Keon-Hyeong Lee

Mr. Keon-Hyeong Lee

Aerospace Engineering, Pusan National University, Busan, Republic of Korea
orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 November 2024 in Aerospace Science and Technology
Verified
Journal Article
Closed access
MKMin-Su Kim
Min-Su Kim
BSBu-Kyeng Sung
Bu-Kyeng Sung
KLKeon-Hyeong Lee
Keon-Hyeong Lee
SJSeung-Min Jeong
Seung-Min Jeong
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi
KYKenneth H. Yu
Kenneth H. Yu

8 November 2023 in Aerospace
Verified
Journal Article
Open access
PDF file
IKIn-Hoi Koo
In-Hoi Koo
KLKeon-Hyeong Lee
Keon-Hyeong Lee
MKMinsu Kim
Minsu Kim
HHHyung-Seok Han
Hyung-Seok Han
HKHolak Kim
Holak Kim
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi
Fuel injection and mixing affect the characteristics of detonation initiation and propagation, as well as the propulsion performance of rotating detonation engine (RDE). A study on the injector is carried out in the present investigation. A rectangular-shaped hole-type fuel injector (RHFI) and slit-type fuel injector (SFI) were designed and compared experimentally at equivalent conditions. The investigation of the detonation propagation modes and the analysis of propulsion performance were carried out using fast Fourier transform (FFT), short-time Fourier transform (STFT), and unwrapped image post-processing. Under 50, 75, and 100 g/s flow rate conditions at an equivalence ratio of 1.0 ± 0.05, the RHFI has relatively stable detonation propagation characteristics, higher thrust, and specific impulse performance. Additionally, the results of the experiment indicate that the number of detonation waves affects performance.

11 August 2023 in Aerospace
Verified
Journal Article
Open access
PDF file
MKMinsu Kim
Minsu Kim
IKIn-Hoi Koo
In-Hoi Koo
KLKeon-Hyeong Lee
Keon-Hyeong Lee
ELEun Sung Lee
Eun Sung Lee
HHHyung-Seok Han
Hyung-Seok Han
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi
This experimental investigation focused on the ignition and combustion characteristics of a tandem cavity-based scramjet combustor with side-by-side identical cavities. This study utilized the Pusan National University-direct connect scramjet combustor (PNU-DCSC), which was capable of simulating flight conditions at Mach number 4.0–5.0 and altitudes of 20–25 km using the vitiated air heater (VAH). The combustion tests were conducted under off-design point conditions corresponding to low inlet enthalpy. It is a condition in which self-ignition does not occur, and a micro pulse detonation engine (μPDE) ignitor is used. The results revealed that as the injection pressure of the gaseous hydrogen fuel (GH2) and the corresponding equivalence ratio increased, the combustion mode transitioned from the cavity-shear layer flame to the jet-wake flame. Furthermore, the measured wall static pressure profiles along the isolator and scramjet combustor indicated that the region of elevated pressure distribution caused by the shock train expanded upstream with higher equivalence ratios. When ignited from the secondary cavity, the combustion area did not extend to the primary cavity at lower equivalence ratios, while it expanded upstream faster with higher equivalence ratios. Therefore, the combustion characteristics of the tandem cavity were found to vary based on the overall equivalence ratio of the main fuel (GH2) and ignition position.


25 October 2025 in Combustion and Flame
Verified
Journal Article
Closed access
KLKeon-Hyeong Lee
Keon-Hyeong Lee
BSBu-Kyeng Sung
Bu-Kyeng Sung
GMGyeong-Ui Mo
Gyeong-Ui Mo
SCSu-Wan Choi
Su-Wan Choi
MJMin-Seon Jo
Min-Seon Jo
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi

8 July 2024 in Aerospace
Verified
Journal Article
Open access
PDF file
KLKeon-Hyeong Lee
Keon-Hyeong Lee
MKMinsu Kim
Minsu Kim
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi
KYKenneth H. Yu
Kenneth H. Yu
A micro-pulse detonation engine (μPDE) was designed and installed to a direct-connect scramjet combustor of Pusan National University (PNU-DCSC). The active excitation on the scramjet combustor was experimentally studied using the μPDE operating at frequencies of 10–20 Hz. A vitiation air heater (VAH) was used to supply high-enthalpy vitiated air to the isolator and the scramjet combustor at a Mach number of 2.0, with a total temperature of 1600 K and a total pressure of 1.68 MPa. The exit of μPDE was located at the center of the cavity of the scramjet combustor. Active excitation was performed at equivalence ratios of 0.111 and 0.163, and characteristics were analyzed through Schlieren recording and bottom wall pressure measurement. As a result, when the detonation emitted from the μPDE entered the scramjet combustor, it instantly formed a shock train and moved forward within the scramjet combustor. The flame instantaneously changed from the cavity shear layer flame to the cavity flame. Through bottom wall pressure measurement, it was also observed that active excitation resulted in a significant pressure increase near the cavity compared to when active excitation was not performed. This revealed combustion characteristics, indicating improved combustion efficiency from the pressure increase in the scramjet combustor.