A fully integrated 0.35-μm CMOS optical data receiver with a 50-μm diameter single-photon avalanche-diode and a cascoded gating circuit enabling a maximum excess bias voltage of 6.6 V (to obtain a high photon detection efficiency) is presented. To optimize the sensitivity in presence of dark counts and after-pulsing a decision threshold of 2-5 photon counts can be selected. For red light (635 nm) and nonreturn-to-zero modulation the sensitivity is -64 dBm for 20 Mb/s with 100 MHz clock frequency and -57 dBm for 50 Mb/s with 250 MHz.
24 September 2018 in Journal of Lightwave Technology
This paper reports the performances of a silicon photonics optical switch matrix fabricated by using large scale 3D integration. The wavelength selective optical switch consists of a photonic integrated circuit (PIC), with 1398 circuit elements, interconnected in a 3D stack with its control electronic integrated circuit (EIC). Each PIC element can be trimmed or reconfigured by using metallic heaters. The EIC is designed to drive the heaters and to read the signal of monitor photodiodes integrated into the PIC. Small footprint and high energy efficiency are achieved in the PIC and the EIC. Automatic wavelength alignment of the optical circuits in the PIC to the ITU grid and fine temperature tuning of each photonic element to optimize the switch insertion losses are obtained by an optimization routine. A fully packaged switch with input/output fibers is tested both for optical and electrical characteristics as well as for the system performances. Fiber to fiber insertion losses of about 20 dB and channel isolation of -35 dB are achieved. BER characteristics at 25 Gbps are evaluated. Perspective applications of the optical switch in optical transport and intra-data center networks are discussed.
A monolithically integrated receiver consisting of a low-capacitance PIN photodiode and a photo-charge integrating amplifier in 0.18-μm CMOS is introduced launching a new class of ultra-sensitive optical receivers. The integrated PIN photodiode has a junction capacitance of 1.5 fF at a light-sensitive diameter of 30 μm, a responsivity of 0.39 A/W at 635 nm, and rise/fall times of 0.73/0.92 ns at a reverse bias of 20 V. The common-source amplifier integrates the photo-charges on the smallest possible integration capacitor, which is a gate-drain overlap capacitance. The data bits are reconstructed by double sampling. In such a way, the sensitivity of SPAD receivers is achieved, however without using any impact ionization. At 50 Mb/s, a sensitivity of -56.4 dBm for a bit error ratio (BER) of 2×10 -3 is obtained using a wavelength of 635 nm.
Spot PIN photodiodes were integrated without any process modifications in a high-voltage 0.18 μm CMOS technology. These photodiodes are a combination of vertical and lateral PIN photodiodes using the P+ bulk wafer and a P-type ring at the surface as anodes. Devices with N+ cathode and N+/N-well cathode are compared. A small N+/N-well cathode spot reduces the capacitance to 1.47 fF and the N+ cathode spot leads to a capacitance of 1.07 fF. The light sensitive area of these photodiodes is 707 μm 2 . Simulated electric field distributions show the full depletion of the spot PIN photodiodes. Responsivities from 0.12 A/W to 0.16 A/W and from 0.50 A/W to 0.52 A/W for 405 nm and 675 nm, respectively, are achieved. The measured bandwidths for 675 nm light are from 520 MHz to 690 MHz at reverse biases from 15 V to 30 V.
14 December 2023 in Journal of Lightwave Technology
The integration of quantum functionalities in photonic integrated circuits (PICs) is attracting intense research efforts nowadays. Many solutions have been proposed for generation, processing and detection of single photons in such quantum PICs. A significant breakthrough would be the monolithic integration of all the three functionalities in a compact, CMOS compatible silicon chip. In this paper we present a solution to integrate monolithically photonic architectures with photon detectors on the same chip. In our device, the light (850 nm photons) propagates within a SiON waveguide, integrated on top of a silicon chip where we realized the single photon avalanche diodes (SPADs). The light is coupled from the waveguide to the detector with a novel and efficient top-down evanescent-transfer approach. The proposed solution for a monolithic integration is fully CMOS compatible. In this contribution, we characterized the performance of the photonic integrated chip, containing several waveguides coupled to SPADs. We detail the functional performance of the fabricated SPADs, as well as the system performance when the injected photons are manipulated and detected within the same chip.
This paper presents a CMOS-integrated dot avalanche photodiode (dot-APD) that features a small central n+/p-well hemispherical cathode/p-well structure circularly surrounded by an anode ring. The dot-APD enables wide hemispherical depletion, charge collection from a large volume, and a small multiplication region. These features result in a large light-sensitive area, high responsivity and bandwidth, and exceptionally low junction capacitance. The active area can be further expanded using a multi-dot structure, which is an array of several cathode/p-well dots with a shared anode. Experimental results show that a 5 × 5 multi-dot APD with an active area of 70 μm × 70 μm achieves a bandwidth of 1.8 GHz, a responsivity of 9.7 A/W, and a capacitance of 27 fF. The structure of the multi-dot APD allows for the design of APDs in various sizes that offer high bandwidth and responsivity as an optical detector for various applications while still maintaining a small capacitance.