The electrification of aircrafts is a recent trend in aviation and with it the use of batteries as energy carriers at high altitudes. These batteries can be exposed to low pressures and it is crucial to understand the influence of low pressures on the battery behavior. In this study, commercially available lithium ion batteries were examined experimentally at low pressures down to 25 kPa. Discharge curves and impedance measurements were performed at 23 °C for each pressure level. Cylindrical Lithium Nickel-Cobalt-Aluminum Oxide (NCA) and Iron-Phosphate (LFP) cells did not show any pressure influence, while Lithium Nickel-Manganese-Cobalt Oxide (NMC) pouch cells showed some performance variation with reduced pressure. The ohmic resistance increased by around 0.1 mΩ per 25 kPa and at 25 kPa the charge transfer impedance increased for low SOCs. The results show that no strong change in performance is to be expected for low pressure applications in airplanes, however further research is needed with respect to long term effects, thermal management and safety.
The climate impact of aviation can be reduced using powertrains based on hydrogen fuel cells and batteries. Combining both technologies in a direct-hybrid without a DC/DC converter is a promising approach for light-weight systems. Depending on the power demand, both the fuel cell and battery are used to provide power or only the fuel cell is connected to the powertrain. The system voltage in a direct-hybrid is determined by the fuel cell and battery, but the performance of fuel cells is affected by low-ambient pressure at high altitudes and the battery voltage is affected by state of charge and discharge rate. Taking this into account, the presented work demonstrates how a direct-hybrid system must be designed based on a scaled mission profile of a 40-seater aircraft. The fuel cell and battery are configured and sized according to the power demand in different flight phases while considering voltage limits given by the powertrain. The energy requirement from the fuel cell and the battery is calculated for a flight based on a realistic mission profile and different battery and fuel cell configurations are evaluated. By optimizing the battery and fuel cell size, the energy required from the battery was reduced by 57% and the total weight of the fuel cell and battery was reduced by 11%.
For the optimal high-efficiency operation of a PEM fuel cell system, the temperature, pressure, humidity and mass flow of the supplied air must be tuned to the fuel cell stack requirements. Especially for aircraft applications, this requires a thorough understanding of the fuel cell air supply system behavior and how it changes when the ambient pressure is below 1 bar(a) during flight. This work investigates the influence of low inlet pressures and varying inlet temperatures on the compression map of an electrical turbo charger. This is especially relevant in airborne fuel cell application and not much literature can be found on that topic. Compressor limits are evaluated experimentally and theoretically. The theory of mass flow and speed correction is compared to experimental findings and found to be applicable for the surge and speed limit of the investigated turbo chargers as long as the compressor map is not limited by the power of the electric motor and inverter. Based on this, a prediction of the compressor map for altitudes up to 10,000 m is made with the help of a developed software tool.
A commercially available 100 kW PEM fuel cell system designed for efficient operation on ground-level was tested at low ambient pressures between 750 mbar and 940 mbar in a low-pressure chamber. The current–voltage characteristics at 940 mbar and 900 mbar showed only small differences, while the system performed worse at lower ambient pressures. To enable operation at these low pressures, an additional current-limiting strategy had to be implemented, as it was found that the compressor could not deliver sufficient mass flow at ambient pressures below 867 mbar to reach the maximum current allowed by the system (420 A). The results show that the fuel cell system, which was designed for ground-level applications, can be operated at lower pressures if the proposed current-limiting strategy is implemented, although at the cost of a lower maximum current output at low ambient pressures. Based on the results, suggestions for further hardware measures to optimise the system for flight conditions are made.