MOHAMED ELBANNA

MOHAMED ELBANNA

Faculty of Engineering Ain-Shams Uni, Cairo, Al Qāhirah, Egypt
orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 July 2020 in IEEE Access
Verified
Journal Article
Open access
MSMarwa. S. Salem
Marwa. S. Salem
AAAbdullah J. Alzahrani
Abdullah J. Alzahrani
Rabie A. RamadanRabie A. Ramadan
Rabie A. Ramadan
AAAdwan Alownie Alanazi
Adwan Alownie Alanazi
Ahmed ShakerAhmed Shaker
Ahmed Shaker
Abdelhalim ZekryAbdelhalim Zekry
Abdelhalim Zekry
In this paper, an analytical model of a proposed low-cost high efficiency NPN silicon-based solar cell structure is presented. The structure is based on using low cost heavily doped commercially available silicon wafers and proposed to be fabricated by the same steps as the conventional solar cells except an extra deep trench etch step. Moreover, the cell has been engineered to react to the UV spectrum, resulting in a greater conversion performance. The presented analytical model takes the electrical and optical characteristics into account. Thus, the influence of both physical and technological parameters on the structure performance could be easily examined. Consequently, the optimization of the structure performance becomes visible. To inspect the validity of the analytical model, a comparison of the main performance parameters resulting from the model results with TCAD simulations is carried out showing good agreement.

19 July 2021 in IEEE Access
Verified
Journal Article
Open access
MEMOHAMED ELBANNA
MOHAMED ELBANNA
APAdel Helmy Phillips
Adel Helmy Phillips
ABAhmed Saeed Abdelrazek Bayoumi
Ahmed Saeed Abdelrazek Bayoumi
The object of the current research manuscript is to analyze the valley-spin thermoelectric properties and Nernst coefficient at two different temperatures for ferromagnetic silicene superlattice. Photon-assisted tunneling probability is used to identify the resolved thermoelectric parameters including (valley, spin, and charge) electronic thermal conductance, Seebeck coefficient, figure of merit, and also electrical conductance and Nernst coefficient. The results show oscillatory behavior to all investigated parameters. The improved data of Seebeck coefficient (valley, spin, and charge) could be because of quantum confinement effect of the present investigated nanodevice. The figure of merit (valley, spin, and charge) attains quite high values with good high thermoelectric efficiency. The enhancement of Nernst coefficient (valley, spin, and charge) might consider Nernst effect is suitable for thermoelectric heat energy conversion system of the present flexible ferromagnetic silicene superlattice. The ferromagnetic silicene superlattice nanodevices are good candidates for flexible renewable energy generation as demonstrated by this analysis.

1 January 2022 in Ain Shams Engineering Journal
Verified
Journal Article
Open access
YYYasmin Yahia
Yasmin Yahia
MSMarwa. S. Salem
Marwa. S. Salem
ASA. Shaker
A. Shaker
HKH. Kamel
H. Kamel
MAM. Abouelatta
M. Abouelatta
MEMOHAMED ELBANNA
MOHAMED ELBANNA

9 July 2022 in Crystals
Verified
Journal Article
Open access
PDF file
MSMarwa Salem
Marwa Salem
Abdelhalim ZekryAbdelhalim Zekry
Abdelhalim Zekry
Ahmed ShakerAhmed Shaker
Ahmed Shaker
MAMohamed Abouelatta
Mohamed Abouelatta
MEMOHAMED ELBANNA
MOHAMED ELBANNA
MAMohammad T. Alshammari
Mohammad T. Alshammari
This work aims at inspecting the device operation and performance of a novel flipped npn microstructure solar cell based on low-cost heavily doped silicon wafers. The flipped structure was designed to eliminate the shadowing effect as applied in the conventional silicon-based interdigitated back-contact cell (IBC). Due to the disappearance of the shadowing impact, the optical performance and short-circuit current density of the structure have been improved. Accordingly, the cell power conversion efficiency (PCE) has been improved in comparison to the conventional npn solar cell microstructure. A detailed analysis of the flipped npn structure was carried out in which we performed TCAD simulations for the electrical and optical performance of the flipped cell. Additionally, a comparison between the presented flipped microstructure and the conventional npn solar cell was accomplished. The PCE of the conventional npn structure was found to be 14.5%, while it was about 15% for the flipped structure when using the same cell physical parameters. Furthermore, the surface recombination velocity and base bulk lifetime, which are the most important recombination parameters, were studied to investigate their influence on the flipped microstructure performance. An efficiency of up to 16% could be reached when some design parameters were properly fine-tuned. Moreover, the impact of the different physical models on the performance of the proposed cell was studied, and it was revealed that band gap narrowing effect was the most significant factor limiting the open-circuit voltage. All the simulations accomplished in this analysis were carried out using the SILVACO TCAD process and device simulators.

27 March 2023 in Materials
Verified
Journal Article
Open access
PDF file
AEAbdelhady ali eLLAKANY
Abdelhady ali eLLAKANY
Abdelhalim ZekryAbdelhalim Zekry
Abdelhalim Zekry
MAMohamed Abouelatta
Mohamed Abouelatta
Ahmed ShakerAhmed Shaker
Ahmed Shaker
GSGihan T. Sayah
Gihan T. Sayah
MEMOHAMED ELBANNA
MOHAMED ELBANNA
Recently, nanowire detectors have been attracting increasing interest thanks to their advantages of high resolution and gain. The potential of using nanowire detectors is investigated in this work by developing a physically based model for Indium Phosphide (InP) phototransistor as well as by performing TCAD simulations. The model is based on solving the basic semiconductor equations for bipolar transistors and considering the effects of charge distribution on the bulk and on the surface. The developed model also takes into consideration the impact of surface traps, which are induced by photogenerated carriers situated at the surface of the nanowire. Further, photogating phenomena and photodoping are also included. Moreover, displacement damage (DD) is also investigated; an issue arises when the detector is exposed to repeated doses. The presented analytical model can predict the current produced from the incident X-ray beam at various energies. The calculation of the gain of the presented nanowire carefully considers the different governing effects at several values of energies as well as biasing voltage and doping. The proposed model is built in MATLAB, and the validity check of the model results is achieved using SILVACO TCAD device simulation. Comparisons between the proposed model results and SILVACO TCAD device simulation are provided and show good agreement.

29 September 2022 in Energies
Verified
Journal Article
Open access
PDF file
MSMarwa Salem
Marwa Salem
Abdelhalim ZekryAbdelhalim Zekry
Abdelhalim Zekry
Ahmed ShakerAhmed Shaker
Ahmed Shaker
MAMohamed Abouelatta
Mohamed Abouelatta
TATariq Almurayziq
Tariq Almurayziq
MEMOHAMED ELBANNA
MOHAMED ELBANNA
In the current study, the performance of the npn solar cell (SC) microstructure is improved by inspecting some modifications to provide possible paths for fabrication techniques of the structure. The npn microstructure is simulated by applying a process simulator by starting with a heavily doped p-type substrate which could be based on low-cost Si wafers. After etching deep notches through the substrate and forming the emitter by n-type diffusion, an aluminum layer is deposited to form the emitter electrode with about 0.1 µm thickness; thereby, the notches are partially filled. This nearly-open-notches microstructure, using thin metal instead of filling the notch completely with Al, gives an efficiency of 15.3%, which is higher than the conventional structure by 0.8%. Moreover, as antireflection coating (ARC) techniques play a crucial role in decreasing the front surface reflectivity, we apply different ARC schemes to inspect their influence on the optical performance. The influence of utilizing single layer (ZnO), double (Si3N4/ZnO), and triple (SiO2/Si3N/ZnO) ARC systems is investigated, and the simulation results are compared. The improvement in the structure performance because of the inclusion of ARC is evaluated by the relative change in the efficiency (Δη). In the single, double, and triple ARC, Δη is found to be 12.5%, 15.4%, and 17%, respectively. All simulations are performed by using a full TCAD process and device simulators under AM1.5 illumination.