This study intends to examine the impact of successive wetting and drying cycles on the strength and hydraulic conductivity of lime- and cement-treated soil, with a special emphasis on the protocol that is employed to impose the cycles. Compacted specimens were cured for 90 days before being exposed to different numbers of wetting and drying cycles. These cycles were imposed on treated samples with two protocols, the first one based on oven drying and full saturation, and the second based on control of the relative humidity of the samples at room temperature to thus obtain more realistic conditions for the wetting and drying cycles. The unconfined compressive strength and saturated hydraulic conductivity were monitored as a function of the number of cycles. The results highlight the role of the imposed wetting and drying cycle technique for a better assessment of the long-term performances of treated soils. Special attention was also taken to evaluate the relationship between the alteration of hydraulic conductivity and mechanical strength as a function of the number of applied wetting and drying cycles. The results showed that the degradation of the strength of the treated samples is associated with a significant increase of their hydraulic conductivity as a function of the number of cycles.
Soil thermal properties are needed in specific engineering applications, such as the design of high-level radioactive waste disposal, buried power transmission cables and geothermal systems. The propagation of the heat flow in a soil exposed to a temperature gradient is based on three main soil thermal properties: the thermal conductivity (λ), the thermal capacity (C) and the thermal diffusivity (α = λ/C). The temperature variations affect the physical properties of soil, inducing changes in its thermal properties. In this study, the evolution of thermal properties of different compacted soils exposed to cyclic temperature variations were investigated through laboratory tests. The results showed that at 20 °C, the thermal conductivity of the compacted soils increased on the dry side of the compaction curve until it reached a maximum near the optimum water content. Variation of λ in a temperature range of 1–20 °C was not shown, but a slight increase of λ was measured in the range of 20–40 °C, which was clearly confirmed in the range of 40–70 °C. The application of cyclic temperature variations to the samples showed partially reversible evolution of thermal conductivity and totally reversible evolution of volumetric heat capacity.
Artificial ground freezing (AGF) has emerged as a prominent treatment method due to its ability to mechanically strengthen the soil while reducing its permeability. However, its implementation has raised concerns about its impact, particularly with respect to frost heave and subsequent thaw-induced displacements. These soil movements can cause subsidence and pose a significant threat to the integrity of surface structures. Overburden pressure plays a crucial role in AGF and determines the amount of heave generated. This paper presents an analysis of the existing literature about soil freezing and thawing. The aim is to offer an understanding of these processes, specifically with regard to their application in AGF. This paper explains the behavior of soil during freezing, with particular emphasis on the influence of overburden pressure. It also investigates frozen soils’ thawing and freeze–thaw (FT) cycles’ long-term effects on soil properties. AGF offers improved soil strength and reduced water permeability, enhancing construction project stability. However, the interplay between the temperature, soil composition, and initial ground conditions during freezing is complex. This thermo-hydro-chemo-mechanical process strengthens the soil and reduces its permeability, but it can also induce frost heave due to water expansion and ice lens formation. Overburden pressure from the overlying soil limits ice lens growth. FT cycles significantly impact soil properties. In fine-grained soils, FT cycles can lead to over-consolidation, while rapid thawing can generate high pore pressures and compromise stability. Importantly, FT acts as a weathering mechanism, influencing soil properties at both the microscopic and macroscopic scales. These cycles can loosen over-consolidated soil, densify normally consolidated soil, and increase overall hydraulic conductivity due to structural changes. They can also weaken the soil’s structure and deteriorate its mechanical performance.
This paper assesses the performance of an embankment constructed in 2010 with a stabilised expansive soil. Two types of treatment were employed at construction time: 4% lime and a mix of 2% lime and 3% cement. A sampling campaign was carried out in 2021 to evaluate the long-term performance of the stabilised soil properties. To assess the compressibility of the soil, oedometer tests were carried out on samples from different parts of the embankment. The results were compared to the compression curve of the untreated soil, also sampled in the same embankment. Complementary shrinkage tests were performed to investigate the effect of the treatment on swelling and shrinkage. The obtained results show that the yield stress of the material from the outer part was inferior to 100 kPa, similarly to the yield stress of the untreated soil, demonstrating a strong alteration in the effect of both treatments over time. This alteration was noticeable to a distance of approximately 2 m from the external surface. Beyond this distance, the performance of the soil was comparable to the behaviour of recently treated soil, with yield stresses close to 1000 kPa. These observations, similar for each treatment dosage, raise questions as to the durability of the treatment on the outer part of the backfill.