Replacing virgin raw materials with recycled waste in construction products is a key strategy for advancing sustainable development. This study explores the partial substitution of commercial gypsum with powdered waste brick (WB) in gypsum mortars, assessing its impact on mechanical performance, water absorption, and environmental footprint. Mortars were prepared with 0%, 5%, 10%, 20%, and 30% WB by weight. Results indicate that a 20% replacement level enhances flexural strength by 56% and compressive strength by 33% at 28 days, compared to the reference mix. SEM and XRD analyses revealed no formation of new crystalline phases, suggesting that the performance improvement is primarily due to physical interactions and microstructural effects. However, at 30% WB, a significant reduction in adhesion strength was observed, falling below the typical threshold for gypsum-based coatings, which may constrain practical application at higher replacement levels. Environmental assessment showed that both CO2 emissions and energy consumption decreased by up to 20% with a 30% substitution. A 20% WB content is therefore proposed as the optimal compromise between mechanical performance and environmental benefit. This approach supports circular economy principles by promoting the reuse of ceramic construction waste in the development of new sustainable materials.
Gypsum has been used as a building material for a long time due to its environmental friendliness, exceptional fire performance, and ease of use. However, it is also known to have poor moisture resistance and lower mechanical performance. Construction and demolition wastes, which can cause many environmental issues if not properly managed, are increasingly recycled as reinforcement materials in gypsum mortar. This study aims to assess the effect of incorporating fine glass waste aggregates into gypsum mortars on their physical, mechanical, and adhesive properties. The effect of replacing sand from 0% to 100% by glass waste in gypsum mortar was investigated using various tests and analyses including scanning electron microscopy (SEM), X-ray diffraction (XRD), thermal analysis (DTA and TGA), setting time, flexural and compressive strengths, adhesive, surface hardness, water absorption, thermal conductivity, and ultrasonic pulse velocity. The results obtained emphasize that glass waste can substitute sand in gypsum mortar, even when used at high replacement levels. Replacing all the sand in mortar with glass waste results in a 11% increase in porosity, a 9% decrease in density, and a 53% decrease in thermal conductivity, while still maintaining acceptable mechanical performances. The adhesive strength shows a great dependence on the nature of the substrate.