Boqi Xi

Prof. Boqi Xi


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 June 2020 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
ZXZeyuan Xu
Zeyuan Xu
BXBoqi Xi
Boqi Xi
GYGuoxing Yi
Guoxing Yi
DWDanwei Wang
Danwei Wang
This paper proposes a modeling method for fully closed-loop system of hemispherical resonator gyroscope (HRG) under force-to-rebalance mode. A fully closed-loop system consists of two parts: driving loop and detecting loop. First, dynamic equations of driving loop are derived to obtain vibration differential equations of a hemispherical resonator driven by electrostatic forces, further obtain accurate output models of wave amplitude and angular rate, which establishes a model of driving loop. Next, the output model of wave amplitude is analyzed to clarify the relationship between amplitude voltage and wave amplitude. Simultaneously, influences of interference factors on amplitude voltage and angular rate voltage are analyzed, which can result in the HRG output error. Then, a model of detecting capacitance is built based on deformation equations of the hemispherical resonator. A model of detecting loop is established to analyze its performance and precision. Finally, by tests of amplitude voltage and resonant frequency, accuracy of the models of driving loop and detecting loop is proved. A model of fully closed-loop system of the HRG is proposed based on the models of driving loop and detecting loop. The HRG output errors caused by resonator’s deformation, detecting error and nonuniformity of quality factor are identified and compensated accurately by the proposed model. It is verified by simulations and tests that the proposed model of fully closed-loop system is effective, which can not only identify the main errors of the HRG accurately, but also provide an accurate model for error analysis.

22 May 2023 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
YLYuanxi Li
Yuanxi Li
BXBoqi Xi
Boqi Xi
SRShun-qing Ren
Shun-qing Ren
CWChanghong Wang
Changhong Wang
In order to compensate for the hemispherical resonator gyroscope (HRG) dynamic output drift errors, a novel compensation method is presented. Through deriving the resonator motion equations and analyzing the mechanism of HRG dynamic output drift errors, it is found that the resonator defect nonuniformity is the main cause of the HRG dynamic output errors. By analyzing the mechanisms of these errors, the influence of these error sources is interacted and coupled, and it is difficult to analyze HRG output error mechanism and establish an error model comprehensively. We proposed a compensation prediction model for the HRG dynamic output to suppress the influence of these errors comprehensively. To establish the high precision HRG dynamic output compensation model, we proposed an improved variational mode decomposition (VMD) method to achieve an accurate HRG output. First, we used VMD to decompose the HRG output, and the optimal VMD decomposition parameters are achieved by genetic algorithm. In order to better achieve the effective information, the decomposed components of HRG drift are classified using the sample entropy. Then the mixed components are further processed using time frequency peak filtering. Finally, the accurate HRG output is achieved by reconstructing all the effective components. The accurate HRG output is used to construct the training set, and the high-precision HRG dynamic output prediction model is established by long short-term memory. The software compensation of the HRG dynamic output drift is realized by the prediction model. The experiment shows that the HRG dynamic output drift is mainly produced by the resonator nonuniformity, and it is strongly correlated with the standing wave azimuth, which verifies the correctness of the mechanism analysis. The HRG dynamic drift peak-peak value decreases to 5.715×10 -3 °/s, which verifies the effectiveness of the compensation method.

30 May 2025 in IEEE Sensors Journal
Verified
Journal Article
Closed access
WCWei Cheng
Wei Cheng
SRShun-qing Ren
Shun-qing Ren
BXBoqi Xi
Boqi Xi
JWJie Wang
Jie Wang
YNYouhuan Ning
Youhuan Ning
ZTZhen Tian
Zhen Tian
Hemispherical Resonator Gyroscope (HRG) represents a new type of inertial sensor. The vibrational properties of the hemispherical resonator, a core component of the HRG, significantly influence the output accuracy of the gyroscope. This paper is the first to integrate the effects of residual stress nonuniformity and mass nonuniformity in a unified model for hemispherical resonator. Firstly, the equation of motion for the resonator with these nonuniformities are derived based on the thin shell theory and the Lagrange equation. Then, two important vibration parameters, including the frequency split and the azimuth of stiffness axis, are calculated by a novel method based on the unified model. Next, the detailed simulations are conducted, which reveals that the frequency split is directly proportional to the fourth harmonic magnitude of mass or residual stress nonuniformity alone, with the azimuth of stiffness axis aligning with their initial phase (or differing by 22.5° for shear stress). However, under coupled nonuniformities, the frequency split depends nonlinearly on both fourth harmonics, while the azimuth of stiffness axis exhibits complex nonlinear behavior, with coupling strength critically influenced by their phase difference. Finally, based on the least squares method, an identification scheme for the error parameters associated with residual stress nonuniformity is designed. The experimental results show good consistency with the theoretical predictions, which confirms the correctness of the dynamic model and error analysis. This study addresses practical limitations of existing models and provides a theoretical foundation and experimental guidance for the optimization of the manufacturing processes of high-precision HRG.

15 January 2025 in Scientific Reports
Verified
Journal Article
Open access
PDF file
YNYouhuan Ning
Youhuan Ning
CWChanghong Wang
Changhong Wang
BXBoqi Xi
Boqi Xi
ZTZhen Tian
Zhen Tian
BZBoda Zhang
Boda Zhang
The phase-delay error of the circuit system is the primary source of the output error observed in the hemispherical resonator gyroscope (HRG). Additionally, the temperature-dependent nature of the phase-delay error results in a deterioration of the initial calibration parameters, which, in turn, significantly impairs the performance of the gyroscope in its intended application. This paper proposes a self-calibration method to effectively suppress the impact of phase-delay error on the application performance of gyroscopes. Firstly, based on the analysis of the influence of phase-delay error on the performance of the whole-angle mode HRG, a sinusoidal interference signal with a small amplitude is introduced into the quadrature control loop of the gyroscope. Then, the angular rate signal is demodulated and calculated to obtain the phase-delay error of the system, which is employed as the compensation value of the reference phase of the PLL to offset the phase-delay error of the circuit system in real-time. The experimental results demonstrate that after the phase-delay error is self-calibrated, the zero-bias output error of the gyroscope is reduced by 5 times, the bias instability is improved by 37.7%, and the self-calibration method of the phase-delay error presented is more strongly robust to temperature changes.

28 May 2025 in IEEE Sensors Journal
Verified
Journal Article
Closed access
YNYouhuan Ning
Youhuan Ning
CWChanghong Wang
Changhong Wang
BXBoqi Xi
Boqi Xi
ZTZhen Tian
Zhen Tian
BZBoda Zhang
Boda Zhang
WCWei Cheng
Wei Cheng
This paper studied the primary sources, evolution rules, and influence mechanisms of the damping anisotropy of the whole-angle hemispherical resonator gyroscope from the perspective of the fabrication process and analyzed the influence of temperature change on the damping anisotropy. An error identification and compensation method is proposed to suppress the effect of the damping anisotropy error on the gyroscope's bias error. According to the energy controller's output, this method involves applying the recursive least squares method to identify the damping anisotropy error and the damping axis angle in real time. Subsequently, a compensation signal is synthesized based on the identification results and applied to the angular rate control loop to compensate for the damping asymmetry error online. The experimental results show that the peak-to-peak value of the angular rate output harmonic error of the gyroscope is reduced from 0.023°/s to 0.005°/s after the error compensation, which is an improvement of about 5 times. In addition, the peak-to-peak value of the gyroscope angular dependent bias error decreases from 0.7072° to 0.08268°, which improves by 8.55 times, and the linearity of the angular measurements is also significantly improved. This methodology can be widely applied to gyroscopes operating in whole-angle mode, which is essential for fundamentally reducing the bias errors of the gyroscope induced by damping asymmetry.

24 April 2024 in Sensors
Verified
Journal Article
Open access
PDF file
WCWei Cheng
Wei Cheng
SRShun-qing Ren
Shun-qing Ren
BXBoqi Xi
Boqi Xi
ZTZhen Tian
Zhen Tian
YNYouhuan Ning
Youhuan Ning
YHYan Huo
Yan Huo
The properties of small size, low noise, high performance and no wear-out have made the hemispherical resonator gyroscope a good choice for high-value space missions. To enhance the precision of the hemispherical resonator gyroscope for use in tasks with large angular velocities and angular accelerations, this paper investigates the standing wave precession of a non-ideal hemispherical resonator under nonlinear high-intensity dynamic conditions. Based on the thin shell theory of elasticity, a dynamic model of a hemispherical resonator is established by using Lagrange’s second kind equation. Then, the dynamic model is equivalently transformed into a simple harmonic vibration model of a point mass in two-dimensional space, which is analyzed using a method of averaging that separates the slow variables from the fast variables. The results reveal that taking the nonlinear terms about the square of the angular velocity and the angular acceleration in the dynamic equation into account can weaken the influence of the 4th harmonic component of a mass defect on standing wave drift, and the extent of this weakening effect varies with the dimensions of the mass defects, which is very important for steering the development of the high-precision hemispherical resonator gyroscope.