Zhaoheng Yan

Dr. Zhaoheng Yan

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 August 2023 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
ZYZhaoheng Yan
Zhaoheng Yan
SYSong Yuan
Song Yuan
XJXi Jiang
Xi Jiang
CDChaofan Deng
Chaofan Deng
ZPZhenjiang Pang
Zhenjiang Pang
YHYue Hao
Yue Hao
This article presents a temperature sensor based on a partial p-GaN cap layer and a semicircular T-anode AlGaN/gallium nitride (GaN) Schottky barrier diode (PCT-SBD). The PCT-SBD uses a p-GaN layer and a semicircular T-anode to enlarge and adjust the position of the subthreshold region. This structure enabled better integration with AlGaN/GaN high-electron-mobility transistors (HEMTs) and improved the measurement accuracy of heterojunction temperature. The PCT-SBD temperature sensor exhibited great temperature sensitivity, reaching a maximum of 2.54 mV/K under 2.04 A/cm $^\text{2}$ in the subthreshold region, which is approximately twice the temperature sensitivity of a regular GaN Schottky barrier diode (SBD) temperature sensor. Moreover, the device maintained good linearity, low turn-on voltage, and low reverse leakage current. The AlGaN/GaN PCT-SBD shows good potential in integrating with GaN-based power devices for temperature sensor applications.

3 October 2023 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
XJXi Jiang
Xi Jiang
TJTao Jiang
Tao Jiang
SZShijie Zhang
Shijie Zhang
SYSong Yuan
Song Yuan
ZYZhaoheng Yan
Zhaoheng Yan
WJWang Jun
Wang Jun
This article studies the short-circuit (SC) failure modes and mechanism of ohmic-gate GaN high electron mobility transistors (HEMTs) through experimental evaluation and numerical investigation. Two distinct SC failure modes of ohmic-gate GaN HEMT have been identified: gate–source SC failure and rapid thermal runaway failure. The SC capability and failure mode of ohmic-gate GaN HEMT are significantly influenced by both the dc bus voltage and gate injection current. Thermal–mechanical simulation and failure analysis techniques are used to identify two SC failure mechanisms: thermal–mechanical stress-induced structural failure and thermal breakdown of the gate GaN/AlGaN heterostructure. The gate injection current is found to be a crucial factor in improving the SC ruggedness of ohmic-gate GaN HEMT under high bus voltage SC conditions.

28 February 2025 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
XJXi Jiang
Xi Jiang
YWYue Wu
Yue Wu
SYSong Yuan
Song Yuan
Xiangdong LiXiangdong Li
Xiangdong Li
ZYZhaoheng Yan
Zhaoheng Yan
WJWang Jun
Wang Jun
Gallium nitride (GaN) high electron mobility transistor (HEMT) devices are prone to rapid failure after repetitive short-circuit (SC) stress under high bus voltage conditions. The dislocation defects at the substrate interface play a critical role in inducing device degradation and thermal breakdown failure. However, the mechanisms of dislocation defect formation under SC stress and their influence on the SC capability of GaN HEMTs remain unclear. This article presents a novel method based on transient thermal resistance characterization to monitor the evolution of dislocation defects within GaN HEMT devices. Meanwhile, a thermal model is developed to illustrate the influence of dislocation defects on the thermal characteristics of the device. By analyzing the structure function of the GaN HEMT before and after SC stress, the accumulation of previously imperceptible defects is translated into observable changes in thermal resistance curves. The degradation of thermal characteristics of GaN HEMT devices under varying bus voltages and SC pulse durations are investigated. Experimental results demonstrate that the transient thermal characterization method effectively identifies regions of dislocation defect accumulation, quantifies the extent of defect accumulation, and provides a comprehensive understanding of damage evolution within GaN HEMTs under repetitive SC stress.

31 October 2024 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
QLQifan Liu
Qifan Liu
XJXi Jiang
Xi Jiang
XGXiaowu Gong
Xiaowu Gong
SYSong Yuan
Song Yuan
LYLinsen Yang
Linsen Yang
ZYZhaoheng Yan
Zhaoheng Yan
Lower power consumption is a primary concern in the design and development of the flyback converter. However, the power consumption of the flyback converter during light loads has not been extensively explored in existing literature. Given the rapid deployment of flyback converters, it is necessary to develop a new technique of reducing power consumption for the flyback converter under light load conditions. This letter introduces a novel power loss reduction approach for flyback converter with average power reduction strategy. A controller IC is fabricated with TSMC 0.5-μm bipolar-CMOS-DMOS (BCD) mixed-signal process. And verified by a prototype experimental test board of 15 W/15 V.

28 January 2025 in IEEE Sensors Journal
Verified
Journal Article
Closed access
ZYZhaoheng Yan
Zhaoheng Yan
XJXi Jiang
Xi Jiang
Xiangdong LiXiangdong Li
Xiangdong Li
CDChaofan Deng
Chaofan Deng
YLYanzuo Li
Yanzuo Li
XGXiaowu Gong
Xiaowu Gong
In this study, a partial p-GaN cap layer and T-anode GaN SBD temperature sensor with TiN as Schottky contact (TiN-PCT-SBD) is demonstrated to mitigate the impact of nitrogen vacancies in the AlGaN layer on the temperature characteristics of GaN lateral integrated temperature sensor. The TiN anode significantly reduces the trap density associated with nitrogen vacancies in the AlGaN layer, DT=3.05~3.44×1012cm−2eV−1, and ET = 0.303~0.410 eV, thereby enhancing temperature characteristics and broadening the sub-threshold range. The TiN-PCT-SBD temperature sensor achieves an increased temperature sensitivity of 3.72 mV/K over a wide operational range from 298 K to 473 K, compared to 2.67 mV/K for Ti-PCT-SBD. Furthermore, TiN-PCT-SBD maintains high sensitivity while exhibiting excellent linearity with R2 = 0.9997, whereas Ti-PCT-SBD demonstrates a linearity of only 0.997.

1 August 2025 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
XJXi Jiang
Xi Jiang
JCJing Chen
Jing Chen
CPChaofan Pan
Chaofan Pan
HNHao Niu
Hao Niu
SYSong Yuan
Song Yuan
WJWang Jun
Wang Jun
This article investigates the failure mechanisms of the gallium nitride high electron mobility transistors (GaN HEMTs) under overcurrent stress. The overcurrent behavior of GaN hybrid drain-embedded gate injection transistor (HD-GIT) devices was evaluated under different stress conditions, and the primary failure modes were identified. The waveforms of the GaN devices during overcurrent events were analyzed in stages, and the physical mechanisms underlying each stage were analyzed. Numerical technology computer-aided design (TCAD) simulations were conducted to analyze the electric field distribution and the variations in electron mobility during overcurrent stress. Both thermal runaway and drain/substrate breakdown failures were investigated through simulation analysis. The results indicate that thermal runaway failure in GaN HEMTs occurs due to the accumulation of thermal stresses in the access region, which is triggered by the reduction in electron mobility and an increase in the electric field within the channel. The drain and substrate breakdown failure are mainly caused by the high vertical electric field between the drain and substrate due to hole injection from the drain p-GaN region. Furthermore, the failure mechanisms were validated through experimental tests.