A monolithically integrated receiver consisting of a low-capacitance PIN photodiode and a photo-charge integrating amplifier in 0.18-μm CMOS is introduced launching a new class of ultra-sensitive optical receivers. The integrated PIN photodiode has a junction capacitance of 1.5 fF at a light-sensitive diameter of 30 μm, a responsivity of 0.39 A/W at 635 nm, and rise/fall times of 0.73/0.92 ns at a reverse bias of 20 V. The common-source amplifier integrates the photo-charges on the smallest possible integration capacitor, which is a gate-drain overlap capacitance. The data bits are reconstructed by double sampling. In such a way, the sensitivity of SPAD receivers is achieved, however without using any impact ionization. At 50 Mb/s, a sensitivity of -56.4 dBm for a bit error ratio (BER) of 2×10 -3 is obtained using a wavelength of 635 nm.
We present an avalanche photodiode (APD) with separate absorption and multiplication zone. The APD is fabricated in a 0.35-μm CMOS process using an epitaxial wafer. Due to its thick detection zone, this concept offers a high dynamic quantum efficiency and thus a high resulting dynamic responsivity. Measurements using a 670-nm laser source demonstrate a maximum responsivity of 1.8· 10 4 A/W at 5 nW and a maximum bandwidth of 1.02 GHz at 5-μW illumination power. A maximum responsivity bandwidth product of 269.7 GHz· A/W was found at 35 V reverse bias voltage and 5-nW optical power.
Spot PIN photodiodes were integrated without any process modifications in a high-voltage 0.18 μm CMOS technology. These photodiodes are a combination of vertical and lateral PIN photodiodes using the P+ bulk wafer and a P-type ring at the surface as anodes. Devices with N+ cathode and N+/N-well cathode are compared. A small N+/N-well cathode spot reduces the capacitance to 1.47 fF and the N+ cathode spot leads to a capacitance of 1.07 fF. The light sensitive area of these photodiodes is 707 μm 2 . Simulated electric field distributions show the full depletion of the spot PIN photodiodes. Responsivities from 0.12 A/W to 0.16 A/W and from 0.50 A/W to 0.52 A/W for 405 nm and 675 nm, respectively, are achieved. The measured bandwidths for 675 nm light are from 520 MHz to 690 MHz at reverse biases from 15 V to 30 V.
An analytical approach to model and analysis of the bit-error ratio performance in multi-SPAD optical receivers is presented. The model covers all important non-ideality effects including the detector dead time, the optical signal profile, and the SPAD intrinsic parasitics. This is very helpful to understand the bottlenecks that limit the performance and, therefore, is critical to attempt further improvements. A good agreement to the experimental data is achieved and it is found that the corsstalk makes the major contribution to the BER as compared to the other parasitic effects including dark-counts and afterpulsing.
This paper presents a CMOS-integrated dot avalanche photodiode (dot-APD) that features a small central n+/p-well hemispherical cathode/p-well structure circularly surrounded by an anode ring. The dot-APD enables wide hemispherical depletion, charge collection from a large volume, and a small multiplication region. These features result in a large light-sensitive area, high responsivity and bandwidth, and exceptionally low junction capacitance. The active area can be further expanded using a multi-dot structure, which is an array of several cathode/p-well dots with a shared anode. Experimental results show that a 5 × 5 multi-dot APD with an active area of 70 μm × 70 μm achieves a bandwidth of 1.8 GHz, a responsivity of 9.7 A/W, and a capacitance of 27 fF. The structure of the multi-dot APD allows for the design of APDs in various sizes that offer high bandwidth and responsivity as an optical detector for various applications while still maintaining a small capacitance.
A highly sensitive avalanche photodiode (APD) in 0.35 μm CMOS technology is presented. Due to a thick intrinsic absorption layer, a high responsivity at a low bias voltage, where the avalanche gain is 1, is combined with an excellent avalanche gain at high voltages to achieve a maximum overall responsivity of the APD of more than . This responsivity exceeds that of other submicrometer CMOS APDs by a factor of more than 700. As a figure of merit the responsivity–bandwidth product is defined, and the achieved value of is 2.4 times higher than the values found in the literature.