mahmoud sherif

Dr. mahmoud sherif

Steel and ferro-alloys, Central Metallurgical Research and Development Institute, Cairo, Al Qāhirah, Egypt
orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 January 2023 in Materials
Verified
Journal Article
Open access
PDF file
MOmostafa mahmoud oweis
mostafa mahmoud oweis
SEShimaa El-Hadad
Shimaa El-Hadad
MSmahmoud sherif
mahmoud sherif
KIKhaled M Ibrahim
Khaled M Ibrahim
AFAhmed I. Z. Farahat
Ahmed I. Z. Farahat
Helmi AttiaHelmi Attia
Helmi Attia
A comparative study was conducted for the machining of two α/β titanium alloys, namely Ti-6Al-4V (Ti64) and Ti-6Al-7Nb (Ti67), using wire electric discharge machining (WEDM). The influence of cutting speed and cutting mode on the machined surfaces in terms of surface roughness (Ra), recast layer (RL), and micro-hardness have been evaluated. Rough cut (RC) mode at a cutting speed of 50 µm/s resulted in thermal damage; Ra was equal to 5.68 ± 0.44 and 4.52 ± 0.35 µm for Ti64 and Ti67, respectively. Trim-cut mode using seven cuts (TRC-VII) at the same speed decreased the Ra to 1.02 ± 0.20 µm for Ti64 and 0.92 ± 0.10 µm for Ti67. At 100 µm/s, Ra reduced from 2.34 ± 0.28 µm to 0.88 ± 0.12 µm (Ti64), and from 1.42 ± 0.15 µm to 0.90 ± 0.08µm (Ti67) upon changing from TRC-III to TRC-VII. Furthermore, a thick recast layer of 30 ± 0.93 µm for Ti64 and 14 ± 0.68 µm for Ti67 was produced using the rough mode, while TRC-III and TRC-VII modes produced layers of 12 ± 1.31 µm and 5 ± 0.72 µm for Ti64 and Ti67, respectively. Moreover, rough cut and trim cut modes of WEDM played a significant role in promoting the surface hardness of Ti64 and Ti67. By employing the Response Surface Methodology, it was found that the machining mode followed by cutting speed and the interaction between them are the most influential parameters on surface roughness. Finally, mathematical models correlating machining parameters to surface roughness were successfully developed. The results strongly promote the trim-cut mode of WEDM as a promising machining route for two-phase titanium alloys.

10 May 2026 in Materials & Design
Verified
Journal Article
Open access
MSmahmoud sherif
mahmoud sherif
MAMohammed Ali
Mohammed Ali
SSSaeed Sadeghpour
Saeed Sadeghpour
MEMamdouh Eissa
Mamdouh Eissa
PKPentti Karjalainen
Pentti Karjalainen
Vahid JavaheriVahid Javaheri
Vahid Javaheri