The paper addresses environmental protection by valorizing an important agri-food waste category, namely fruit and vegetables with focusing on the main characteristics regarding consumption, waste quantities, and ways for valorizing these materials. Thus, vast research was undertaken in order to emphasize the main commodities and their potential application as adsorbents for organic and inorganic pollutants. The main methods or treatment techniques applied for the valorization of eco-materials as adsorbents were presented and the principal efficiency results were indicated. The advantages and disadvantages of using these eco-materials as adsorbents in wastewater treatment were revealed and future recommendations were established. According to the international statistics, the most purchased and consumed five commodities were studied regarding waste generations as potential conversion into eco-materials with an adsorbent role for water pollutants. Thus, the performances for adsorbents based on fruit wastes (such as citrus, banana, apples, grapes, mango) and vegetable wastes (such as potatoes, tomatoes, cabbage, carrots, cauliflower, and/or broccoli) were studied and highlighted in this research.

In line with the development of industrial society, wastewater has caused multiple environmental problems. Contaminants of emerging concern (CECs) in water and wastewater are persistent, and for this reason they can cause serious problems for human health, animal health, and the whole environment. Therefore, it is absolutely necessary to apply efficient methods for the treatment of wastewater that has a high concentration of organic compounds. Over recent years, the prescribed and non-prescribed consumption of antibiotics has increased significantly worldwide. Large quantities of antibiotics are discharged into wastewater because of their incomplete absorption by living organisms. However, even small concentrations present in aquatic environments represent a major risk to human health and environment protection. This paper presents the main advantages and disadvantages of advanced oxidation processes, and the current state and new perspectives in the field of environment protection. This study summarizes data from the most recent specialized scientific literature that focuses on the topic of advanced oxidation processes, thus bringing all these aspects to the attention of researchers in a single work that adds comments and interpretations related to the presented processes. Advanced oxidation processes (AOPs) are often used in the treatment of different types of wastewater. AOPs are based on physicochemical processes that create significant structural changes in chemical species. The majority of antibiotics may be eliminated using physicochemical processes, such as photo-Fenton oxidation, photolysis, ozonation, electrooxidation, heterogeneous catalysis, and other bioprocesses. In comparison to conventional chemical processes, AOPs provide superior oxidation efficiency, ideal operating costs, and zero secondary pollutants.

A novel hydrogel composite based on gellan gum and graphene oxide (GG/GO) was synthesized, characterized and tested for sorption capacity in this work. The microstructural, thermogravimetric and spectroscopic analysis confirmed the formation of the GG/GO composite. Comparative batch sorption experiments revealed a sorption capacity of the GG/GO composite for Zn (II) ions of approximately 2.3 higher than that of pure GG. The GG/GO composite exhibits a maximum sorption capacity of 272.57 mg/g at a pH of Zn (II) initial solution of 6. Generally, the sorption capacity of the sorbents is approximately 1.5 higher in slightly acidic conditions (pH 6) comparative with that for strong acidic conditions (pH 3). The sorption isotherms revealed that the sorption followed a monolayer/homogenous behavior. The sorption kinetic data were well fitted by the pseudo-second-order kinetic model, and were consistent with those derived from sorption isotherms. The intraparticle diffusion was considered to be the rate-determining step. Two main sorption mechanisms for Zn (II) were identified namely, ion exchange at low pH values, and both ion exchange and chemisorption in weekly acidic conditions.

New photocatalytic membranes based on polylactic acid (PLA)/TiO₂ hybrid nanofibers deposited on fiberglass supports were prepared and tested for the removal of ampicillin from aqueous solutions. The electrospinning technique was used to obtain hybrid nanofibers that were deposited on three types of fiberglass with different structures, resulting in three distinct photocatalytic membranes namely fiberglass fabric plain woven-type membrane, fiberglass mat-type membrane, and fiberglass fabric one-fold edge-type membrane. The results of the photocatalytic tests showed that the highest efficiency of ampicillin removal from aqueous solution is obtained with the fiberglass fabric plain woven-type membrane. Although it has been shown that the rate of photocatalytic degradation of ampicillin is high, being practically eliminated within the first 30 min of photocatalysis, the degree of mineralization of the aqueous solution is low even after two hours of photocatalysis due to the degradation of PLA from the photocatalytic membrane. The instability of PLA in the reactive environment of the photocatalytic reactor, evidenced by morphological, mineralogical and spectroscopic analyzes as well as by kinetic studies, is closely related to the structure of the fiberglass membrane used as a support for PLA/TiO₂ hybrid nanofibers.