The evidence on the neuroprotective impact of Centella asiatica (C. asiatica) has been greatly documented in recent years. However, a major obstacle that remains to be overcome is the capacity of the active molecules in C. asiatica to cross the blood-brain barrier (BBB). In this study, we explored the possibilities of using a D-optimal mixture design to fabricate nanoemulsion of C. asiatica (NanoSECA) for better brain bioavailability. The parameters for optimization were the percentage of water (1080 w/v) and virgin coconut oil (VCO) (1080 w/v). Nanoemulsions were formulated using a high-pressure homogenization approach and were characterized for their physicochemical properties. The optimal VCO-based nanoemulsion (VBN: F2) conditions were found at 80 (w/v) of water and 10 (w/v) of VCO. Subsequently, viability tests were conducted on neuroblastoma (SH-SY5Y) and macrophage (RAW 264.7) cell lines. NanoSECA was distinguished for its antioxidant, acetylcholinesterase (AChE), anti-inflammatory, and parallel artificial membrane permeability assay (PAMPA) activities in vitro. The NanoSECA has a particle size of 127.833±8.280nm, zeta potential (ZP) of 24.9±0.011mV, polydispersity index (PDI) of 0.493±4.681, percentage prediction error (PPE) of 12.02, and pH of 6.0±0.006 and is also stable under different storage conditions. Cell viability was improved in a dose-dependent manner on SH-SY5Y and RAW 264.7 cell lines. In addition, NanoSECA significantly reduced the AChE activity, suppressing the level of proinflammatory mediators and oxidative stress. Moreover, NanoSECA showed high BBB permeation with a high value of experimental permeability to cross the BBB. Thus, NanoSECA could efficiently potentiate the central nervous system (CNS) therapeutic activities through enhanced penetration of BBB. These nano-delivery systems are crucial to unlock the full potential of C. asiatica for treating numerous CNS disorders.
With the progressive increase in human activities in the Antarctic region, the possibility of domestic oil spillage also increases. Developing means for the removal of oils, such as canola oil, from the environment and waste “grey” water using biological approaches is therefore desirable, since the thermal process of oil degradation is expensive and ineffective. Thus, in this study an indigenous cold-adapted Antarctic soil bacterium, Rhodococcus erythropolis strain AQ5-07, was screened for biosurfactant production ability using the multiple approaches of blood haemolysis, surface tension, emulsification index, oil spreading, drop collapse and “MATH” assay for cellular hydrophobicity. The growth kinetics of the bacterium containing different canola oil concentration was studied. The strain showed β-haemolysis on blood agar with a high emulsification index and low surface tension value of 91.5% and 25.14 mN/m, respectively. Of the models tested, the Haldane model provided the best description of the growth kinetics, although several models were similar in performance. Parameters obtained from the modelling were the maximum specific growth rate (qmax), concentration of substrate at the half maximum specific growth rate, Ks% (v/v) and the inhibition constant Ki% (v/v), with values of 0.142 h−1, 7.743% (v/v) and 0.399% (v/v), respectively. These biological coefficients are useful in predicting growth conditions for batch studies, and also relevant to “in field” bioremediation strategies where the concentration of oil might need to be diluted to non-toxic levels prior to remediation. Biosurfactants can also have application in enhanced oil recovery (EOR) under different environmental conditions.
Pepsin enzyme was used to pretreat the bovine skin at the rate of 5, 15, and 25 units of enzyme/g of skin to recover gelatin, and the recovered gelatins were referred to as Pe5, Pe15, and Pe25, respectively. The gelatin yield increased significantly (p < 0.05) from 18.17% for Pe5 to 24.67% for Pe25 as the level of pepsin increased, but the corresponding gel strength and viscosity decreased significantly (p < 0.05) from 215.49 to 56.06 g and 9.17 to 8.17 mPa·s for Pe5 and Pe25, respectively. β- and α1- and α2-chains were degraded entirely in all the gelatins samples as observed in protein pattern elaborated by gel electrophoresis. 1H nuclear magnetic resonance (1H NMR) analysis indicated the coiled structure of gelatin protein chains. The lowest amide III amplitude of Pe25 as found by Fourier transform infrared (FTIR) spectroscopy indicated that α-helix structure of protein chains were lost to more irregular coiled structure. Thus, it could be summarized that pepsin might be used at the lower level (5 units/g of wet skin) to extract gelatin from bovine skin with good functional properties and at higher level (15/25 units/g of wet skin) to obtain gelatin of industrial grade with high yield.
Petroleum hydrocarbons, notably diesel oil, are the main energy source for running amenities in the Antarctic region and are the major cause of pollution in this area. Diesel oil spills are one of the major challenges facing management of the Antarctic environment. Bioremediation using bacteria can be an effective and eco-friendly approach for their remediation. However, since the introduction of non-native organisms, including microorganisms, into the Antarctic or between the distinct biogeographical regions within the continent is not permitted under the Antarctic Treaty, it is crucial to discover native oil-degrading, psychrotolerant microorganisms that can be used in diesel bioremediation. The primary aim of the current study is to optimize the conditions for growth and diesel degradation activity of an Antarctic local bacterium, Arthrobacter sp. strain AQ5-05, using the Plackett-Burman approach and response surface method (RSM) via a central composite design (CCD) approach. Based on this approach, temperature, pH, and salinity were calculated to be optimum at 16.30 °C, pH 7.67 and 1.12% (w/v), respectively. A second order polynomial regression model very accurately represented the experimental figures’ interpretation. These optimized environmental conditions increased diesel degradation from 34.5% (at 10 °C, pH 7.00 and 1.00% (w/v) salinity) to 56.4%. Further investigation of the kinetics of diesel reduction by strain AQ5-05 revealed that the Teissier model had the lowest RMSE and AICC values. The calculated values for the Teissier constants of maximal growth rate, half-saturation rate constant for the maximal growth, and half inhibition constants (μmax, Ks, and Ki), were 0.999 h−1, 1.971% (v/v) and 1.764% (v/v), respectively. The data obtained therefore confirmed the potential application of this cold-tolerant strain in the bioremediation of diesel-contaminated Antarctic soils at low temperature.