The unmeasurable gear backlash nonlinearity caused by mechanical wear in multimotor driving systems (MDSs) is inevitable, imposing challenges for the modeling and controller design. As a remedy, this work proposes a model predictive controller (MPC) to handle the unmeasurable backlash often encountered in dual-motor driving systems (DDSs). First, a control-oriented model with an observer is established to estimate the backlash torque. Accordingly, a constrained MPC is developed to minimize both the tracking error and vibrations. Therein, delay compensation is leveraged to decrease prediction lag. PI feedback is introduced to compensate for the steady-state error caused by the offset of the external observer. Based on the output of the proposed MPC, which is the sum of the torques for two motors, a time-varying-bias-torque (TVBT) scheme to save energy consumption is designed to compute the torque for each motor. Finally, experiments are conducted on DDSs to verify the effectiveness and superiority of the present MPC-TVBT.
Back electromotive force (EMF)‐based sliding mode observer (SMO) is increasingly employed for interior permanent magnet synchronous machine (IPMSM) sensorless drives due to its high robustness to external disturbance and low sensitivity to system parameter variations. However, its control performance is severely weakened by the inherent chattering and speed iteration operation. In order to effectively resolve these problems, a strategy to design a dual‐SMO is proposed in this paper. With the proposed strategy, the combination of the stator‐voltage transformation matrix (SVTM) and the low‐pass filter is developed to obtain the rotor position information, which greatly alleviates the chattering without any deviations. Meanwhile, three independent equations are constructed and extracted by placing two SVTMs in different locations. By solving these three equations, the rotor position can be calculated directly with zero phase shift, which eliminates the speed iteration operation and improves the system’s dynamic performance. Furthermore, by analyzing the influences of machine parameters’ variations, the suitable virtual q‐axis inductance can be selected to quickly achieve the optimal‐efficiency sensorless control of the IPMSM. Finally, the experimental results on an IPMSM demonstrate that the rotor position with good steady‐state and dynamic performance can be obtained accurately by using the proposed sensorless control strategy.
Nonsmooth gear-contact vibration under variable-speed operation is strongly affected by mesh-phase evolution, backlash-induced contact switching, and unilateral tooth contact. This study investigates local line-of-action vibration suppression in a single-stage spur-gear pair performing a repetitive acceleration–braking–cruising task. The modelling contribution is a control-oriented hybrid-coordinate formulation that separates the prescribed mean-speed motion from local dynamic transmission error (DTE), reconstructs the time-varying mesh stiffness (TVMS) phase from the mean angle and local relative displacement, and retains a distinct mean-coordinate phase for transmission error (TE). The learning contribution is a bounded line-of-action force strategy that combines finite-time application, low-pass filtering, plateau DC removal, amplitude and rate constraints, and trial-level contact-response acceptance and rollback. Thus, an input-feasible candidate can still be rejected when its executed contact response violates the prescribed limits. Under the nominal same-initial-condition baseline, the trade-off iteration reduces DTE and mesh-force AC RMS by 11.52% and 24.85%, respectively. Contact loss decreases from 3.35% to 0.55%, and re-engagements decrease from 29 to 5. In 100 paired perturbation samples, 94 cases improve both RMS measures. The results support the proposed framework within the tested numerical task and perturbation range.