Basic principles are discussed of a First Mirrors Unit (FMU) design for ITER optical diagnostics, equipped with an RF capacitive coupled discharge cleaning subsystem. A non-tunable RF pre-matcher device is shown to be desirable in the proximity to the discharge load to avoid excessive heating of an in-vessel RF feeder part. A possibility of satisfactory RF pre-matching with a simple non-tunable L-shaped circuit is demonstrated for the experimentally measured RF discharge impedance variation. The structure of an FMU RF power distribution circuit is suggested, consisting of an RF pre-matcher, an RF power meter, and, when required, an RF decoupler of a DC-grounded water-cooled mirror. Planar implementation of an RF pre-matching device is recognized as the most feasible and universal, as a result of analysis of various base element types. Three options of RF-decoupled mirror cooling manifolds are discussed, revealing an optimal selection of their electric and dimensional parameters. A structural implementation of a planar RF pre-matcher ceramic parts fastening is suggested, taking into account their integrity under inertial, neutron and thermal loads expected during ITER operation. Successful pilot tests of the RF pre-matcher performance and structural integrity demonstrate the promise of the described design approach.
High-quality tungsten coating deposition on sintered aluminum nitride ceramic substrates (both of thin flat chips and structural boxes) was realized using an adapted plasma-aided coating deposition rig. The tungsten coating produced using this technique and the accompanying apparatus setup are of high-purity, strong adhesion, and controlled three-dimensional uniformity (<20% thickness variations). The coating also exhibits well-structured and smooth (Ra < 1.0 µm) microscopic surface landscape with densely clustered tungsten granulations. The coated samples were tested under load conditions expected during ITER operation, including thermal cycling and superheated (up to 500°C) steam. Exposure to thermal cycles and hot steam made no apparent changes to the coating’s microscopic structure with no sign of cracks, blistering, or exfoliation seen under electron microscopy. These successes validated the microwave shield design for the ITER high-frequency magnetic sensor, which is based on this concept, and laid a solid foundation for the production of this component in the forthcoming procurement phase. Besides, a failure test was conducted for the tungsten coating in the temperature range of 500°C to 1500°C. Surface smoothing, pores, delamination, and mass loss in substrate were observed when temperature exceeded 1000°C, possibly due to the evaporation of aluminum atoms. These findings unveiled the changes of tungsten coating properties under extreme conditions that are of both academic and practical values.
The challenges of large-scale mirror design for in-vessel collection system of ITER Divertor Thomson Scattering (DTS) are under consideration. These are the mirrors located out-of-line vision of fusion plasma (so called “second mirrors” i.e. not First Mirrors) with high-reflective Ag-based coating. The paper outlines: approaches providing optical surface shape and angular position stability; Ag coating applicability in nuclear irradiation, ITER in-vessel application and its resistance to Steam Ingress. Although, this assessment and the proposed solutions are considered in terms of ITER DTS compatibility, they may also appear to be of some use in other ITER diagnostics and in diagnostics of other fusion devices.