Chemical amination of the enzyme was demonstrated to favor immobilization onto polydopamine (PDA)-coated magnetic nanoparticles (MNPs) for the first time, to the best of the author’s knowledge. MNPs prepared via hydrothermal synthesis were coated with PDA for the immobilization of naringinase. X-ray diffraction, transmission electron microscopy, X-ray photoelectron spectroscopy, and Fourier-transform infrared spectroscopy showed that the MNPs were composed mainly of Fe3O4 with an average size of 38.9 nm, and coated with a 15.1 nm PDA layer. Although the specific activities of α-L-rhamnosidase (RAM) and β-D-glucosidase (GLU) of free naringinase decreased with amination, the immobilization yields of the aminated enzyme increased by more than 40% for RAM and more than 10-fold for GLU. The immobilization improved the enzyme’s thermal stability (at 50 °C), reaching a half-life of 40.7 and 23.1 h for RAM and GLU activities, respectively. The biocatalyst was successfully used for the debittering of grapefruit juice, detecting a reduction in naringin of 56% after 24 h. These results demonstrate that the enzyme amination is an effective strategy to enhance the immobilization on a PDA coating and could be applied to other enzymes in order to obtain an easily recoverable biocatalyst using a simple immobilization methodology.
Four titanium alloys (Ti-Ta, Ti-Ta-Sn, Ti-Ta-Mn, and Ti-Nb-Sn) were synthesized by mechanical alloying (MA) in a planetary mill in different times between 2 h and 100 h. The microstructure characterization was made by X-ray diffraction (XRD), in which the Rietveld method was applied to analyze the diffraction patterns. The study demonstrated that after short milling times between 2 h and 30 h, the fraction of hexagonal close-packed (hcp) phase decreases; at the same time, the formation of body-centered cubic (bcc) and face-centered cubic (fcc) Ti phases are promoted. Additionally, after 30 h of MA, the full transformation of hcp-Ti was observed, and the bcc-Ti to fcc-Ti phase transformation took place until 50 h. The results suggest that the addition of Ta and Sn promotes the fcc-Ti phase formation, obtaining 100% of this phase at 50 h onwards, whereas Nb and Mn show the opposite effect.
10 February 2023 in Materials Science and Engineering: A
Highly porous titanium foams are great candidates for replacing bone structures with a low elastic modulus owing to their ability to avoid the stress shielding effect. However, the production of highly porous foams (>70 vol.%) with well-distributed, stable, and predictable porous architectures using powder compaction and space holders is challenging. In this study, pure titanium powder and mechanically alloyed Ti-13Ta-6Sn were mixed with 50, 70, and 80 vol.% KCl powders as a space holder, cold-compacted, and sintered in a plasma-assisted sintering reactor to produce highly porous foams. The space holder was completely removed using heat and plasma species collisions prior to sintering. A Ti-13Ta-6Sn alloy powder with α, β, and metastable FCC-γ phases was synthesized. The characteristics of the alloyed powder, mixing step, and the resulting sintered samples were compared to those of CP-Ti. After sintering, the alloy exhibited α and β phases and a reduced elastic modulus. Foams with an elastic modulus in the range of the cortical and trabecular bones were obtained. The results showed the effects of the space holder volume fractions on the volume fraction, size, distribution, interconnectivity, and shape of the pores. The Ti-13Ta-6Sn foams exhibited a uniform open-celled porous architecture, lower elastic modulus, higher yield strength, and higher passivation resistance than CP-Ti. Ti-13Ta-6Sn exhibited a nontoxic effect for the mouse fibroblast cell line.