State Key Laboratory of Optoelectronic Materials and Technologies, School of Electronics and Information Technology, Sun Yat-Sen University, Guangzhou, China
Auto-generated profile, based on publicly available information
Xianda Zhou
State Key Laboratory of Optoelectronic Materials and Technologies, School of Electronics and Information Technology, Sun Yat-Sen University, Guangzhou, China
High performance NiO/β-Ga2O3 heterojunction pn diodes were realized by applying a sputtered p-type NiO film onto a lightly doped n-type β-Ga2O3 epitaxial layer. Taking advantage of the high barrier height against carriers within the pn heterojunction, the demonstrated device exhibited a high breakdown voltage (VB) of 1059 V without optimized electric field management techniques, and before breakdown the reverse leakage current density remained below 1 μA/cm2. Simultaneously, a relatively low specific on-resistance (Ron, sp) of 3.5 mΩ∙cm2 was achieved. The built-in potential of the heterojunction that determined by a capacitance-voltage (C-V) measurement was around 2.4 eV. As discussed in terms of the energy band diagram of a type-II heterojunction, the conduction band and valence band offsets at the NiO/β-Ga2O3 hetero-interface were estimated to be 1.2 and 2.3 eV, respectively.
1 July 2021 in IEEE Transactions on Electron Devices
This work presents the fabrication and characterization of a high-performance vertical Nickel oxide (NiO)/Beta gallium oxide ( β-Ga 2 O 3 ) heterojunction p-n diode. The heterojunction was fabricated by sputtering a p-NiO thin film onto an epitaxial n - - β-Ga 2 O 3 drift layer. The sputtered NiO, revealed to be polycrystalline, showed an improved crystallinity after annealed in an oxygen ambient, while a seamless contact with the underneath single crystalline β-Ga 2 O 3 was observed. A high hole concentration of 1- 3×10 19 cm -3 and an improved Ohmic contact were also obtained by the annealing process, as confirmed by the Hall and TLM measurements, respectively. A high breakdown voltage ( V B ) of 1.4 kV and a low specific ON-resistance ( R on,sp ) of 2.7 mΩ·cm 2 were simultaneously achieved for the fabricated diodes, yielding a superior Baliga's figure-of-merit (BFoM) of 0.73 GW/cm 2 . From the temperature-dependent current-voltage ( I- V) measurements, two carrier transport mechanisms, namely interface recombination and multistep tunneling, have been identified in the forward conduction of the NiO/ β-Ga 2 O 3 heterojunction. The fast recovery property of the device, which was revealed by a double-pulse test, further confirmed the purposed carrier transport mechanisms.
A new superjunction MOSFET (SJ-MOSFET) architecture with dual built-in Schottky diodes is proposed and studied with numerical TCAD simulations. The study is based on silicon. One Schottky contact is formed to the top of the n-pillar, while the other is formed to the bottom of the p-pillar. During reverse conduction period, the Schottky junctions turn on at a lower voltage than the PN junction. The current flows through n-pillar and p-pillar in parallel, so the potential difference across the PN junction is kept below its turn-on voltage. Thus, minority carrier injection through the PN junction is completely suppressed, leading to a superior reverse recovery performance. Integration of a single Schottky contact to either the n-pillar or the p-pillar cannot completely suppress the turn-on of the PN junction in the SJ-MOSFET, due to the potential drop created by the current through only one type of the pillars. Furthermore, the proposed dual-Schottky SJ-MOSFET reduces the gate charge (QG) and the gate to drain charge (QGD), compared to the conventional SJ-MOSFET, leading to better figures of merit.
30 September 2019 in IEEE Transactions on Electron Devices
A Schottky diode based on amorphous wide bandgap oxide semiconductor is experimentally demonstrated with reasonable performance. The Schottky barrier is formed between the room-temperature sputtered amorphous indium-tin-zinc-oxide/indium-gallium-zinc-oxide bilayer and platinum, and a highly-resistive, self-aligned junction termination region is implemented at only 280 °C. Due to such low-temperature process, oxide-based Schottky diode is very attractive in terms of low manufacturing cost and back-end-of-line (BEOL) integration compatibility. The proposed Schottky diode has an ideality factor of 1.2 and a high rectification ratio of 1 x 10⁹ at ±1.5 V. The extracted specific ON-resistance is 7.8 mΩ ·mm², and the breakdown voltage is 26.4 V. With approximately the same Baliga's figure-of-merit as that of the single-crystal silicon counterparts, the proposed Schottky diode is therefore promising for power electronic applications.
A hybrid active pixel optical sensor for high-resolution and high-sensitivity imaging is proposed and experimentally demonstrated. The sensor vertically integrates an amorphous silicon p-i-n photodiode and a low-temperature polycrystalline silicon readout thin-film transistor (TFT). The vertical integration results in a high fill factor (> 70%) and an enlarged photosensing area in the pixel. In the photodiode-gated TFT structure of the sensor, the output current is amplified by operating the TFT in the sub-threshold regime. A weakly wavelength-dependent photoconductive gain > 10 is obtained at visible wavelengths, enabling large area low-level light detection.
A heterojunction diode between n-type amorphous indium-gallium-zinc-oxide (a-IGZO) and p-type nickel oxide is experimentally demonstrated with self-aligned junction termination. The diode has an abrupt, non-destructive breakdown behavior, and the avalanche breakdown is confirmed by the positive temperature coefficient of the breakdown voltage. The room-temperature breakdown voltage of the device is 33 V, and the extracted critical breakdown electrical field (E CR ) is 2.7 MV/cm. The E CR is one order of magnitude higher than that of single-crystal silicon, making a-IGZO promising for power electronics and other high-voltage applications.