The production of biofuels has had a great impact on climate change and the reduction of the use of fossil fuels. There are different technologies used for the separation and production of biofuels, which allow having compounds such as ethanol, methane, oxygen, and hydrogen, one of these promising technologies is the Pressure Swing Adsorption process (PSA). The objectives of this article focus on the production and purification of compounds that achieve purities of 99.5% bioethanol, 94.85% biohydrogen, 95.00% medical oxygen, and 99.99% biomethane through the PSA process; also, a significant review is contemplated to identify the different natural and synthetic adsorbents that have greater adsorption capacity, the different configurations in which a PSA operates are studied and identified, and the different mathematical models that describe the dynamic behavior of all the variables are established that interact in this PSA process, parametric studies are carried out in order to identify the variables that have the greatest effect on the purity obtained. The results obtained in this review allow facilitating the calculation of parameters, the optimization of the process, the automatic control to manipulate certain variables and to achieve the rejection of disturbances to have a recovery and production of biofuels with a high degree of purity.
Inexpensive equipment for the deposition of semiconductor thin films by SILAR was designed. Using a low-cost embedded system, a prototype controlled through a human–machine interface (HMI) was constructed. Simple, open-source software was used. The use of an HMI and programming based on state machines showed an improvement in the system control, program flow, and efficiency. The system development consists of three stages: structural design, electronics, and programming of the control and HMI. This system controls the variables of the SILAR process, such as immersion time in chemical solutions, sequence of substrates, and the number of cycles. In order to test the automated SILAR prototype, copper oxide thin films on glass substrates were processed. The copper oxide thin films have been characterized by X-ray diffraction (XRD), UV-VIS, and SEM to investigate the structural, optical, and morphological properties, respectively.