. The removal of the cationic basic blue-41 was optimized under different conditions, such as different initial concentrations, adsorbent doses, and pHs of the dye solution. The maximum removal capacities of acid-activated clays were in the range of 45 mg/g to 80 mg/g and decreased with the extent of the acid activation process. However, the capacities were enhanced after NaOH treatment and reached values in the range of 80 to 120 mg/g. Enhancing the surface area had less of an impact on the materials’ removal ability. The obtained materials performed well in seven adsorption–regeneration cycles, showing a 70% reduction in removal effectiveness.

YRYasser M. Riyad
Yasser M. Riyad
TETaha M. Elmorsi
Taha M. Elmorsi
MAMohd Gulfam Alam
Mohd Gulfam Alam
BABernd Abel
Bernd Abel
In this study, a valuable adsorbent was functionalized using commercial ZnO and a mango seed extract (MS-Ext) as a green approach for synthesis. Fourier-transform infrared spectroscopy, transmission electron microscopy, scanning electron microscopy, and energy-dispersive X-ray analysis spectraconfirmed the presence of bioactive phenolic compounds and Cu2+ ions on the surface of ZnO. Functionalized Cu-doped ZnO/MS-Ext exhibits high efficacy in acidic, neutral, and alkaline medium, as indicated by 98.3% and 93.7% removal of methylene blue (MB) and crystal violet (CV) dyes, respectively. Cu-doped ZnO/MS-Ext has a zeta potential significantly lower than pristine zinc oxide (p-ZnO), which results in enhanced adsorption of cationic MB and CV dyes. In binary systems, both MB and CV were significantly removed in acidic and alkaline media, with 92% and 87% being removed for CV in acidic and alkaline media, respectively. In contrast, the removal efficiency of methyl orange dye (MO) was 16.4%, 6.6% and 11.2% for p-ZnO, ZnO/Ext and Cu-doped ZnO/Ext, respectively. In general, the adsorption kinetics of MB on Cu-doped ZnO/MS-Ext follow this order: linear pseudo-second-order (PSO) > nonlinear pseudo-second-order (PSO) > nonlinear Elovich model > linear Elovich model. The Langmuir isotherm represents the adsorption process and indicates that MB, CV, and MO are chemisorbed onto the surface of the adsorbent at localized active centers of the MS-extract functional groups. In a binary system consisting of MB and CV, the maximum adsorption capacity (qm) was 72.49 mg/g and 46.61 mg/g, respectively. The adsorption mechanism is governed by electrostatic attraction and repulsion, coordination bonds, and π–π interactions between cationic and anionic dyes upon Cu-doped ZnO/Ext surfaces.