The torque transmission capacity of frictional connections, commonly used in wind turbine drive trains, is heavily influenced by the coefficient of friction between contacting surfaces. To improve performance, friction-enhancing techniques like hard particle systems and coatings are employed to increase the coefficient of friction. Hard particles enhance deformative friction through embedding and micro-interlocking with the base material. Despite efforts to minimize them, dynamic loads can still result in micro-slip movements that alter the frictional behavior of the joint. This research investigates the effects of alternating loads, below the sliding limit, on the embedding process of diamond particles. Through simulations using an elasto-plastic finite element (FE) model, the study compares slip amplitude and transmittable torque under dynamic loading conditions with reference pairings and quasi-static torsion tests. Findings reveal that dynamic pre-loading significantly influences frictional characteristics, boosting torque transmission. The micro-slip motion observed in FE simulations highlights how the embedding process of hard particles during dynamic loading leads to increased frictional resistance, with a clear correlation between particle indentation depth and the resulting frictional slip behavior.
A well-known phenomenon in machinery systems is the easing of a blocked connection of mechanical parts after an impact hit close to the connection. Such impact hits may also arise in shaft–hub connections such as gears, crankshafts, or other parts. The objective of this study is to investigate the influence of local impact loads on the transmittable torque of smooth shaft–hub connections. In a specially designed test rig, it was demonstrated that the transmittable torque of the shaft–hub connection is reduced as a consequence of the impact, resulting in a reduction in the frictional force and slippage of the hub. Increasing the impact load leads to an increase in the reduction in the frictional force as well as the slippage and reduces the transmittable torque. By carrying out a modal analysis of the relevant parts and FE simulations of the impact, two possible reasons have been identified: (i) the impact load excites a vibration mode in the connection which reduces the frictional force and the transmittable torque; and (ii) the impact causes local deformation of the shaft, which results in local slip.
28 February 2021 in Journal of Mining and Earth Sciences
Classification of built-up land and bare land on remote sensing images is a very difficult problem due to the complexity of the urban land cover. Several urban indices have been proposed to improve the accuracy in classifying urban land use/land cover from optical satellite imagery. This paper presents an development of the EBBI (Enhanced Built-up and Bareness Index) index based on the combination of Landsat 8 and Sentinel 2 multi-resolution satellite imagery. Near infrared band (band 8a), short wave infrared band (band 11) of Sentinel 2 MSI image and thermal infrared band (band 10) Landsat 8 image were used to calculate EBBI index. The results obtained show that the combination of Landsat 8 and Sentinel 2 satellite images improves the spatial resolution of EBBI index image, thereby improving the accuracy of classification of bare land and built-up land by about 5% compared with the case using only Landsat 8 images.
Aufgrund ökonomischer Forderung und dem Trend zum Leichtbau werden Lagergehäusen und Anschlusskonstruktionen zunehmend dünnwandiger gestaltet. Die damit einhergehenden Verformungen begünstigen die Relativbewegungen zwischen Gehäuse/Welle. Die vorliegende Arbeit untersucht mittels FE-Simulation die Schlupfzustände in der Fuge die aus den Verformungen des dünnwandigen Gehäuses und Anschlusskonstruktionen resultieren.