Mushroom consumption has increased in recent years due to their beneficial properties to the proper functioning of the body. Within this framework, the high potential of mushrooms as a source of essential elements has been reported. Therefore, the present study aims to determine the mineral content of seven essential metals, Fe, Mg, Mn, P, K, Ca, and Na, in twenty samples of mushrooms of the genus Lactarius collected from various locations in southern Spain and northern Morocco, by FAAS, UV-Vis spectroscopy, and ICP-OES after acid digestion. Statistics showed that K was the macronutrient found at the highest levels in all mushrooms studied. ANOVA showed that there were statistically significant differences among the species for K, P, and Na. The multivariate study suggested that there were differences between the accumulation of the elements according to the geographic location and species. Furthermore, the intake of 300 g of fresh mushrooms of each sample covers a high percentage of the RDI, but does not meet the recommended daily intake (RDI) for any of the metals studied, except for Fe. Even considering these benefits, the consumption of mushrooms should be moderated due to the presence of toxic metals, which may pose health risks.
This review focuses on trace element speciation in edible mushrooms, providing information on analytical methods, available literature data, and health risk assessment. All steps of analytical procedures were presented, including extraction, separation and quantification. It compiles fragmented literature data on trace element speciation, focusing on arsenic, chromium, selenium, mercury, and antimony. Key findings include nonbioaccumulative chromium, the prevalence of Sb(V), mercury accumulation in contaminated sites, diverse arsenic and selenium speciation. Safe intake limits by agencies like USEPA indicate low risk for Cr(VI) and Sb but significant hazards from mercury and methylmercury, especially in contaminated areas: about 10 % of samples exceed safe limits for inorganic arsenic, and selenium enrichment often surpasses safety thresholds. The review underscores the need for standardized methods, speciation analyses of all toxicologically relevant species, and research on cooking impacts to improve health risk evaluations: establishing safe conditions for mushroom consumption remains a far-fetched goal.
The intake of mushrooms provides numerous beneficial properties for the correct functioning of the human body due to their rich content in carbohydrates, proteins, fibers, vitamins, and minerals. However, most of the reports are focused on the determination of bioactive compounds and only a few regarding the essential mineral content and the evaluation of the RDI. Thus, the aim of this study was to determine the mineral composition of different cultivated (A. bisporus and P. ostreatus) and wild edible mushrooms (A. crocodilinus, A. arvensis, A. silvicola, A. impudicus, M. mastoidea, M. rhacodes, and P. ostreatus) collected in the south of Spain and north of Morocco. First, the optimization of a microwave-assisted digestion method was carried out using a Box–Behnken design with a response surface methodology to quantify the total content of five metals: Fe, Mg, Na, K, and Ca in mushrooms. The samples were analyzed by FAAS and ICP-OES. The percentage of the RDI of each mineral covered by the intake of mushrooms was calculated. It was observed that a high percentage of RDI levels are covered and just exceeded for Fe. Thence, due to their beneficial properties and high content of essential minerals, mushrooms would be proposed as a valuable source of nutrients to manufacture some food supplements.
Antimony (Sb) contamination poses significant environmental and health concerns due to its toxic nature and widespread presence, largely from anthropogenic activities. This study addresses the urgent need for an accurate speciation analysis of Sb, particularly in water sources, emphasizing its migration from polyethylene terephthalate (PET) plastic materials. Current methodologies primarily focus on total Sb content, leaving a critical knowledge gap for its speciation. Here, we present a novel analytical approach utilizing frontal chromatography coupled with inductively coupled plasma mass spectrometry (FC-ICP-MS) for the rapid speciation analysis of Sb(III) and Sb(V) in water. Systematic optimization of the FC-ICP-MS method was achieved through multivariate data analysis, resulting in a remarkably short analysis time of 150 s with a limit of detection below 1 ng kg−1. The optimized method was then applied to characterize PET leaching, revealing a marked effect of the plastic aging and manufacturing process not only on the total amount of Sb released but also on the nature of leached Sb species. This evidence demonstrates the effectiveness of the FC-ICP-MS approach in addressing such an environmental concern, benchmarking a new standard for Sb speciation analysis in consideration of its simplicity, cost effectiveness, greenness, and broad applicability in environmental and health monitoring.