Rare-earth iron garnets (REIGs) are the benchmark systems for magnonics, including the longitudinal spin Seebeck effect (LSSE). While most research has focused on single-crystalline REIGs on complimentary garnet substrates, moving to more, cost-effective complementary metal-oxide semiconductor (CMOS)-compatible substrates is important to integrate REIG thin films with existing technology. In this regard, we grow a 130 nm-thick polycrystalline gadolinium iron garnet (GdIG) film on the Si/SiO2 substrate and investigate the temperature-dependent LSSE. Interestingly, the polycrystalline GdIG film exhibits perpendicular magnetic anisotropy (PMA) at room temperature which is induced by tensile in-plane (IP)-strain originating from the thermal-expansion mismatch between the GdIG film and the substrate during rapid thermal annealing. Further, a spin-reorientation transition from the out-of-plane IP direction below TS = 180 K is observed. Additionally, the film reveals a magnetic compensation temperature, TComp, of ≈240 K. The LSSE voltage not only demonstrates a sign-inversion around TComp, but also shows noticeable changes around TS. As compared to a single-crystalline GdIG film, the lower LSSE voltage for the polycrystalline GdIG is attributed to the higher effective magnetic anisotropy and enhanced magnon scattering at the grain boundaries. Our study not only paves the way for the cost-effective growth of CMOS-compatible REIG-based systems with PMA for magnonic memory and information processing applications, but also highlights the fact that the spincaloritronic and spin-insulatronic properties of the polycrystalline REIGs follow those of their single-crystalline counterparts with reduced spin-to-charge conversion efficiency through LSSE which can be tuned further by controlling the average gran size and interface engineering.
In the fabrication of optical polymer-based components, such as diffractive gratings and waveguides, high throughput and high precision are required. The non-destructive evaluation of these complex polymer-based structures is a significant challenge. Different measurement techniques can measure the structure geometry directly or via its functionality indirectly. This study investigates various measurement techniques aimed at assessing these structures from 200 nm up to 20 µm. Environmental scanning electron microscopy (ESEM), white light interferometry (WLI), atomic force microscopy (AFM), micro computed tomography (µCT), optical coherence tomography (OCT), phase contrast microscopy (PCM), and Mueller matrix ellipsometry (MME) are investigated for their practical limits of lateral resolution and aspect ratio. The impact of the specimens’ complexity factors, including structure width and aspect ratio, on measurement quality is discussed. A particular focus of this study is on the suitability of different measurement systems for evaluating undercuts and enclosed structures while considering structure size, slant angle, and cover thickness. The aim is to discuss the specific advantages of the individual measurement systems and their application areas in order to be able to quickly select suitable measurement systems for a non-destructive evaluation of polymer-based micro and nanostructures.