High thermal stability of planar Hall resistance (PHR) signal in magnetic sensors, configured as a cross-junction and as a Wheatstone bridge, has been demonstrated. A thermal drift of PHR signal, being proportional to PHR offset at zero field, is few orders of magnitude less than the thermal drift of anisotropic magnetoresistance signal. The thermal drift of PHR originates from two independent components, base line drift and signal amplitude drift. The temperature coefficient of base line drift, normalized by zero field offset, is similar with the temperature coefficient of resistance. This makes possible to characterize a drift at any temperature range, by a single measurement of PHR under ambient conditions. A signal amplitude drift is shown to be dependent on sensor's geometry, and becomes higher with a reduction of the width of a current path. The temperature coefficients of base line drift and signal amplitude drift are of opposite signs. A possibility of mutual compensation of signal amplitude drift and base line drift by a slight misbalancing of a bridge-type sensor has been demonstrated.
In this paper, we propose a high accuracy open-type current sensor with a differential Planar Hall Resistive (PHR) sensor. Conventional open-type current sensors with magnetic sensors are usually vulnerable to interference from an external magnetic field. To reduce the effect of an unintended magnetic field, the proposed design uses a differential structure with PHR. The differential structure provides robust performance to unwanted magnetic flux and increased magnetic sensitivity. In addition, instead of conventional Hall sensors with a magnetic concentrator, a newly developed PHR with high sensitivity is employed to sense horizontal magnetic fields. The PHR sensor and read-out integrated circuit (IC) are integrated through a post-Complementary metal-oxide-semiconductor (CMOS) process using multi-chip packaging. The current sensor is designed to measure a 1 A current level. The measured performance of the designed current sensor has a 16 kHz bandwidth and a current nonlinearity of under ±0.5%.
Advanced microelectromechanical system (MEMS) magnetic field sensor applications demand ultra-high detectivity down to the low magnetic fields. To enhance the detection limit of the magnetic sensor, a resistance compensator integrated self-balanced bridge type sensor was devised for low-frequency noise reduction in the frequency range of 0.5 Hz to 200 Hz. The self-balanced bridge sensor was a NiFe (10 nm)/IrMn (10 nm) bilayer structure in the framework of planar Hall magnetoresistance (PHMR) technology. The proposed resistance compensator integrated with a self-bridge sensor architecture presented a compact and cheaper alternative to marketable MEMS MR sensors, adjusting the offset voltage compensation at the wafer level, and led to substantial improvement in the sensor noise level. Moreover, the sensor noise components of electronic and magnetic origin were identified by measuring the sensor noise spectral density as a function of temperature and operating power. The lowest achievable noise in this device architecture was estimated at ~3.34 at 100 Hz.
1 August 2020 in SID Symposium Digest of Technical Papers