In this paper, a microheater that can absorb thermal stress and has a large heating area is demonstrated by optimizing the structure and process of the microheater. Four symmetrically distributed elongated support beam structures were machined around the microheater via deep silicon etching. This design efficiently mitigates the deformation of the heated region caused by thermal expansion and enhances the structural stability of the microheater. The updated microheater no longer converts the work area into a thin film; instead, it creates a stable heating platform that can uniformly heat a work area measuring 10 × 10 mm2. The microheater is verified to have high temperature uniformity and structural stability in finite element simulation. Finally, thorough investigations of electrical–thermal–structural characterization were conducted. The test findings show that the new microheater can achieve 350 °C with a power consumption of 6 W and a thermal reaction time of 22 s. A scan of its whole plane reveals that the surface of the working area of the new microheater is flat and does not distort in response to variations in temperature, offering good structural stability.
Circumferential milling is used in wood processing, yet it generates vast quantities of dust and chips in a single pass, highlighting the need to predict chip dispersion and prevent associated hazards. This article presents findings from a theoretical and experimental analysis of chip size and kinematics of pine wood during cutting. A chip diffusion boundary surface model was established and its key parameters were determined through CCD testing. Results reveal that chip diffusion can be divided into three distinct areas based on motion state: main diffusion, random diffusion, and vortex. Notably, spindle speed and feed rate are most influential on the orthogonal diffusion angle of the main diffusion zone, whereas cutting depth most heavily impacts the top view diffusion angle. Chip scattering on the table showed an exponential increase in average chip size with sampling distance, whereas the boundary surface model accurately characterizes chip motion and demonstrates a reasonable degree of reliability, offering potential in predicting chip morphology and diffusion state. This model has important implications for wood milling practices, particularly in controlling chip dispersion.
Continuous gas leakage in thin-walled sealed spacecraft structures produces sustained broadband acoustic-emission (AE) signals from which reliable first-arrival picking is difficult. This study presents an interpretable two-stage workflow that decouples leak screening from regional localization. Experiments used a 500 × 500 × 2.5 mm 3A21 aluminum-alloy plate with eight piezoelectric AE sensors under 0.1 MPa pressure difference. Intact, circular-hole, and slit-leak conditions were each tested three times with a 0.5–1.5 s steady-state window. Leak screening employed the 20–200 kHz mean spectral amplitude (Hann window). A provisional threshold of 0.85, set from three intact records, separated all leak records from intact controls. Regional localization used relative logarithmic RMS amplitudes in an energy-decay plus maximum-likelihood-estimation (ED+MLE) cost function on a 10 mm grid. The equivalent attenuation coefficient, empirically selected as 2.3 m−1 using the 1 mm central-hole calibration case, gave a 10 mm grid error for that calibration demonstration. With this coefficient fixed, the four transfer conditions yielded mean localization errors of 19.6–45.7 mm. The results provide preliminary feasibility evidence for leak detection and regional localization under the controlled laboratory conditions investigated in this study. Further validation requires independent channel calibration, larger background datasets, leak-rate measurements, parameter-sensitivity analysis, and testing on more representative structures.