A handy, flexible micro-thermocouple using low-melting-point metal alloys is proposed in this paper. The thermocouple has the advantages of simple fabrication and convenient integration. Bismuth/gallium-based mixed alloys are used as thermocouple materials. To precisely inject the metal alloys to the location of the sensing area, a micro-polydimethylsiloxane post is designed within the sensing area to prevent outflow of the metal alloy to another thermocouple pole during the metal-alloy injection. Experimental results showed that the Seebeck coefficient of this thermocouple reached −10.54 μV/K, which was much higher than the previously reported 0.1 μV/K. The thermocouple was also be bent at 90° more than 200 times without any damage when the mass ratio of the bismuth-based alloy was <60% in the metal-alloy mixture. This technology mitigated the difficulty of depositing traditional thin–film thermocouples on soft substrates. Therefore, the thermocouple demonstrated its potential for use in microfluidic chips, which are usually flexible devices.

Gallium-based liquid metal can be used as a material for microheaters because it can be easily filled into microchannels and electrified to generate Joule heat, but the liquid metal-based microheater will suffer breakage induced by voids forming within the liquid metal when the temperature normally gets higher than 100 °C. To resolve this problem, a novel liquid metal-based microheater with parallel ventilating side-channels is presented. It consists of a liquid-metal heating channel and two parallel ventilating side-channels. The heating channel is connected with the side-channels by small gaps between polydimethylsiloxane (PDMS) posts. Experimental results show that this novel microheater can be heated up to 200 °C without damage. To explain its excellent performance, an experiment is performed to discover the development of the voids within the liquid-metal heating channel, and two reasons are put forward in this work on the basis of the experiment. Afterward pressing and bending tests are conducted to explore the mechanical stability of the novel microheaters. Finally, the microheaters are applied to warm water to show their good flexibility on non-flat surfaces. In consequence, the novel liquid metal-based microheater is believed to be widely applicable to soft micro-electro-mechanical system(MEMS) heating devices.

This paper proposes a novel microdroplet generator based on the dielectrophoretic (DEP) force. Unlike the conventional continuous microfluidic droplet generator, this droplet generator is more like “invisible electric scissors”. It can cut the droplet off from the fluid matrix and modify droplets’ length precisely by controlling the electrodes’ length and position. These electrodes are made of liquid metal by injection. By applying a certain voltage on the liquid-metal electrodes, the electrodes generate an uneven electric field inside the main microfluidic channel. Then, the uneven electric field generates DEP force inside the fluid. The DEP force shears off part from the main matrix, in order to generate droplets. To reveal the mechanism, numerical simulations were performed to analyze the DEP force. A detailed experimental parametric study was also performed. Unlike the traditional droplet generators, the main separating force of this work is DEP force only, which can produce one droplet at a time in a more precise way.