Chiplet-based packaging technology integrates multiple heterogeneous dies with different functions and materials into a single system as a LEGO-based approach using advanced packaging technology. However, it also brings new challenges in the thermal design aspect and thermal crosstalk between chiplets. In this article, the thermal modeling of a chiplet-based packaging with a 2.5-D interposer was carried out. Two chiplets were mounted on the interposer side-by-side. A Cu lid was attached to the top surfaces of the chiplets and periphery of the interposer through the thermal interface material1 (TIM1) and adhesive, respectively. To further dissipate the heat from the top side, a heat sink was attached to the top surface of the lid through a layer of TIM2. The effects of the TIM type, bonding approach between chiplets and interposer, heat sink structure, thermal crosstalk, convective heat transfer coefficient above the lid, and thermal design power (TDP) were analyzed. The study results show that the bumpless interconnect is beneficial for the heat dissipation of the chiplet-based packaging. The staggered column fin can exhibit superior cooling performance. The short pitch would bring cooling challenges for fine-pitch multiple chiplets integration. The temperature is decreased rapidly first and then slowed down with the increase of convective heat transfer coefficient above the lid. Under 10 000 W/ $\text{m}^{2}\cdot \text{K}$ , the maximum TDP was about 250 W.
With the development of artificial intelligence (AI) and high-performance computing (HPC), the microelectronic industry is challenged with increased device integration density. Chiplet architecture can break through a variety of limitations on the system-on-chip (SoC) to create a high-computility system. However, chiplet heterogeneous integration suffers from high heat flux and serious thermal interaction problems. The factors affecting thermal interaction are not clear. In this paper, a collective parameter model and a distribution parameter model are developed to clarify the optimization method to mitigate thermal interaction. The trends predicted by the parameter model are consistent with the finite element method (FEM) simulation results. Furthermore, to cool the chiplets, a thermal test vehicle is designed and fabricated, and the cooling performance of the test vehicle with different flow rates, different TIMs (Thermal Interfacial Materials) (DOW5888 vs. liquid metal), and different heat modes is experimentally investigated. Compared with DOW5888, the utilization of liquid metal TIM can mitigate thermal interaction by 56% and 76% at flow rates of 0.2 L/min and 0.8 L/min, respectively. Consequently, at a temperature rise of 60 °C and a flow rate of 0.8 L/min, using liquid metal TIM can achieve heat fluxes of 330 W/cm2 and 520 W/cm2 for two chiplets, respectively.