Krzysztof Klos

Dr. Krzysztof Klos

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 April 2023 in Optics Express
Verified
Journal Article
Open access
LHL. A. Hanks
L. A. Hanks
KMKatarina Mamic
Katarina Mamic
KKKrzysztof Klos
Krzysztof Klos
ABAndrew Bainbridge
Andrew Bainbridge
JFJosh Fletcher
Josh Fletcher
AMA. R. J. Marshall
A. R. J. Marshall
An InGaAsSb p-B-n structure has been designed and characterized for zero bias low power detection applications. Devices were grown by molecular beam epitaxy and fabricated into quasi-planar photodiodes with a 2.25 µm cut-off wavelength. Maximum responsivity was measured to be 1.05 A/W at 2.0 µm, achieved at zero bias. D* of 9.4 × 1010 Jones was determined from room temperature spectra of noise power measurements with calculated D* remaining >1 × 1010 Jones up to 380 K. With a view to simple miniaturized detection and measurement of low concentration biomarkers, optical powers down to 40 pW were detected, without temperature stabilization or phase-sensitive detection, indicating the photodiode’s potential.

10 November 2024 in Materials
Verified
Journal Article
Open access
PDF file
TMTetiana Manyk
Tetiana Manyk
JRJarosław Rutkowski
Jarosław Rutkowski
MKMałgorzata Kopytko
Małgorzata Kopytko
KKKrzysztof Klos
Krzysztof Klos
PMPiotr Martyniuk
Piotr Martyniuk
This paper presents a theoretical analysis of an nBp infrared barrier detector’s performance intended to operate at a room temperature (300 K) based on AIIIBV materials—In1-xGaxAsySb1−y quaternary compound—lattice-matched to the GaSb substrate with a p-n heterojunction ternary Al1−xGaxSb barrier. Numerical simulations were performed using a commercial Crosslight Software—package APSYS. The band structure of the nBp detector and the electric field distribution for the p-n heterojunction with and without a potential barrier were determined. The influence of the barrier-doping level on the detector parameters was analyzed. It was shown that Shockley-Read-Hall (SRH) recombination plays a decisive role in carrier transport for lifetimes shorter than 100 ns. The influence of the absorber/barrier thickness on the detector’s dark current density and photocurrent was investigated. It was shown that valence band offset does not influence the device’s performance. The quantum efficiency reaches its maximum value for an absorber’s thickness of ~3 μm. The performed simulations confirmed the possibility of the detector’s fabrication exhibiting high performance at room temperature based on quaternary compounds of AIIIBV materials for the short wavelength infrared range.

3 April 2025 in Sensors
Verified
Journal Article
Open access
PDF file
TMTetiana Manyk
Tetiana Manyk
JRJarosław Rutkowski
Jarosław Rutkowski
KKKrzysztof Klos
Krzysztof Klos
NGNathan Gajowski
Nathan Gajowski
SKSanjay Krishna
Sanjay Krishna
PMPiotr Martyniuk
Piotr Martyniuk
This paper presents a theoretical analysis of npBp infrared (IR) barrier avalanche photodiode (APD) performance operating at 300 K based on a quaternary compound made of AIIIBV—InGaAsSb, lattice-matched to the GaSb substrate with a p-type barrier made of a ternary compound AlGaSb. Impact ionization in the multiplication layer of InGaAsSb separate absorption, grading, charge, and multiplication avalanche photodiodes (SAGCM APDs) was studied using the Crosslight Software simulation package APSYS. The band structure of the avalanche detector and the electric field distribution for the multiplication and absorption layers were determined. The influence of the multiplication and charge layer parameters on the impact multiplication gain and the excess noise factor was analyzed. It has been shown that with the decrease in the charge layer doping level, the gain and the breakdown voltage increase, but the punch-through voltage decreases, and the linear range of the APD operating voltages widens. The multiplication layer doping level slightly affects the detector parameters, while increasing its width, the photocurrent and the breakdown voltage also increase. The detector structure proposed in this work allows us to obtain a comparable gain and lower dark currents to the APD detectors made of InGaAsSb previously presented in the literature. The performed simulations confirmed the possibility of obtaining APDs with high performance at room temperatures made of InGaAsSb for the SWIR range.

12 March 2026 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
JPJarosław Pawluczyk
Jarosław Pawluczyk
OŚOskar ŚlęZak
Oskar ŚlęZak
Krzysztof MurawskiKrzysztof Murawski
Krzysztof Murawski
KMKinga Majkowycz
Kinga Majkowycz
PBPiotr Baranowski
Piotr Baranowski
PMPiotr Martyniuk
Piotr Martyniuk
We report on the development of a passivation technology for InGaAsSb nBp photodiodes incorporating an AlGaSb barrier, aimed at achieving bulk-limited leakage currents and enhanced detectivity in detectors with a photosensitive area of 0.01mm2. Following passivation with SiO2 preceded by sulfidation, an increased yield of 113- $\mu $ m-diameter diodes exhibiting improved zero-bias resistance ( ${R}_{{0}}\text {)}$ was observed, particularly at lower temperatures reachable with thermoelectric coolers. At 215K, the dark current of devices of this size, with ${R}_{{0}}$ close to the average, was reduced by two orders of magnitude. At this temperature, the volume and surface generation rates of carriers were found to be equal for diodes with an average size of $150~\mu $ m. Furthermore, we investigated alternative approaches, including backside illumination through the GaSb substrate, the integration with immersion optics, and the use of ionic liquid (IL)-based passivation technique.

21 September 2026 in Applied Physics Letters
Verified
Journal Article
Open access
GGGrzegorz Edward Gomółka
Grzegorz Edward Gomółka
KKKrzysztof Klos
Krzysztof Klos
JPJarosław Pawluczyk
Jarosław Pawluczyk
MKMaciej Kowalczyk
Maciej Kowalczyk
PMPiotr Martyniuk
Piotr Martyniuk
ŁSŁukasz A. Sterczewski
Łukasz A. Sterczewski
The demand for fast mid-wave infrared photodetectors is fueled by high-rate free-space optical communication and optical frequency comb spectroscopy. To date, only a few multi-GHz photodetectors have shown sensitive room-temperature operation in the 3.0–3.7 μm band, yet their commercial availability remains scarce. In this work, we present the remarkable response speed of an InAs/InAsSbP p-Bp-i-n barrier detector based on a p-InAsSbP/n-InAs heterostructure—a technological platform typically not associated with high-frequency operation. A weakly reverse-biased photodiode with a diameter of 121 μm achieves a −3 dB electrical bandwidth of 2.4 GHz and −20 dB bandwidth of 8.0 GHz. This is the best result in this class of mid-infrared photodetectors confirmed optically. High signal-to-noise photodetection is also demonstrated at frequencies exceeding 19 GHz. The relatively simple device structure (devoid of cascaded structure or type-II superlattice) was realized on the mature InAs material platform, which opens new perspectives for accessible, sensitive, multi-GHz photodetectors for the 3.0–3.7 μm spectral region.

11 July 2022
Verified
Other
Closed access
KKKrzysztof Klos
Krzysztof Klos
MBMac Benedict
Mac Benedict
QDQuangang Du
Quangang Du
HYHairong Yuan
Hairong Yuan
HBHaijiao Bian
Haijiao Bian
KSKanakaraju Subramaniam
Kanakaraju Subramaniam