In this work, sampling was carried out in the urban area of Madrid to analyze the content of total heavy metals (Zn, Pb, Cu, Cr, Ni, and Cd) in the street dust. Contamination was evaluated using various indices, such as the Contamination Factor (CF), Enrichment Factor (EF), Geo-accumulation Index (Igeo), Potential Ecological Risk Index (RI), Pollution Load Index (PLI), the Human Health Index Hazard Index (HI), and Cancer Risk (CR). Pollution indices were related to traffic density and color. Traffic density was the factor that most influenced the values of the pollution indexes, but no significant differences were found with the color of street dust. The concentration of heavy metals in the urban dust of Madrid had the following sequence: Zn (895) > Cu (411) > Pb (290) > Cr (100) > Ni (42) > Cd (1.25 mg kg⁻¹). The pollution levels were high or very high in Pb, Zn, and Cd regarding the environmental pollution indexes. Ingestion was the main route of exposure to heavy metals contained in street dust. The CR for adults and children is less than 1 × 10⁻⁶, which means that there is no risk for the population. However, the HI was 10 times higher in children than in adults.

In the present work, a sampling grid of the urban core of the city of Murcia (South East Spain) was designed in order to analyze street dust, focusing on the contents of the heavy metals Cd, Cr, Cu, Ni, Pb, and Zn and their relationships with the color of the sample, the traffic pattern, and the location where they were sampled (sidewalks, ledges, and roads). The characterization of the samples was carried out by X-ray diffraction and scanning electron microscopy, whereas the heavy metals were extracted by acid digestion and determined by inductively coupled plasma mass spectrometry. The concentration (mg/kg) in urban dust of the city of Murcia was highest for Zn (653), followed by Cu (201) > Pb (177) > Cr (117) > Ni (51) >> Cd (0.5). The color expounded statistically significant differences with regard to the heavy metals, including the pollutant load. The same pattern was found when the classification variable was the traffic intensity, except in the case of Ni. The areas with a higher risk of contamination by heavy metals in the urban dust are the ledges of narrow city center streets with moderate traffic, where Zn and Pb seem to accumulate most greatly.

Drought is considered as one of the major limiting factors to plant growth and productivity. Drought stress reduces stomatal conductance, affecting water relations and decreasing CO₂ assimilation rate and photosynthesis. Several strategies have been developed to alleviate the negative effects of drought in the agricultural industry. One of these strategies is the use of the mulching technology, which retains water in the soil surface. Knowing that hormones play a key role in plant growth and drought stress responses, we hypothesized that the use of a new ecological mulching technology called hydromulching would improve growth over bare soil under drought stress through changes in the hormonal balance. To test this hypothesis, escarole plants (Cichorium endivia L.) were grown in pots filled with coco fiber, non-covered (bare soil) or covered with polyethylene film (PE) and three types of hydromulches made up with recycled additives: wheat straw (WS), rice hulls (RH), and substrate used for mushroom cultivation (MS). Half of the plants were subjected to drought by reducing the volume of irrigation water to 70% of crop evapotranspiration. Despite drought stress impaired escarole growth-related parameters in all treatments, plants mulched with MS maintained significantly superior growth, due to improved plant water relations and photosynthetic function. This can be explained by an efficient interaction hydromulch/soil/plant in regulating the hormonal balance under water depletion. Indeed, the concentrations of the active cytokinins (CKs), trans-zeatin and isopentenyladenine, were higher in plants grown with MS treatment, associated with shoot growth-enhancing and photosynthetic rate maintenance under stress conditions. The concentrations of the stress-related hormone, abscisic acid (ABA), varied antagonistically to those of the active CKs. In this regard, ABA increased with drought but to a lower extent in MS plants thus regulating stomata opening, which, in crosstalk with the ethylene precursor 1-aminocyclopropane-1-carboxylic acid and salicylic acid, improved plant water relations. The results obtained demonstrate that hydromulching is an efficient and sustainable management strategy to ameliorate the drought effects on escarole plants through fine regulation of the CKs/ABA balance, which will be of utmost interest and applicability in the actual climate change scenario.

To improve water and nutrient use efficiencies some strategies have been proposed, such as the use of mulching techniques or arbuscular mycorrhizal fungi (AMF) inoculation. To gain insights into the interaction between the use of hydromulch and AMF inoculation on plant growth and productivity, escarole plants (Cichorium endivia, L.) were inoculated with the AMF Rhizophagus irregularis and grown with non-inoculated plants under different soil cover treatments: ecological hydromulching based on the substrate of mushroom cultivation (MS), low-density black polyethylene (PE), and non-covered soil (BS). AMF inoculation or the use of mulching alone, but especially their interaction, increased the plant growth. The growth improvement observed in AMF-inoculated escarole plants grown under hydromulching conditions was mainly associated with the upgrading of nitrogen and phosphorous use efficiency through the regulation of the hormonal balance. Both hydromulching and AMF inoculation were found to increase the active gibberellins (GAs) and cytokinins (CKs), resulting in a positive correlation between these hormones and the growth-related parameters. In contrast, the ethylene precursor 1-aminocyclopropane-1-carboxylic acid (ACC) and abscisic acid (ABA) decreased in AMF-inoculated plants and especially in those grown with the MS treatment. This study demonstrates that there exists a positive interaction between AMF and hydromulching which enhances the growth of escarole plants by improving nutrient use efficiency and hormonal balance.

The use of mulching in agriculture suppresses the weeds around crop plants, enhances the nutrients status of soil, controls the soil structure and temperature, and reduces soil water evaporation. Excessive use of low-density polyethylene mulches is contributing to the accumulation of high amounts of plastic wastes, an environmental problem for agricultural ecosystems. Fragments of plastic from such wastes can be found in soils, in water resources, and in organisms, including humans. The objective of this work was to study the economic viability of the use of different hydromulches in an artichoke crop. Three blends were prepared by mixing paper pulp (recycled from used paper) and cardboard (from paper mills) with different additives: wheat straw (WS), rice hulls (RH), and substrate used for mushroom cultivation (MS). These were compared with low-density polyethylene (Pe), a treatment without mulching on bare soil where hand weeding was performed (HW), and a treatment without mulching on bare soil where herbicide was applied (H). The results indicate that the use of hydromulch in an artichoke crop represents a good alternative for reducing plastic waste in agriculture. The net profits of the hydromulch treatments (MS, WS, RH) were higher than for HW and H, and slightly lower than for Pe. The most profitable treatment was Pe (€0.69 m⁻³), followed by RH (€0.59 m⁻³), WS (€0.58 m⁻³), MS (€0.47 m⁻³), HW (€0.36 m⁻³), and H (€0.32 m⁻³). A sensitivity analysis showed a probability of negative results of 0.04 in Pe, 0.13 in SM, 0.08 in WS, and 0.07 in RH, so the probability that the grower will make a profit is greater than 0.9 with the use of mulch (except mushroom substrate) or polyethylene.

The Brassica oleracea L. species embrace important horticultural crops, such as broccoli, cauliflower, and cabbage, which are highly valued for their beneficial nutritional effects. However, the complexity of flower emasculation in these species has forced breeders to adopt biotechnological approaches such as somatic hybridization to ease hybrid seed production. Protoplasts entail a versatile tool in plant biotechnology, supporting breeding strategies that involve genome editing and hybridization. This review discusses the use of somatic hybridization in B. oleracea L. as a biotechnological method for developing fusion products with desirable agronomic traits, particularly cytoplasmic male sterile (CMS) condition. These CMS lines are critical for implementing a cost-effective, efficient, and reliable system for producing F1 hybrids. We present recent studies on CMS systems in B. oleracea L. crops, providing an overview of established models that explain the mechanisms of CMS and fertility restoration. Additionally, we emphasize key insights gained from protoplast fusion applied to B. oleracea L. breeding. Key steps including pre-treatments of donor plants, the main tissues used as sources of parental protoplasts, methods for obtaining somatic hybrids and cybrids, and the importance of establishing a reliable plant regeneration method are discussed. Finally, the review explores the incorporation of genome editing technologies, such as CRISPR-Cas9, to introduce multiple agronomic traits in Brassica species. This combination of advanced biotechnological tools holds significant promise for enhancing B. oleracea breeding programs in the actual climate change context.