The influence of rolling temperature and pass reduction degree on microstructure and texture evolution was investigated using an AZXW3100 alloy, Mg-3Al-1Zn-0.5Ca-0.5Y, in wt.%. The change in the rolling schedule had a significant influence on the resulting texture and microstructure from the rolling and subsequent annealing. A relatively strong basal-type texture with a basal pole split into the rolling direction was formed by rolling at 450 °C with a decreasing scheme of the pass reduction degrees with a rolling step, while the tilted basal poles in the transverse direction were developed by using an increasing scheme of the pass reduction degrees. Rolling at 500 °C results in a further distinct texture type with a far more largely tilted basal pole into the rolling direction. The directional anisotropy of the mechanical properties in the annealed sheets was caused by the texture and microstructural features, which were in turn influenced by the rolling condition. The Erichsen index of the sheets varied in accordance to the texture sharpness, i.e., the weaker the texture the higher the formability. The sheet with a tetrarchy distribution of the basal poles into the transverse and rolling directions shows an excellent formability with an average Erichsen index of 8.1.

In this study, the microstructure and related corrosion behavior of AM60 alloys with/without Ca and Y addition upon gravity casting (GC) and high-pressure die-casting (HPDC) are investigated by means of SEM/EDS characterization, immersion/salt spray test, hydrogen releasing, as well as electrochemistry examination. When utilizing GC, AM60 alloy with Ca and Y addition (named AZXW6000 alloy) has better corrosion resistance compared with AM60 alloy. Thanks to grain refinement and second phase networks introduced in HPDC, the anti-corrosion properties of the AM alloy seem much better than those of the GC counterpart. The corrosion mechanism of both GCed and HPDCed AM60-based alloys is also investigated in detail. The inspiration from present work can provide more thinking for developing high corrosion-resistant Mg alloys using different casting methods.

This study evaluates the corrosion behavior of high-pressure die-casting AZXW alloys, focusing on the influence of Al content (6, 9, 11, and 13 wt.%). The Al effect on corrosion resistance is characterized by a dual effect. The corrosion rates initially increase as Al content reaches 9 wt.%, which is attributed to a higher fraction of isolated β phases acting as micro-galvanic cathodes. Conversely, further increasing the Al content to 13 wt.% promotes the development of continuous network β phases, which serve as an efficient physical barrier that stops corrosion propagation. Furthermore, the Volta potential difference (VPD) between the α-Mg and β-phase decreases with rising Al concentrations, alleviating galvanic corrosion, further lowering the corrosion rate.