In this study, we synthesized hybrid systems based on manganese oxide@zinc oxide (Mn3O4@ZnO), using sol gel and hydrothermal methods. The hybrid materials exhibited hierarchical morphologies and structures characterized by the hexagonal phase of ZnO and the tetragonal phase of Mn3O4. The hybrid materials were tested for degradation of methylene blue (MB), methyl orange (MO), and malachite green (MG) under ultraviolet (UV) light illumination. The aim of this work was to observe the effect of various amounts of Mn3O4 in enhancing the photocatalytic properties of ZnO-based hybrid structures towards the degradation of MB, MO and MG. The ZnO photocatalyst showed better performance with an increasing amount of Mn3O4, and the degradation efficiency for the hybrid material containing the maximum amount of Mn3O4 was found to be 94.59%, 89.99%, and 97.40% for MB, MO and MG, respectively. The improvement in the performance of hybrid materials can be attributed to the high charge separation rate of electron-hole pairs, the co-catalytic role, the large number of catalytic sites, and the synergy for the production of high quantities of oxidizing radicals. The performance obtained from the various Mn3O4@ZnO hybrid materials suggest that Mn3O4 can be considered an effective co-catalyst for a wide range of photocatalytic materials such as titanium dioxide, tin oxide, and carbon-based materials, in developing practical hybrid photocatalysts for the degradation of dyes and for wastewater treatment.
Wastewater from the textile industry is chronic and hazardous for the human body due to the presence of a variety of organic dyes; therefore, its complete treatment requires efficient, simple, and low cost technology. For this purpose, we grew ZnO microstructures in the presence of psyllium husk, and the role of psyllium husk was to modify the surface of the ZnO microstructures, create defects in the semiconducting crystal structures, and to alter the morphology of the nanostructured material. The growth process involved a hydrothermal method followed by calcination in air. Additionally, the psyllium husk, after thermal combustion, added a certain value of carbon into the ZnO nanomaterial, consequently enhancing the photocatalytic activity towards the degradation of methylene blue. We also investigated the effect of varying doses of photocatalyst on the photocatalytic properties towards the photodegradation of methylene blue in aqueous solution under the illumination of ultraviolet light. The structure and morphology of the prepared ZnO microstructures were explored by scanning electron microscopy (SEM) and powder X-ray diffraction (XRD) techniques. The degradation of methylene blue was monitored under the irradiation of ultraviolet light and in the dark. Also, the degradation of methylene blue was measured with and without photocatalyst. The photodegradation of methylene blue is highly increased using the ZnO sample prepared with psyllium husk. The photodegradation efficiency is found to be approximately 99.35% for this sample. The outperforming functionality of psyllium-husk-assisted ZnO sample is attributed to large surface area of carbon material from the psyllium husk and the synergetic effect between the incorporated carbon and ZnO itself. Based on the performance of the hybrid material, it is safe to say that psyllium husk has high potential for use where surface roughness, morphology alteration, and defects in the crystal structure are vital for the enhancing the functionality of a nanostructured material. The observed performance of ZnO in the presence of psyllium husk provides evidence for the fabrication of a low cost and efficient photocatalyst for the wastewater treatment problems.
Nickel-supported hierarchical zeolite catalysts were prepared through a desilication reassembly process under optimized conditions and applied in one-pot menthol synthesis. In this work, the hierarchical zeolite-supported metal bifunctional catalysts were prepared with the help of desilication re-assembly and wetness impregnation techniques and applied in menthol synthesis via citral hydrogenation. The prepared catalysts were characterized using PXRD, BET, FE-TEM, NH3-TPD, H2-TPR, pyridine adsorption, and ICP-OES techniques. As a result, the physicochemical and acidic properties, such as mesopore surface area, metal dispersion, acidity, catalytic activity, and strong Lewis acid sites of pure microporous ZSM-5/USY zeolites, were significantly improved. Consequently, with the occurrence of superior physicochemical and acidic properties, the Ni/HZ-0.5 M catalyst exhibited outstanding catalytic activity (100% conversion, TOF 7.12 h−1) and menthol selectivity (83%, 4 h) with uniform stability at 100 °C, 1.0 MPa hydrogen. Similarly, the cracking rate decreased with the decrease in Bronsted acid sites.