An active shield using a scintillator and silicon photo-multipliers (SiPMs) has been developed to operate with space environment particle detectors sensitive to both protons and electrons, such as ICARE-NG (Influence sur les Composants Avancés des Radiations de l’Espace-Nouvelle Génération). The method shows a reduction in electron contamination through the sides of the detector, thus increasing energy resolution. Two geometries are studied, one working in coincidence mode with the main detector, the other in anti-coincidence. Performances of both geometries are simulated in proton and electron environments in energy ranges typical of a space environment. Experimental measurements then aimed to validate the Monte-Carlo simulation framework for scintillating materials. Lastly, a case study of electron decontamination is carried out, as well as an error rate estimation in flux reconstruction.
COMCUBE-S (Compton Telescope CubeSat Swarm) is a proposed mission aimed at understanding the radiation mechanisms of ultra-relativistic jets from Gamma-Ray Bursts (GRBs). It consists of a swarm of 16U CubeSats carrying a state-of-the-art Compton polarimeter and a bismuth germanium oxide (BGO) spectrometer to perform timing, spectroscopic and polarimetric measurements of the prompt emission from GRBs. The mission is currently in a feasibility study phase (Phase A) with the European Space Agency to prepare an in-orbit demonstration. Here, we present the simulation work used to optimise the design and operational concept of the microsatellite constellation, as well as estimate the mission performance in terms of GRB detection rate and polarimetry. We used the MEGAlib software to simulate the response function of the gamma-ray instruments, together with a detailed model for the background particle and radiation fluxes in low-Earth orbit. We also developed a synthetic GRB population model to best estimate the detection rate. These simulations show that COMCUBE-S will detect about 2 GRBs per day, which is significantly higher than that of all past and current GRB missions. Furthermore, simulated performance for linear polarisation measurements shows that COMCUBE-S will be able to uniquely distinguish between competing models of the GRB prompt emission, thereby shedding new light on some of the most fundamental aspects of GRB physics.
25 November 2022 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
We present a readout electronics system designed for Compton scattering detection using silicon drift detectors (SDDs). This system represents the first component of a Compton telescope to be integrated into a CubeSat module as part of the ComPol project. The instrument is designed to observe Cygnus X-1, a binary system consisting of a black hole and a blue supergiant star, with the aim of measuring its X-ray spectrum and polarization. Through the detection of Compton events, the system will determine the angle and degree of polarization of the source. The payload consists of a Si-based detector to scatter the X-rays and a scintillating cerium bromide crystal (CeBr3) with silicon photon multiplier (SiPM) matrix for the detection of the scattered photons. The analog readout chain of the first detection system based on SDD matrices consists of charge preamplifiers, an analog pulse processor (ASIC), while a field programmable gate array (FPGA) module handles the digital data flow to the PC. Experimental characterisation of the prototype shows an energy resolution of 151 eV full width at half maximum (FWHM) with a shaping time of 3 μs. This paper presents the prototype boards designed for the final flight module, together with the results of tests performed with the prototype system.