The strengthening mechanism of X100 high steel grade pipeline steel, including grain boundary strengthening, solution strengthening, precipitation strengthening, dislocation strengthening, and texture strengthening, was analyzed by the technics of scanning electron microscopy (SEM), electron backscattered diffraction (EBSD), transmission electron microscopy (TEM), X-ray diffraction (XRD), physicochemical phase analysis, and so on. The results showed that the tested steel had a mixed structure of granular bainite and lath bainite, the average effective grain size was refined to about 1 μm by severe hot plastic deformation, the dislocation density was as high as 1.74 × 1015/m2, and the second phase precipitation was mainly (Ti, Nb)(C, N) in submicron scale and nanoscale NbC. Through orientation distribution function (ODF) orientation analysis, it was found that the tested steel had obvious anisotropy and had a strong rolling direction (RD) texture along the rolling direction compared with the 30° direction: {115} and {113}. After the quantitative analysis of strengthening mechanisms, it was found that the highest strengthening increment was caused by high-density dislocations in bainite of about 268 MPa, while the lowest strengthening increment was induced by precipitation particles of about 31 MPa.
20 February 2020 in Journal of Materials Engineering and Performance
Retained austenite (RA) transformation and its role in the mechanical properties of three low-carbon micro-alloyed quenching and partitioning (Q&P) steels was investigated utilizing in situ tensile tests and electron microscopy. Meanwhile, RA’s strain-induced martensite transformation (SIMT) was analyzed and discussed in terms of the strengthening mechanism. The results show that the ductility of the Q&P steels relies on the size and morphology of RA. In addition, both affect RA’s mechanical or thermostability. Dislocation density and carbon trapping should be considered in estimating the yield strength in the two-step Q&P process. V and Nb-Ti elements promote the formation of blocky RA. Ti accelerates the formation of film-like RA. For experimental Q&P steels with different processes and compositions, the true stress always keeps a linear relationship with the amount of transformed martensite, i.e., 30.38~46.37 MPa per vol. 1% transformed martensite, during the in situ tensile deformation.
13 November 2021 in Transactions of the Indian Institute of Metals
Iron-based soft magnetic composites (SMCs) are the key components of high-frequency electromagnetic systems. Selecting a suitable insulating oxide layer and ensuring the integrity and homogeneity of the heterogeneous core–shell structure of SMCs are essential for optimizing their magnetic properties. In this study, four types of SMCs—Fe-Si-Cr/ZrO2, Fe-Si-Cr/TiO2, Fe-Si-Cr/MgO, and Fe-Si-Cr/CaO—were prepared via ball milling, followed by hot-press sintering. The differences between the microscopic morphologies and magnetic fproperties of the Fe-Si-Cr/AOx SMCs prepared using four different metal oxides were investigated. ZrO2, TiO2, MgO, and CaO were successfully coated on the surface of the Fe-Si-Cr alloy powders through ball milling, forming a heterogeneous Fe-Si-Cr/AOx core–shell structure with the Fe-Si-Cr alloy powder as the core and the metal oxide as the shell. ZrO2 is relatively hard and less prone to breakage and refinement during ball milling, resulting in a lower degree of agglomeration on the surface of the composites and prevention of peeling and collapse during hot-press sintering. When ZrO2 was used as the insulation layer, the magnetic dilution effect was minimized, resulting in the highest resistivity (4.2 mΩ·cm), lowest total loss (580.8 kW/m3 for P10mt/100kHz), and lowest eddy current loss (470.0 kW/m3 for Pec 10mt/100kHz), while the permeability stabilized earlier at lower frequencies.