A novel s LC _ LCC resonant dc–dc converter is proposed in this article. With the combination of a notch filter and a new s LC excitation structure of the transformer, wide and fast gain characteristics are obtained. With the frequency modulation, the notch filter structure helps the converter realize a wide output voltage range adjustable from zero theoretically. Besides, the fast voltage gain regulation capacity is achieved in a narrow frequency range with the s LC excitation structure. In the text, topology structure, operation principle, and characteristics analysis are illustrated in detail. For numerous passive components, an effective design method is necessary to guide parameter determination. And a detailed parameter design process is discussed. With the selected parameters, the soft-switching feature is realized. Finally, a 500 W experimental prototype is fabricated to verify the feasibility and effectiveness of theoretical analysis. The converter achieves 59.3–16.3 V output voltage regulation ability in a narrow frequency range (86 kHz, 189 kHz) under the condition of power 500 W and input voltage 375 V. High efficiency is maintained in the full load range, and the maximal efficiency of the converter reaches 97.7% at 99.5 kHz.
In this paper, a variable-structure multi-resonant soft-switching DC–DC converter and its transient smooth control method are proposed. Through the introduction of auxiliary switches, the converter can flexibly adjust its structure among three operating modes. Two switching processes can be obtained. Thus, a wide voltage gain range is achieved within a narrow frequency range. Moreover, to eliminate the large voltage fluctuation during modes switching, a drive signal gradual adjustment control method is proposed. Consequently, smooth switching between different modes can be realized and the voltage fluctuation is suppressed effectively. Finally, a 200 W experimental prototype is established to verify the theoretical analyses. Soft-switching performances for power switches and diodes are both guaranteed. The highest efficiency is 98.2%. With the proposed transient control method, a basically constant 400 V output voltage is ensured within a wide input voltage range (80 V–600 V). In particular, the transient voltage fluctuations during two switching processes decrease from 38.4 V to 10.8 V and from 37.2 V to 8.4 V, respectively.
16 June 2025 in IEEE Transactions on Industrial Electronics
Aiming to the issue of low efficiency caused by zero-voltage switching (ZVS) missing of phase-shift modulation (PSM) under light load condition, an efficiency optimized analysis method (EOAM) for synchronous rectification resonant converters is proposed. EOAM is realized by adjusting the synchronous rectifier (SR) advance conduction time TR. So, the mathematical model of the controlled variable TR and loss is established. And a trade-off between the reduced loss and the increased loss is emerged during the adjustment process. And the optimal SR advance conduction time (TR_op) corresponding to the optimal efficiency (ηop) under different working conditions is discussed in detail. Furthermore, the optimization methods under different working conditions are put forward and refined. To verify the effectiveness of the theoretical analysis, a 500-W experimental prototype of inductor-capacitor-inductor-capacitor (LCLC) converter is built. Compared with the traditional method of without EOAM, the proposed EOAM can improve efficiency of light load (10% load) by more than 2.6% (92.44%–95.077%). And the highest efficiency after efficiency improvement with EOAM is appeared at P = 100 W (20% load), reaching to 95.821%.