The 65 nm Static Random Access Memory (SRAM) based Field Programmable Gate Array (FPGA) was designed and manufactured, which employed tradeoff radiation hardening techniques in Configuration RAMs (CRAMs), Embedded RAMs (EBRAMs) and flip-flops. This radiation hardened circuits include large-spacing interlock CRAM cells, area saving debugging logics, the redundant flip-flops cells, and error mitigated 6-T EBRAMs. Heavy ion irradiation test result indicates that the hardened CRAMs had a high linear energy transfer threshold of upset ∼18 MeV/(mg/cm ) with an extremely low saturation cross-section of 6.5 × cm /bit, and 71% of the upsets were single-bit upsets. The combinational use of triple modular redundancy and check code could decline ∼86.5% upset errors. Creme tools were used to predict the CRAM upset rate, which was merely 8.46 × /bit/day for the worst radiation environment. The effectiveness of radiation tolerance has been verified by the irradiation and prediction results.
In order to quantitatively compare the design cost and performance of various gate styles, NMOS transistors with two-edged, annular and ring gate layouts were designed and fabricated by a commercial 0.35 μm CMOS process. By comparing the minimum W/L ratios and transistor areas, it was found that either the annular layout or its ring counterpart incurs a higher area penalty that depends on the W/L ratio of the transistor to be designed. Furthermore, by comparing the output and transfer characteristics of the transistors and analyzing the popular existing methods for extracting the effective W/L ratio, it was shown that the mid-line approximation for annular NMOS could incur an error of more than 10%. It was also demonstrated that the foundry-provided extraction tool needs significant adaptation when being applied to the enclosed-gate transistors, since it is targeted only toward the two-edged transistor. A simple approach for rough extraction of the W/L ratio for the ring-gate NMOS was presented and its effectiveness was confirmed by the experimental results with an error up to 8%.
8 December 2017 in IEEE Transactions on Nuclear Science
Total-ionizing-dose (TID) irradiation affects the single-event (SE) vulnerability of electronics by changing transistor leakage currents and/or effective threshold voltages (VT). Characterization of SE response of flip-flop (FF) designs in a 14-/16-nm bulk FinFET technology after TID exposure has been carried out with alpha particle irradiations. Results show that SE cross section (SECS) first increase with total dose and then start to decrease after certain dose levels. These transition dose levels for SECS trend depend on supply voltage and FF design due to competing mechanisms associated with n-hit and p-hit SE transient (SET) pulse-widths and feedback loop delay. Similar trends were observed for SET-induced logic errors at highfrequency operations after TID exposure.
In this work, performance degradation of 65 nm N‐channel metal‐oxide‐semiconductor field effect transistors (NMOSFETs) with enclosed gate and two‐edged gate layouts under hot carrier stress and constant voltage stress is investigated. Compared with the cold carrier, the hot carrier effect (HCE) causes more serious degradation in threshold voltage and transconductance. It is shown that cold carrier contribution is reversible, while HCE damage is permanent, it cannot be reversed by application of the annealing bias. Meanwhile, an enclosed gate NMOSFET is proved to have higher resistance to HCE than two‐edged gate NMOSFET fabricated in the same 65 nm complementary metal‐oxide‐semiconductor (CMOS) technology according to the results of experiments. That is, the enclosed gate NMOSFET not only provides total‐dose radiation tolerance but also improves the hot carrier reliability of advanced CMOS circuits. The contributions of the two types of carriers to the degradation of transistor performance are analysed. The physical mechanism of HCE reliability of different geometry MOSFETs is studied.
20 May 2018 in Advances in Condensed Matter Physics
The breakdown characteristics of ultra-thin gate oxide MOS capacitors fabricated in 65 nm CMOS technology under constant voltage stress and substrate hot-carrier injection are investigated. Compared to normal thick gate oxide, the degradation mechanism of time-dependent dielectric breakdown (TDDB) of ultra-thin gate oxide is found to be different. It is found that the gate current () of ultra-thin gate oxide MOS capacitor is more likely to be induced not only by Fowler-Nordheim (F-N) tunneling electrons, but also by electrons surmounting barrier and penetrating electrons in the condition of constant voltage stress. Moreover it is shown that the time to breakdown () under substrate hot-carrier injection is far less than that under constant voltage stress when the failure criterion is defined as a hard breakdown according to the experimental results. The TDDB mechanism of ultra-thin gate oxide will be detailed. The differences in TDDB characteristics of MOS capacitors induced by constant voltage stress and substrate hot-carrier injection will be also discussed.