The effect of free volume on the process of crystallization of an Al87Ni8Gd5 amorphous alloy is investigated. The deformation of the amorphous alloys leads to the formation of shear bands, which contain an enhanced free volume concentration. To retain the free volume the amorphous alloy was coated with a layer of a refractory metal. The structure of the Al87Ni8Gd5 alloy with a protective Ta coating was studied by X-ray diffraction and transmission electron microscopy methods. The fraction of the nanocrystalline phase formed in the amorphous samples with a protective Ta coating under annealing was found to be larger than that in the uncoated samples. The size of Al nanocrystals formed in the coated and uncoated samples is the same. A higher rate of crystal nucleation in the deformed amorphous samples with a protective coating is caused by a higher diffusion coefficient due to an enhanced free volume concentration.
The nanocrystal formation in Zr55Cu30Al15Ni5 bulk metallic glass was studied under heat treatment and deformation. The activation energy of crystallization under heating is 278 kJ/mol. Different crystalline phases were found to be formed during crystallization under heating and deformation. At the first crystallization stage, the metastable phase with a hexagonal structure (lattice of space group P63/mmc with the parameters a = 8.66 Å, c = 14.99 Å) is formed under heat treatment. When the temperature rises, the metastable phase decays with the formation of stable crystalline phases. The crystalline Zr2Cu phase with the lattice of space group Fd3m is formed during crystallization under the action of deformation. It was determined that during deformation nanocrystals are formed primarily in the subsurface regions of the samples.
A change in the structure of an amorphous Zr55Cu30Al10Ni5 alloy under deformation by high-pressure torsion (HPT) was studied by X-ray diffraction, high-resolution electron microscopy, scanning electron microscopy, and atomic force microscopy. It was found that the uneven distribution of deformation along the radius of the sample, characteristic of deformation by high-pressure torsion, led to the formation of an inhomogeneous structure. The formation of nanocrystals begins at the periphery of the sample. The threshold value of deformation required for crystallization onset was established; the formation of nanocrystals begins in areas with true deformation e = 4.83 or more. An increase in the deformation degree led to an increase in the height of steps on the deformed sample surface and an increase in the roughness of the surface. The thickness of an elementary step that was formed when one shear band came out to the surface was 10 nm, and its height was about 1 nm. It was found that large steps on the deformed surface of the sample had a complex structure and consisted of a large number of elementary steps. The results obtained are important for analyzing the stress distribution and the concentration of free volume in a deformed material, which affect the parameters of the amorphous-nanocrystalline structure formed.
The structure and properties of the amorphous Fe78Si13B9 alloy were studied after severe plastic deformation and subsequent heat treatment. The deformation was performed by torsion under high pressure at room temperature. The heat treatment was carried out at temperatures lower than the alloy crystallization temperature. The investigations were performed using X-ray diffraction, transmission electron microscopy, and vibrating-sample magnetometry. It was shown that the minimum coercive force (1.7 Oe) corresponds to the initial state and increases up to 2.6 Oe with an increase in the degree of deformation. It was found that the heat treatment of the deformed Fe78Si13B9 alloy improves its soft magnetic characteristics. The successive annealings for 1 h and, then, 2 h at a temperature of 200°C led to a decrease in the coercive force of the samples from 2.6 to 2.0 Oe.