The climate impact of aviation can be reduced using powertrains based on hydrogen fuel cells and batteries. Combining both technologies in a direct-hybrid without a DC/DC converter is a promising approach for light-weight systems. Depending on the power demand, both the fuel cell and battery are used to provide power or only the fuel cell is connected to the powertrain. The system voltage in a direct-hybrid is determined by the fuel cell and battery, but the performance of fuel cells is affected by low-ambient pressure at high altitudes and the battery voltage is affected by state of charge and discharge rate. Taking this into account, the presented work demonstrates how a direct-hybrid system must be designed based on a scaled mission profile of a 40-seater aircraft. The fuel cell and battery are configured and sized according to the power demand in different flight phases while considering voltage limits given by the powertrain. The energy requirement from the fuel cell and the battery is calculated for a flight based on a realistic mission profile and different battery and fuel cell configurations are evaluated. By optimizing the battery and fuel cell size, the energy required from the battery was reduced by 57% and the total weight of the fuel cell and battery was reduced by 11%.
A commercially available 100 kW PEM fuel cell system designed for efficient operation on ground-level was tested at low ambient pressures between 750 mbar and 940 mbar in a low-pressure chamber. The current–voltage characteristics at 940 mbar and 900 mbar showed only small differences, while the system performed worse at lower ambient pressures. To enable operation at these low pressures, an additional current-limiting strategy had to be implemented, as it was found that the compressor could not deliver sufficient mass flow at ambient pressures below 867 mbar to reach the maximum current allowed by the system (420 A). The results show that the fuel cell system, which was designed for ground-level applications, can be operated at lower pressures if the proposed current-limiting strategy is implemented, although at the cost of a lower maximum current output at low ambient pressures. Based on the results, suggestions for further hardware measures to optimise the system for flight conditions are made.
Hybrid electric aircraft with a powertrain based on fuel cells and batteries can reduce climate-active emissions in aviation. In a direct hybrid powertrain, the fuel cell and the battery are connected in parallel, without a DC/DC converter balancing their voltage levels. Switches make it possible to select different operational modes (fuel cell only, hybrid or battery charging) depending on the power demand during different flight phases. To exploit the high specific energy of hydrogen, the system should change from Hybrid Mode during take-off to Fuel Cell Mode in cruise. During descent, the battery can be charged if Charging Mode is selected. To avoid voltage and current peaks and consequent damage to components when switching between modes, certain conditions must be fulfilled. Those switching conditions were defined, and switching procedures for changing from one mode to the other during flight were developed and tested in a lab system. In a direct hybrid, the system voltage depends on the required power. When switching from Hybrid Mode to Fuel Cell Mode, a short reduction in power of 65% is necessary for the examined system to meet the switching requirements. It is also shown how this power loss can be reduced to 25% by distributed propulsion with a second powertrain or even eliminated by a change in the hybrid ratio.