Currently, the electrification of transport networks is one of the initiatives being performed to reduce greenhouse gas emissions. Despite the rapid advancement of power electronic systems for electrified transportation systems, their integration into the AC power grid generates a variety of quality issues in the electrical distribution system. Among the possible solutions to this challenge is the inclusion of continuous storage systems, which can be located either onboard or offboard. The rapid development of energy storage devices has enabled the creation of numerous solutions that are leading to ever-increasing energy consumption efficiency, particularly when two or more of these storage systems are linked in a cascade and a hybrid mode. The various energy storage systems that can be integrated into vehicle charging systems (cars, buses, and trains) are investigated in this study, as are their electrical models and the various hybrid storage systems that are available.

Environmental issues and the global need to extend sustainable access to electricity have fostered a huge amount of research in distributed generation by renewables. The challenges posed by the widespread deployment of distributed generation by renewables, such as intermittent power generation, low inertia, the need for energy storage, etc., call for the development of smart grids serving specific local areas or buildings, referred to as microgrids and nanogrids, respectively. This has led in the last decades to the proposal and actual implementation of a wide variety of system architectures and solutions, and along with that the issue of the power converters needed for interfacing the AC grid with DC micro- or nanogrids, and for DC regulation within the latter. This work offers an overview of the state of the art of research and application of nanogrid architectures, control strategies, and power converter topologies.

This paper proposes a novel feedforward control scheme to achieve a very smooth transition from Constant Current (CC) to Constant Voltage (CV) charging modes, the commonly used method for electric vehicle charging applications. Furthermore, a three-loop model-independent Linear Active Disturbance Rejection Control (LADRC)-based system is proposed, replacing the traditional two-loop Proportional-Integral (PI) control system. The extra loop performs a decoupled dq vector control of the inductor current, which is typically not used in single-phase Dual Active Bridge (DAB) systems. This additional loop not only facilitates the optimal determination of both internal and external phase shift angles of a Dual-Phase Shift (DPS) modulator but also lowers the peak input current of the converter, allowing for lower-rated switches. Numerical simulations using MATLAB/Simulink demonstrate the robustness of the proposed control strategy against both input voltage disturbances and load disturbances during the transition from CC to CV charging modes. Hence, the dynamic performance of the charging system is significantly improved with minimal controller effort.

DC nanogrid architectures with Photovoltaic (PV) modules are expected to grow significantly in the next decades. Therefore, the integration of multi-port power converters and high-frequency isolation links are of increasing interest. The Triple Active Bridge (TAB) topology shows interesting advantages in terms of isolation, Zero Voltage Switching (ZVS) over wide load and input voltage ranges and high frequency operation capability. Thus, controlling PV modules is not an easy task due to the complexity and control stability of the system. In fact, the TAB power transfer function has many degrees of freedom, and the relationship between any of two ports is always dependent on the third one. In this paper we analyze the interfacing of photovoltaic arrays to the TAB with different solar conditions. A simple but effective control solution is proposed, which can be implemented through general purpose microcontrollers. The TAB is applied to an islanded DC nanogrid, which can be useful and readily implemented in locations where the utility grid is not available or reliable, and applications where isolation is required as for example More Electric Aircraft (MEA). Different conditions have been simulated and the control loops are proved for a reliable bus voltage control on the load side and a good maximum power point tracking (MPPT).