Akifumi Kasamatsu

Akifumi Kasamatsu

Auto-generated profile, based on publicly available information

Akifumi Kasamatsu

National Institute of Information and Communications Technology, Tokyo, Japan

Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 July 2022 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Open access
SHShinsuke Hara
Shinsuke Hara
RDRuibing Dong
Ruibing Dong
SLSangyeop Lee
Sangyeop Lee
KTKyoya Takano
Kyoya Takano
NTNaoya Toshida
Naoya Toshida
MFMinoru Fujishima
Minoru Fujishima
A 76-Gbit/s 265-GHz CMOS receiver (RX) modularized with a WR-3.4 waveguide interface is presented. It is a mixer-first RX fabricated using a 40-nm CMOS technology. The primary design focus is simplicity and the resulting low noise and loss and high conversion gain (CG). To allow for both on-wafer and packaged measurements, ON-chip transmission lines are designed such that their characteristics are relatively insensitive to the presence or absence of adhesive covering the chip. The RX chip is flip-chip-mounted on a multilayer printed circuit board (PCB). Built into the PCB is a waveguide transition using double-resonant stacked patches for wideband operation. The CMOS RX module achieves the highest wireless data rate of 76 Gbit/s with 16 QAM, which is comparable to 80 Gbit/s reported previously for a CMOS RX with on-wafer probing measurement.

19 December 2024 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Open access
CLChenxin Liu
Chenxin Liu
ZLZheng Li
Zheng Li
YYYudai Yamazaki
Yudai Yamazaki
HHHans Herdian
Hans Herdian
CWChun Wang
Chun Wang
KOKenichi Okada
Kenichi Okada
This work presents a D-band (110–170 GHz) CMOS transceiver (TRX) chipset that covers a 56-GHz (114–170 GHz) signal-chain bandwidth. Both the transmitter (TX) and the receiver (RX) operate as heterodyne architectures with external intermediate frequency (IF) and local oscillator (LO) signals. An eight-way low- Q power-combined power amplifier (PA), a two-way low- Q power-combined low-noise amplifier (LNA), wideband-impedance-transformation passive mixers, common-source-based cascaded distributed amplifiers (DAs), and a low-loss wideband chip-to-waveguide printed circuit board (PCB) transition are proposed with improved bandwidth and linearity to support high-order wideband quadrature amplitude modulation (QAM) signals. The TRX chipset was fabricated using a 65-nm CMOS process. The TX achieves a 13-dBm saturated output power at 130 GHz with 1150-mW dc power. The RX achieves a 12-dB noise figure (NF) with 550-mW dc power. The proposed TRX chipset achieves a data rate of 200 Gb/s by 32QAM in the single-input–single-output (SISO) over-the-air (OTA) measurement at 0.32 m. A data rate of 150 Gb/s by 16QAM is realized with 43-dBi antennas at 15 m. Additionally, a 640-Gb/s 4 $\times$ 4 OTA line-of-sight multiinput multioutput (LOS-MIMO) is demonstrated at 0.52 m.

7 December 2021 in IEEE Open Journal of Antennas and Propagation
Verified
Journal Article
Open access
YTYusuke Tanaka
Yusuke Tanaka
GDGuillaume Ducournau
Guillaume Ducournau
CBCybelle Belem-Goncalves
Cybelle Belem-Goncalves
FGFrederic Gianesello
Frederic Gianesello
CLCyril Luxey
Cyril Luxey
SHShintaro Hisatake
Shintaro Hisatake
In this study, photonics-based near-field measurement and far-field characterization in a 300-GHz band are demonstrated using an electrooptic (EO) sensor with planar scanning. The field to be measured is up-converted to the optical domain (1550 nm) at the EO sensor and delivered to the measurement system with optical fiber. The typical phase drift of the system is 0.46° for the one-dimensional measurement time of 13 s, which is smaller than the standard deviation of the phase measurement of 1.2° for this time scale. The far-field patterns of a horn antenna calculated from the measured near-field distribution are compared with that measured with the direct far-field measurement system using a vector network analyzer. For the angular related parameters, the accuracy of the results obtained by our near-field measurement are comparable to that of those obtained by direct far-field measurements. The sidelobe level discrepancy (approximately 1 dB) between the results obtained based on our near-field measurement and those from the direct far-field measurements are attributed to the excess noise of the probe correction data. We believe that photonics-based near-field measurements with spherical EO probe scanning will pave the way for the characterization of high-gain antennas at the 300-GHz band.

8 November 2022 in IEEE Transactions on Terahertz Science and Technology
Verified
Journal Article
Closed access
Ruibing DongRuibing Dong
Ruibing Dong
SHShinsuke Hara
Shinsuke Hara
STSatoru Tanoi
Satoru Tanoi
THTatsuo Hagino
Tatsuo Hagino
IWIssei Watanabe
Issei Watanabe
AKAkifumi Kasamatsu
Akifumi Kasamatsu
A novel × 6 frequency multiplier chain with center frequency of 260 GHz is developed in 40 nm CMOS and measured through this work. The multiplication is accomplished through an x3 frequency multiplier followed by a doubler successive stage. A 4-way signal combiner is employed to enhance the output power, whereas phase shifters are dedicated for compensating the possible phase deviations between the different combined ways, and consequently maintain the combining efficiency. For further output power boosting, the output matching network of 260 GHz frequency doubler is optimized, and a stacked amplifier with 11.5 dBm is employed as a driving amplifier. The multiplier has been fabricated and a peak output power of 3.0 dBm is measured at 260 GHz with a 3-dB bandwidth of 17 GHz.

9 October 2003 in Applied Surface Science
Verified
Journal Article
Closed access
AKA Kasamatsu
A Kasamatsu
KKK Kasai
K Kasai
KHK Hikosaka
K Hikosaka
TMT Matsui
T Matsui
TMT Mimura
T Mimura

4 June 2025 in IEEE Microwave and Wireless Technology Letters
Verified
Journal Article
Open access
YMYohei Morishita
Yohei Morishita
KTKen Takahashi
Ken Takahashi
RHRyosuke Hasaba
Ryosuke Hasaba
AEAkihiro Egami
Akihiro Egami
TATomoki Abe
Tomoki Abe
KTKoji Takinami
Koji Takinami
To realize the practical application of sub-THz band wireless communication toward 6G, it is necessary to develop AiP modules with compact size and low cost. This letter discusses the design of a miniaturized AiP module for high-speed wireless communication targeting extended reality (XR) applications in medical operating rooms as an example of 6G use cases. By integrating waveguide antenna array along with a compact divider/combiner within the multilayer substrates, the module achieves a small form factor of $8.42\times 20.0\times 1.37$ mm while integrating radio frequency integrated circuit (RFIC) and peripheral surface mount components. The measurement shows a data rate of 40 Gb/s at a 3 m distance in the 150 GHz band with an excellent transmission energy efficiency of 35.7 pJ/bit.