The article presents the results of numerical simulations and experimental tests of plastic forming sheets made from the difficult-to-deform nickel alloy Inconel 718 with a thickness of 1 mm, using punches made from elastomeric materials with hardness 50–90 Shore A and steel dies. Elastomeric stamps were created in the form of five layers with a diameter of 160 mm. The influence of the hardness of the elastomeric punches on the geometry of the elements obtained was determined. The dies were made from 90MnCrV8 steel with a hardness of over 60 HRC. Their task was to obtain the expected shape of the element while generating various stress states in specific areas of the semi-finished product. The research was carried out using an original device whose operating principle was based on the Guerin method. The shape and dimensions of the elements made from Inconel 718 nickel alloy were determined by optical 3D scanning. The geometry of the drawpiece showed a significant impact of the hardness of the layered elastomer matrices on the degree of shape reproduction. The results obtained from numerical modeling were confirmed by the results of experimental tests. It has been shown that the hardness of the elastomeric material used for punches for plastic forming Inconel 718 nickel alloy sheets should be adapted to the shape of the drawpiece. It was also found that one of the important aspects of plastic forming sheets using the Guerin method is the tendency to obtain a diversified shape of the final elements.
The MM Science Journal, published since 2008, is a world respected scientific journal. The journal, published in English, is double peer reviewed and competitive in distributing knowledge among domestic and international academics and professionals. Full texts are available on-line on the journal...
Explosive welding technology is crucial for the production of large-area plates composed of materials with varying plastic and physical properties. Severe plastic deformation processes increase the mechanical strength of the plates by refining grains and increasing dislocation density. The aim of the research presented in this paper was to analyze the effect of Equal Channel Angular Pressing (ECAP) on the mechanical properties and microstructure of an Al/Cu (EN AW-1050/Cu-ETP) bimetallic plate produced by the explosive welding technology. The ECAP process was carried out at room temperature. The ECAP experiments consisted of 1–3 passes using a die with a channel angle of 90°. The ram speed was 40 mm/min. The study also considered various sample cutting orientations (longitudinal, transverse) and various positions of the bimetallic sample in the die entry channel. Rotating the sample by an angle of 180° between consecutive passes was also considered. To achieve the research objective, static tensile tests, Vickers hardness tests at a load of 4.9 N, and microstructural analysis of the samples using scanning electron microscopy and energy dispersive spectroscopy were carried out. It was found that each subsequent pass in the ECAP process led to a gradual, severe change in the morphology of the Al/Cu interfacial transition layer. The orientation of the cutting plane of the samples was shown to have no effect on the hardness of the bimetallic material. Vickers hardness tests preceded by the ECAP process revealed a more uniform hardness distribution compared to the base material. The orientation of the Al/Cu plate layers in the ECAP die channel clearly influenced the character of the hardness distribution.
This paper presents a continuous severe plastic deformation (SPD) process for sheet metal called Dual Rolls Equal Channel Extrusion (DRECE) is introduced. The DRECE process achieves maximum sheet metal deformation by combining bending deformation with channel-angular shear deformation. The evolution of the microstructure and mechanical properties of the CuZn37 alloy has been experimentally investigated as a function of the number of repeated DRECE passes. The DRECE process was repeated up to four times at room temperature. As the number of passes increased, the character of the microstructure was gradually strongly deformed by intensive shear deformation. The microhardness and tensile properties changed significantly as a function of the number of repeated passes.