Nasturtium (Tropaeolum majus L.), as a medicinal plant, has a high phenolic content in its leaves and flowers. It is often used in salads as a dietary vegetable. Attracting strong demand, it could be a good candidate crop for a plant factory with artificial lighting (PFAL) that can achieve the mass production of high-quality crops with high productivity by regulating environmental conditions such as light. In this study, two experiments were conducted to investigate the effects of continuous lighting (CL) and different daily light integrals (DLIs) under CL on the growth, secondary metabolites, and light use efficiency (LUE) of nasturtium, all of which are essential in the successful cultivation in PFALs. In Experiment 1, two lighting models, the same DLI of 17.3 mol m⁻² d⁻¹ but different light periods (24 and 16 h) with different light intensities (200 and 300 µmol m⁻² s⁻¹, respectively), were applied to nasturtium. The results showed that leaf production, secondary metabolites, and LUE were higher under the 24-h CL treatment than under the 16-h non-CL treatment. In Experiment 2, three DLI levels (17.3, 25.9, and 34.6 mol m⁻² d⁻¹) under the CL condition were applied. The results showed that the growth parameters were positively correlated with the DLI levels under CL. The lowest DLI had the highest LUE. We conclude that the mass production of nasturtium under CL in PFALs is feasible, and the yield increases as DLI increases from 17.3 to 34.6 mol m⁻² d⁻¹ under CL without causing physiological stress on plants.

Hydroponic cultivation using nutrient solution (NS) is the main cultivation method employed by plant factories with artificial lighting (PFALs). The electrical conductivity (EC) of NSs influences the yield and quality of vegetables. The purpose of this study was to optimize the yield and antioxidant accumulation of basil in a PFAL by EC management. In experiment 1, basil plants were grown under four different ECs (0.5, 1.0, 3.0, and 5.0 dS m⁻¹) after transplanting. At 18 days after treatment, the highest levels of shoot fresh and dry weights, leaf fresh and dry weights, and leaf area were observed at an EC of 3.0 dS m⁻¹. However, low-EC treatments (0.5 and 1.0 dS m⁻¹) generated total phenolic content (TPC) and antioxidant capacities that were higher than those of other EC treatments (3.0 and 5.0 dS m⁻¹). In experiment 2, basil plants were grown at an EC of 3.0 dS m⁻¹ for 13 or 15 days, then treated with water or NS with low ECs (0.5 and 1.0 dS m⁻¹) for 5 or 3 days before harvest. The short-term low-EC treatments, especially, water for 3 days and 0.5 dS m⁻¹ for 5 days, significantly increased the TPC and antioxidant capacity of leaves without significantly decreasing the yields of basil, compared with the control. In conclusion, yield of basil was optimized with an EC of 3.0 dS m⁻¹; however, the TPC and antioxidant capacity of basil were significantly increased by low ECs of 0.5 and 1.0 dS m⁻¹. Short-term low-EC treatments (0.5 dS m⁻¹ for 5 days or water for 3 days) could be used to promote the TPC and antioxidant capacity in leaves without sacrificing yield of basil significantly.

Light-emitting diodes (LEDs) have been widely used as light sources for plant production in plant factories with artificial lighting (PFALs), and light spectrum and light amount have great impacts on plant growth and development. With the expansion of the product list of PFALs, tomato production in PFALs has received attention, but studies on fruit quality influenced by artificial light are lacking. In this study, precisely modulated LED light sources based on white light combined with additional red, blue, and green lights were used to investigate the effects of light spectrum and daily light integral (DLI) on the main quality indicators and flavor substances of “Micro-Tom” tomato fruits. The highest sugar–acid ratio was obtained under the white light with addition of red light with high DLI and blue light with low DLI. The contents of β-carotene, lycopene, and lutein were significantly increased by higher DLI conditions except for under the blue light treatment, and the cross-interactions between the light spectrum and DLI were observed. The accumulation of the main flavor substances in tomato fruits was decreased by addition of green light with a high DLI and red light with a low DLI; notably, the percentage of 2-isobutylthiazole, which is associated with fresh tomato aroma, was decreased by green light. This study provides insights for improving tomato fruit quality and flavor by regulating light conditions in PFALs.

Quantitative nutrient management has advantages, such as saving resources and improving nutrient utilization, compared with the conventional electrical conductivity management method. The growth and nutrient utilization of vegetables are affected by the integrated environmental conditions such as nutrient supply and light spectrum. This study investigated the effects of applied nutrient quantity (ANQ) (0.5, 1, 2, and 4 times (T) the absorption quantity of nutrients determined in the preliminary experiment, indicated by 0.5T, 1T, 2T, and 4T, respectively) in nutrient solution and red:blue ratio (R:B = 3:7, 7:3, and 9:1, indicated by RB3:7, RB7:3, and RB9:1, respectively) on the growth and nutrient utilization of basil plants in a plant factory with artificial lighting. Results demonstrated that the nutrient use efficiency (NUE) and the nutrient absorption efficiency (NAE) were significantly increased by the ANQ of 0.5T compared with the treatments of 1T, 2T, and 4T, irrespective of R:B ratios. Furthermore, under the ANQ of 0.5T, RB7:3 significantly increased the yield and the absorption of N and K of the basil plant compared with other R:B ratios. Therefore, the ANQ of 0.5T combined with RB7:3 was considered the optimal combination to improve the yield, NUE, and NAE of basil plants in the present study.

Nasturtium is a popular herbal plant, widely cultivated as culinary and medicinal plants all over the world. However, the seed propagation of nasturtium is inefficient, and in-vitro propagation is sophisticated and high-cost. In this study, the cutting propagation method was employed to produce nasturtium seedlings. We aimed to determine the optimal conditions for cutting propagation of nasturtium seedlings by investigating the effects of node position and electric conductivity (EC) of nutrient solution on the root formation of the cuttings. Cuttings from five node positions (apical bud, 2nd node, 3rd node, 4th node, and 5th node) were subjected to water and five EC (1.0, 2.0, 3.0, 4.0, and 5.0 dS m⁻¹) treatments with a hydroponic cultivation system in a plant factory. Results showed that all cuttings rooted successfully within two weeks. The cuttings from the apical bud position rooted earliest and produced the most roots regardless of EC level. Cuttings from other node positions produced longer roots and heavier root fresh and dry weights than those from the apical bud position. The cuttings under EC of 1.0 dS m⁻¹ had the greatest root number, the longest root length, and the heaviest root fresh and dry weights regardless of node positions. The EC of 1.0 dS m⁻¹ is considered the best condition for nasturtium cuttings for the range of EC tested in this study, and the cuttings from all the five node positions can be used as seedling materials.