A new type of SiCf/TiC-Ti3SiC2 composite was prepared by the Spark Plasma Sintering (SPS) method in this work. The phase transformation and interface cracking of this composite under ion irradiation (single Xe, Xe + He, and Xe + He + H ions) and subsequent annealing were analyzed using transmission electron microscopy (TEM), mainly focusing on the interface regions. Xe ion irradiation resulted in the formation of high-density stacking faults in the TiC coatings and the complete amorphization of SiC fibers. The implanted H ions exacerbated interface coarsening. After annealing at 900 °C for 2 h, the interface in the Xe + He + H ion-irradiated samples was seriously damaged, resulting in the formation of large bubbles and cracks. This damage occurred because the H atoms reduced the surface free energy, thereby promoting the nucleation and growth of bubbles. Due to the absorption effect of the SiCf/TiC interface on defects, the SiC fiber areas near the interface recovered back to the initial nano-polycrystalline structure after annealing.
18 June 2019 in Journal of Physics D: Applied Physics
Plasma ignition technology has been widely used for decades due to its great improvement in enhanced burning rate. However, the interaction process between the plasma jet and the solid propellant is still far from being elucidated. In this paper, coupling the flow model of plasma jet and the chemical reaction model of propellants, a more comprehensive model for predicting the plasma enhanced burning rate is presented. Three types of energetic thermoplastic elastomers propellant are involved. In addition, the closed bomb vessel test is conducted to investigate the burning characteristics of propellant under the action of plasma for comparison. It demonstrates that the enhanced combustion phenomenon of propellants in the experiment can be well described by an enhanced burning rate coefficient epsilon calculated with the model, which could reflect the effect of plasma jet to some extent. The results show that the composition of the energetic material and its surface temperature are the key factors influencing the plasma-enhanced combustion. This model would bring some insight on the interaction mechanisms between plasma and different propellants.
26 March 2019 in IEEE Transactions on Plasma Science
In decades, the plasma ignition technology has drawn much attention due to its advantages. However, the numerical research on the plasma ignition of solid propellants is still limited. In this paper, a 1-D transient plasma ignition model of solid propellant is developed. A simplified chemical reaction mechanism of XM39 is employed in the model to explore the solid phase and gas phase chemical reactions and species transportations in the gas phase. The expansion process of the plasma jet is also investigated. The predicted surface pressure and ignition delay are compared to the experimental results. Good agreement with these data provides the necessary validation of the presented model. In the model, the calculated temperature profiles and the mass fraction distribution of the gas hexogen are used to characterize the reaction zone. In addition, the mass fraction distributions of CH_2O and HCN are used to estimate the possibilities of different reaction paths.
Ethylene-Vinyl-Acetate-Copolymers (EVA) are widely used in the manufacture of wires and cables as electrical insulating media in electric power fields. Oxidation is one of the primary mechanisms leading to the aging of polymer materials, and the addition of antioxidants can effectively slow the oxidation reaction. Current non-destructive testing methodologies face challenges in the measurement of antioxidant concentrations, which constitute a critical metric for aging assessments. In this paper, we propose a method for measuring antioxidant concentration using terahertz time-domain spectroscopy (THz-TDS). In comparison to other techniques such as liquid chromatography, no elaborate sample preparation is necessary, and calibration measurements can be conducted rapidly. The spectral changes caused by the addition of different concentrations of antioxidants were investigated, and the results showed that the refractive index and dielectric constant increased significantly with a decrease in the antioxidant concentration. When the concentration of antioxidant 1010 in the sample was increased from 0 to 10%, the refractive index decreased from 1.55 to 1.42, and the dielectric constant decreased from 2.38 to 2.03 average over the band of 0.5-2.5 THz. Moreover, the numerical calculation using density functional theory (DFT) showed the introduction of oxygen-containing functional groups of antioxidant 1010 molecules into EVA molecules slightly reduced the polarization, resulting in a consistently decrease in the dielectric constant of the constructed materials compared with original EVA materials. The classification of antioxidant concentration in EVA was predicted using machine learning, including Partial Least Squares Regression (PLSR), Random Forest (RF), Support Vector Regression (SVR), and extreme Gradient Boosting (XGboost). XGboost was found to have the highest prediction accuracy with an root mean square error (RMSE) of 0.0412. In order to ascertain the characteristic spectrum of the 1010 antioxidant, we selected the dielectric constant at the 0.9 THz position for a linear fit. The root mean square error of cross validation (RMSECV) value for leave-one-out cross validation (LOOCV) was found to be 0.38.
In this paper, the relationship between the terahertz radiation and the spatial distribution of photogenerated carriers under different bias electric field is studied. Terahertz pulses and the photocurrent of SI-GaAs photoconductive antenna are measured by the terahertz time-domain spectroscopy system. The occupancy rate for photogenerated carriers for different energy valleys is obtained by comparing the photocurrent of terahertz field integrating with respect to time with the photocurrent measured by oscilloscope. Results indicate that 93.04% of all photogenerated carriers are located in the Γ valley when the bias electric field is 3.33 kV/cm, and 68.6% of all photogenerated carriers are transferred to the satellite valley when the bias electric field is 20.00 kV/cm. With the bias electric field increasing, the carrier occupancy rate for the satellite valley tends to saturate at 72.16%. In order to obtain the carrier occupancy rate for the satellite valley and saturate value at the high bias electric field, an ensemble Monte Carlo simulation based on the theory of photo-activated charge domain is developed.