Market demands coating processes with high-performance, high reliability, high flexibility for processing of complex geometries and multi-material depositions, as well as increased deposition rates. The systematic coupling of two plasma transferred arc welding systems that interact in the same melt pool to form a tandem Plasma Transferred Arc (PTA) system accomplishes these tasks. Previous research has shown that the deposition rate with the tandem PTA method reaches 240 percent when comparing to the conventional single torch PTA method. Within one layer, up to four different powders and powder fractions can be combined at the same time. This allows for the creation of multi-material coatings that are suitable for sustaining high mechanical loads and wear- and temperature-resistant surfaces by use of tungsten carbides (WC). This study examines and analyzes defined functionally graded structures made from super duplex steel 1.4410 and corrosion resistant austenitic steel 1.4404. The mechanical-chemical properties of the tandem PTA system can be precisely controlled by changing the powder feeding positions. Furthermore, an additively manufactured specimen from previous studies is examined and evaluated. A direct comparison with conventional single torch PTA was performed to demonstrate the benefits of the tandem PTA-process.
The paper proposes a novel approach for determining multiple heat source parameters to achieve the necessary accuracy in the numerical prediction for a parallel tandem plasma transferred arc process. An artificial neural network (ANN) approach as a supervised learning–based artificial intelligence (AI) was used to model the complex relationship between heat distribution and tandem/dual heat source parameters based on finite element analysis (FEA). This study presents the first ANN-assisted numerical simulation for multiple heat source optimization of the tandem plasma transferred arc process. The model demonstrated high accuracy in predicting and calibrating the tandem heat source parameters, based on systematic simulation trials of the tandem plasma transferred arc welding. The results of the tandem heat source determined by ANN-assisted FEA were verified using experimental data on melt pool size and substrate distortion. This verification considered metrics such as penetration width, penetration depth, melt pool length, melt pool half-width, and the absolute distortion (measured as the difference between minimum and maximum displacement), with relative errors of 7.0%, 7.6%, 0.4%, 1.9%, and 9.7%, respectively.
Intermetallic Fe3Al-based alloys reinforced with Laves-phase precipitates are emerging as potential replacements for conventional high-alloy steels and possibly polycrystalline Ni-based superalloys in structural applications up to 700 °C. Their impressive mechanical properties, however, are offset by limited fabricability and poor machinability due to their severe brittleness. High tool wear during finish-machining, which is still required for components such as turbine blades, remains a key barrier to their broader adoption. In contrast to conventional manufacturing routes, additive manufacturing offers a viable solution by enabling near-net-shape manufacturing of difficult-to-machine iron aluminides. In the present study, laser powder bed fusion was used to produce an Fe-25Al-1.5Ta intermetallic containing strengthening Laves-phase precipitates, and the porosity, microstructure and phase composition were characterized as a function of the process parameters. The results showed that preheating the build plate to 650 °C effectively suppressed delamination and macrocrack formation, even though noticeable cracking still occurred at the high scan speed of 1000 mm/s. X-ray tomography revealed that samples fabricated with a lower scan speed (500 mm/s) and a higher layer thickness (0.1 mm) contained larger, irregularly shaped pores, whereas specimens printed at the same volumetric energy density (40 J/mm3) but with different parameter sets exhibited smaller fractions of predominantly spherical pores. All samples contained mostly elongated grains that were either oriented close to relative to the build direction or largely texture-free. X-ray diffraction confirmed the presence of Fe3Al and C14-type (Fe, Al)2Ta Laves phase in all samples. Hardness values fell within a narrow range (378–398 HV10), with only a slight reduction in the specimen exhibiting higher porosity.