In this study, a commercial IrO2/TiO2 catalyst (75 wt% Ir, named “Benchmark”) for the oxygen evolution reaction (OER) is compared to a newly developed IrO(OH)x/TiO2 catalyst (45 wt% Ir, named “P2X”). Due to its lower Ir packing density and higher OER activity vs the Benchmark catalyst (440 vs 12 A gIr−1 at 1.43 ViR-free), the P2X catalyst shows an improved PEM (proton exchange membrane) water electrolyzer performance at ≈9 times reduced Ir loading, however, only if a platinum-coated porous transport layer (PTL) at the anode is used. While the performance of membrane electrode assemblies (MEAs) with the Benchmark catalyst is unaffected when using an untreated titanium PTL, MEAs with the P2X catalyst perform poorly, which can be attributed to a contact resistance at the anode/PTL interface due to the low electrical conductivity of the P2X catalyst (0.7 S cm−1) vs the Benchmark catalyst (416 S cm−1) and the passivation of the Ti-PTL. A heat treatment procedure is used to transform the amorphous IrO(OH)x of the P2X catalyst into crystalline IrOx and, hence, increases its electrical conductivity. The optimum temperature for heat treatment to maximize electrical conductivity, OER activity and MEA performance will be evaluated.
9 January 2020 in Journal of the Electrochemical Society
In this study, on-line mass spectrometry is used to determine hydrogen permeation during proton exchange membrane water electrolyzer (PEM-WE) operation for a wide range of current densities (0–6 A cm−2) and operating pressures (1–30 bar, differential pressure). H2 permeation measurements with a permeation cell setup, i.e., without applying a current, show a linear correlation between permeation rate and H2 partial pressure, indicating diffusion as the main crossover mechanism. Measurements with full membrane electrode assemblies (MEAs) during PEM-WE operation reveal a significant increase of the gas permeation rate at high current densities, by up to ≈20-fold at 1 bar H2 and up to ≈1.2-fold at 30 bar H2 (Nafion® 212 or Nafion® 117 membrane; Ir-black (anode) and Pt/C (cathode)). Recently, H2 super-saturation of the ionomer phase in the cathode catalyst layer was shown to be the reason for this increase, and we discuss the impact of this effect for different electrode compositions and operating conditions. Finally, the determined H2 permeation rates and electrolyzer performance are used to discuss the overall PEM-WE efficiency for different membrane thicknesses and it is shown that the formation of an explosive gas mixture in the anode at low current densities requires additional mitigation strategies.
For the optimal high-efficiency operation of a PEM fuel cell system, the temperature, pressure, humidity and mass flow of the supplied air must be tuned to the fuel cell stack requirements. Especially for aircraft applications, this requires a thorough understanding of the fuel cell air supply system behavior and how it changes when the ambient pressure is below 1 bar(a) during flight. This work investigates the influence of low inlet pressures and varying inlet temperatures on the compression map of an electrical turbo charger. This is especially relevant in airborne fuel cell application and not much literature can be found on that topic. Compressor limits are evaluated experimentally and theoretically. The theory of mass flow and speed correction is compared to experimental findings and found to be applicable for the surge and speed limit of the investigated turbo chargers as long as the compressor map is not limited by the power of the electric motor and inverter. Based on this, a prediction of the compressor map for altitudes up to 10,000 m is made with the help of a developed software tool.