Lili Lang

Dr. Lili Lang

Shanghai Institute of Microsystem and Information Technology, Shanghai, China
orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 December 2020 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
YLYan Liu
Yan Liu
LLLili Lang
Lili Lang
YCYongwei Chang
Yongwei Chang
YSYi Shan
Yi Shan
XCXiaojie Chen
Xiaojie Chen
YDYemin Dong
Yemin Dong
The cryogenic performance of multinanoscale CMOS transistors with a standard 55-nm Si-bulk technology is systematically investigated by dc measurements. In contrast to 300 K, the cryogenic drain saturation current (Idsat) gain significantly enhances from 54% to 167% with the increasing channel length and has a relatively weak response to width change. In addition, the degraded subthreshold swing (SS) due to the short channel effect is alleviated at lower temperatures. The merits of a typical nMOS transistor (W/L =0.6 μm/60 nm) worked at 4.2 K are associated with an improved Idsat (~1.3 times), decreased drain leakage current with three orders of magnitude, and 2/3 reduced SS. However, the cryogenic Idsat tends to saturate below 10 K and the threshold voltage increases, as well as barrier lowering induced by drain voltage, starts to deteriorate. The detailed analyses on these MOSFET (deep) cryogenic characteristics are implemented based on the comprehensive semiconductor physics images, including energy band change, temperature/geometry-dependent scattering, band-to-band tunneling process, and depletion width influence. Our findings will be beneficial for the community to design ultralow temperature-integrated circuits.

13 January 2020 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
LLLili Lang
Lili Lang
YJYujie Jiang
Yujie Jiang
FLFei Lu
Fei Lu
CWCailu Wang
Cailu Wang
YCYizhang Chen
Yizhang Chen
LYLi Ye
Li Ye
We investigated the low temperature performance of CoFeB/MgO-based perpendicular magnetic tunnel junctions (pMTJs) by characterizing their quasi-static switching voltage, high speed pulse write error rate, and endurance down to 9 K. pMTJ devices exhibited high magnetoresistance (>120%) and reliable (error rate < 10−4) bi-directional switching with 2–200 ns voltage pulses. The endurance of the devices at 9 K surpassed that at 300 K by three orders of magnitude under the same write conditions, functioning for more than 1012 cycles with 10 ns write pulses. The switching voltage at 9 K was observed to increase by 33% to 93%, depending on the pulse duration, compared to that at 350 K. Ferromagnetic resonance and magnetization measurements on blanket pMTJ film stacks suggest that the increased switching voltage is associated with an increase in the energy barrier of the free layer with decreasing temperature. Our work demonstrates that CoFeB/MgO-based pMTJs have great potential to enable cryogenic magnetic random access memory and that their exchange stiffness, magnetization, and effective magnetic anisotropy can be further optimized to lower operating power and improve endurance.

10 July 2023 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
Verified
Journal Article
Closed access
LSLin Sun
Lin Sun
ZZZhenwei Zhang
Zhenwei Zhang
LLLili Lang
Lili Lang
TKTong Kang
Tong Kang
WXWei Xiong
Wei Xiong
YDYemin Dong
Yemin Dong
This brief proposes a fully digital background estimation technique for timing mismatch in time-interleaved analog-to-digital converters (TIADCs). The improved estimation technique is a feedback method based on statistics and Taylor series expansion. Besides, an exponential moving average (EMA) with adaptive coefficient is introduced to prevent performance degradation near specific frequencies, which improves the robustness of calibration. This estimation method can maintain high performance of accuracy and convergence speed across nearly the entire input frequency band. Furthermore, it is not restricted to the number of channels, amplitude, and frequency of the input signal. The effectiveness of this technique is demonstrated through off-chip calibration of a commercial 12-bit four-channel 3 GS/s TIADC using a 1.01 GHz input signal. Results indicate that the proposed method converges after approximately 3000 samples, reducing spurious signals stemming from timing mismatch by 20.6, 19.3, and 18.5 dB, respectively.

9 March 2023 in Electronics
Verified
Journal Article
Open access
PDF file
TKTong Kang
Tong Kang
ZZZhenwei Zhang
Zhenwei Zhang
WXWei Xiong
Wei Xiong
LSLin Sun
Lin Sun
YLYu Liu
Yu Liu
YDYemin Dong
Yemin Dong
Timing-mismatch errors among channels in time-interleaved analog-to-digital converters (TIADCs) greatly degrade the whole performance of the system. Therefore, techniques for calibrating timing mismatch are indispensable, and a new fully-digital calibration technique is presented in this article. Based on a Hilbert filter, modified moving averagers (MMAs) and inverse cosine functions, the proposed estimation algorithm is fast (within 1200 sample points) and accurate. Meanwhile, the coordinate rotational digital computer (CORDIC) algorithm, which is used to implement inverse cosine functions, is also improved, giving it higher precision. In addition, a compensation method based on second-order Taylor series approximation with less hardware resource consumption is provided. Through analyses and simulations, this calibration technique proved to be suitable for TIADCs with an arbitrary number of channels, in which the signal-to-noise and distortion ratio (SNDR) and the spurious-free dynamic range (SFDR) were, respectively, improved from 24.06 dB and 24.57 dB to 67.96 dB and 85.69 dB.

4 December 2024 in Advanced Science
Verified
Journal Article
Open access
MWMingzhi Wang
Mingzhi Wang
CPChang Pan
Chang Pan
NXNian Xie
Nian Xie
Xuepeng QiuXuepeng Qiu
Xuepeng Qiu
YLYufei Li
Yufei Li
ZSZhong Shi
Zhong Shi
The spin Hall efficiency (ξ) is a crucial parameter that evaluates the charge‐to‐spin conversion capability of a material, and thus materials with higher ξ are highly desirable in spin–orbit torque (SOT) devices. Recent studies have highlighted the use of ferromagnetic materials as robust spin sources, paving the way for the development of more efficient SOT devices. To accelerate this innovation, it is essential to pursue ferromagnetic materials of high ξ. Here the experimental observation of a large spin Hall efficiency is reported in ferromagnetic Heusler alloy Co2MnAl (CMA)‐based magnetic trilayers. Utilizing the current‐induced hysteresis loop shift technique, the spin Hall efficiency is determined to be 0.077 for the B2‐phase and 0.029 for the disordered CMA. Notably, magnetization switching both with and without the application of an external auxiliary magnetic field were achieved in these trilayers. The enhancement of ξ is attributed to the formation of chemical ordering in CMA. These findings provide new avenues for the development of ferromagnet‐based SOT devices.

18 December 2023 in Electronics
Verified
Journal Article
Open access
PDF file
LSLin Sun
Lin Sun
LLLili Lang
Lili Lang
WZWei Zhong
Wei Zhong
HLHaijing Liu
Haijing Liu
YDYemin Dong
Yemin Dong
This paper proposes a fully digital background calibration method for time-interleaved analog-to-digital converter (TIADC) mismatches. The method analyzes the frequency and phase of spurious signals caused by three types of mismatches in TIADCs in the frequency domain. By utilizing the Hilbert transform and frequency shifting, orthogonal basis signals located at the mismatch frequencies can be constructed. The calibration of mismatches is achieved by linearly combining the orthogonal basis signals with the estimated coefficients and subtracting them from the original signal. The estimation of coefficients is determined by evaluating the correlation between the linear combination of orthogonal basis signals and the calibrated signal. Furthermore, an exponential moving average (EMA) and least mean square (LMS) algorithm are introduced to expedite the coefficient estimation process. The entire calibration process converges in merely 600 samples, significantly improving the convergence speed. By monitoring the amplitude of the input signal and adjusting the LMS step, the algorithm is functional under different amplitude signals, enhancing the robustness. An off-chip calibration is conducted based on a commercial 14-bit, 8-channel, 2.4GSPS TIADC. Results indicate that all spurious signals are suppressed below 80 dB, and the convergence rate is consistent with the simulation.