This review explores the impact of various additives on the mechanical properties of polylactic acid (PLA) filaments used in Fused Deposition Modeling (FDM) 3D printing. While PLA is favored for its biodegradability and ease of use, its inherent limitations in strength and heat resistance necessitate enhancements through additives. The impact of natural and synthetic fibers, inorganic particles, and nanomaterials on the mechanical properties, printability, and overall functionality of PLA composites was examined, indicating that fiber reinforcements, such as carbon and glass fibers, significantly enhance tensile strength and stiffness, while natural fibers contribute to sustainability but may compromise mechanical stability. Additionally, the inclusion of inorganic particulate fillers like calcium carbonate improves dimensional stability and printability, although larger particles can lead to agglomeration issues. The study highlights the potential for improved performance in specific applications while acknowledging the need for further investigation into optimal formulations and processing conditions.

This paper discusses the structure morphology and the thermal and swelling behavior of physically crosslinked hydrogels, obtained from applying four successive freezing–thawing cycles to poly (vinyl alcohol) blended with various amounts of κ-carrageenan. The addition of carrageenan in a weight ratio of 0.5 determines a twofold increase in the swelling degree and the early diffusion coefficients of the hydrogels when immersed in distilled water, due to a decrease in the crystallinity of the polymer matrix. The diffusion of water into the polymer matrix could be considered as a relaxation-controlled transport (anomalous diffusion). The presence of the sulfate groups determines an increased affinity of the hydrogels towards crystal violet cationic dye. A maximum physisorption capacity of up to 121.4 mg/g for this dye was attained at equilibrium.

Tantalum oxynitride thin films have been deposited by reactive magnetron sputtering, using a fixed proportion reactive gas mixture (85% N₂ + 15% O₂). To produce the films, the partial pressure of the mixture in the working atmosphere was varied. The characteristics of the produced films were analyzed from three main perspectives and correspondent correlations: the study of the bonding states in the films, the efficiency of photo-degradation, and the antibacterial/antibiofilm capacity of the coatings against Salmonella. X-ray Photoelectron Spectroscopy results suggest that nitride and oxynitride features agree with a constant behavior relative to the tantalum chemistry. The coatings deposited with a higher reactive gas mixture partial pressure exhibit a significantly better antibiofilm capacity. Favorable antibacterial resistance was correlated with the presence of dominant oxynitride contributions. The photocatalytic ability of the deposited films was assessed by measuring the level of degradation of an aqueous solution containing methyl orange, with or without the addition of H₂O₂, under UV or VIS irradiation. Degradation efficiencies as high as 82% have been obtained, suggesting that tantalum oxynitride films, obtained in certain configurations, are promising materials for the photodegradation of organic pollutants (dyes).

This paper presents an alternative approach to obtaining crack- and pore-free NiCrBSiFeCuMoC hard coatings on a low alloy steel substrate through coaxial laser cladding, by using Inconel 718 as a buffer layer between the hard coating and the base material. The presence of the buffer layer reduces the overall cracking susceptibility of the hardfacing material by reducing the compressive stresses developed during the cladding process and ensuring a more uniform heat distribution gradient at the surface of the material than the base metal alone, which provides an additional hardness and wear coefficient increase of 7% and improves the corrosion resistance of the obtained materials by 20%, in comparison with the reference sample obtained without an intermediate layer, by using the same operational parameters and minimizes elemental dilution with the substrate. Our method could prove useful in increasing the quality and life cycle of expensive high-performance hard-coated materials, especially those working under demanding operational and environmental conditions.