Jente R. Wubs

Ms. Jente R. Wubs

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 June 2024 in IEEE Transactions on Terahertz Science and Technology
Verified
Journal Article
Open access
XLXiang Lü
Xiang Lü
BRBenjamin Röben
Benjamin Röben
VPValentino Pistore
Valentino Pistore
KBKlaus Biermann
Klaus Biermann
EIEsperanza Luna García De La Infanta
Esperanza Luna García De La Infanta
LSLutz Schrottke
Lutz Schrottke
We report on the development and the application of high-performance terahertz (THz) quantum-cascade lasers (QCLs) based on GaAs/Al $_{x}$ Ga $_{1-x}$ As heterostructures. These lasers with emission frequencies between 2.6 and 4.7 THz are based on a hybrid design, which is preferred for continuous-wave applications. For the design of the active regions, we employ an efficient Fourier-transform-based model which also allows for the simulation of heterostructures with gradual interfaces. Since the inherent interface width is on the same order as the thickness of the layers in the active region, the use of nominally binary AlAs barriers results in an effective Al content up to $x$ $=$ 0.6 for the tallest barriers. For practical applications, Fabry-Pérot lasers based on single-plasmon waveguides are fabricated. Single-mode operation is in most cases achieved by using short cavities. In particular, GaAs/AlAs THz QCLs show a sufficiently high wall plug efficiency so that they can be operated in miniature mechanical cryocoolers. Currently, high-performance THz QCLs are used for commercial continuous-wave, table-top THz systems, local oscillators in 3.5- and 4.7-THz heterodyne spectrometers, and absorption spectrometers for the determination of the density of atomic oxygen in plasmas.

1 February 2023 in Plasma Sources Science and Technology
Verified
Journal Article
Open access
PDF file
JWJente R. Wubs
Jente R. Wubs
UMUwe Macherius
Uwe Macherius
Klaus-Dieter WeltmannKlaus-Dieter Weltmann
Klaus-Dieter Weltmann
XLXiang Lü
Xiang Lü
BRBenjamin Röben
Benjamin Röben
JHJean-Pierre van Helden
Jean-Pierre van Helden
This paper describes the first implementation of terahertz (THz) quantum cascade lasers for high-resolution absorption spectroscopy on plasmas. Absolute densities of ground state atomic oxygen were directly obtained by using the fine structure transition at approximately 4.75 THz. Measurements were performed on a low-pressure capacitively coupled radio frequency oxygen discharge. The detection limit in this arrangement was found to be 2 × 10 13 cm−3, while the measurement accuracy was within 5%, as demonstrated by reference measurements of a well-defined ammonia transition. The results show that the presented method is well suited to measure atomic oxygen densities, and it closes the THz gap for quantitative atomic density measurements in harsh environments such as plasmas.

25 January 2023 in Semiconductor Science and Technology
Verified
Journal Article
Open access
PDF file
XLXiang Lü
Xiang Lü
BRBenjamin Röben
Benjamin Röben
KBKlaus Biermann
Klaus Biermann
JWJente R. Wubs
Jente R. Wubs
UMUwe Macherius
Uwe Macherius
HGHolger T Grahn
Holger T Grahn
We report on terahertz (THz) quantum-cascade lasers (QCLs) based on GaAs/AlAs heterostructures, which exhibit single-mode emission at 3.360, 3.921, and 4.745 THz. These frequencies are in close correspondence to fine-structure transitions of Al atoms, N+ ions, and O atoms, respectively. Due to the low electrical pump power of these THz QCLs, they can be operated in a mechanical cryocooler in continuous-wave mode, while a sufficient intrinsic tuning range of more than 5 GHz is maintained. The single-mode operation and the intrinsic tuning range of these THz QCLs allow for the application of these lasers as radiation sources for high-resolution absorption spectroscopy to determine the absolute densities of Al atoms, N+ ions, and O atoms in plasmas.

21 August 2023 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
JWJente R. Wubs
Jente R. Wubs
LIL. Invernizzi
L. Invernizzi
Kristaq GazeliKristaq Gazeli
Kristaq Gazeli
UMU. Macherius
U. Macherius
XLXiang Lü
Xiang Lü
JHJean-Pierre van Helden
Jean-Pierre van Helden
Terahertz (THz) absorption spectroscopy has recently been developed as a diagnostic technique for measuring absolute ground-state atomic oxygen densities in plasmas. To demonstrate the validity of this approach, we present in this Letter a benchmark against a more established method. Atomic oxygen densities were measured with THz absorption spectroscopy and compared to those obtained from picosecond (ps) two-photon absorption laser induced fluorescence (TALIF) measurements on the same capacitively coupled radio frequency oxygen discharge. Similar changes in the atomic oxygen density were observed with both diagnostics when varying the applied power (20–100 W) and the gas pressure (0.7–1.3 mbar). Quantitatively, the results are in good agreement as well, especially when considering the total margin of error of the two diagnostics. For example, for a gas pressure of 1.3 mbar and an applied power of 30 W, atomic oxygen densities measured with THz absorption spectroscopy and TALIF were (7.0 ± 1.7)×1014 cm−3 and (5.3 ± 3.2)×1014 cm−3, respectively. This shows that THz absorption spectroscopy is an accurate technique that can be reliably used for real-world applications to determine atomic oxygen densities in plasmas.

4 December 2023 in Journal of Physics D: Applied Physics
Verified
Journal Article
Open access
PDF file
OROlivier van Rooij
Olivier van Rooij
JWJente R. Wubs
Jente R. Wubs
HHHans Höft
Hans Höft
Ana SobotaAna Sobota
Ana Sobota
The interaction of an ambient air plasma with a water surface in a pin–water electrode configuration is presented in a polydiagnostic study. A discharge was generated by applying different high-voltage (HV) waveforms to a metallic pin electrode, positioned 2 mm above the water surface of a Petri dish filled with demineralized water. For pulsed discharge operation, a clear distinction is observed between a dielectric barrier discharge regime featuring a transient discharge at the rising as well as at the falling slope of the HV pulse, while a steady discharge is present in the gap during the complete HV pulse for the electrolysis regime. The occurrence of those two regimes is coupled to the increasing conductivity of the water over time, which additionally results in a quick rise of the dissipated discharge power and an increase of the gas temperature. The AC driven discharges exhibit only the electrolysis regime and do not significantly evolve over the treatment time. The resulting water conductivity was found to be a function of the total dissipated energy, irrespective of the discharge driving mode. Additionally, the resulting water conductivity shows a strong correlation with the total transferred charge in the gas phase. The total dissipated energy can potentially be used as a global measure to compare different experiments involving plasma–water interaction across different setups in different research groups.

18 March 2024 in Journal of Physics D: Applied Physics
Verified
Journal Article
Open access
JPJ Petković
J Petković
RWR van de Wege
R van de Wege
JWJente R. Wubs
Jente R. Wubs
ORO J A P van Rooij
O J A P van Rooij
JOJ J van Oorschot
J J van Oorschot
Ana SobotaAna Sobota
Ana Sobota
To assess the species in plasma-treated water, two methods were compared: calibrated absorption spectroscopy and a method using pH and conductivity to determine the amount of dominant reactive species in the water. A function fitting method was developed for the analysis of the absorption spectra based on solutions with known concentrations. The influence of plasma treatment time on demineralized water and the NO x − concentration was studied using the two methods; the results in both cases show an almost linear growth with time. The method, utilizing pH and conductivity, shows consistent results with those achieved using UV absorption spectroscopy in considerably less time and in a more cost-efficient manner.