Shinsuke Hara

Shinsuke Hara

Auto-generated profile, based on publicly available information

Shinsuke Hara

National Institute of Information and Communications Technology, Tokyo, Japan

Research Focus & Metrics

Academic Career Length

36Years (1991-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 July 2022 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Open access
SHShinsuke Hara
Shinsuke Hara
RDRuibing Dong
Ruibing Dong
SLSangyeop Lee
Sangyeop Lee
KTKyoya Takano
Kyoya Takano
NTNaoya Toshida
Naoya Toshida
MFMinoru Fujishima
Minoru Fujishima
A 76-Gbit/s 265-GHz CMOS receiver (RX) modularized with a WR-3.4 waveguide interface is presented. It is a mixer-first RX fabricated using a 40-nm CMOS technology. The primary design focus is simplicity and the resulting low noise and loss and high conversion gain (CG). To allow for both on-wafer and packaged measurements, ON-chip transmission lines are designed such that their characteristics are relatively insensitive to the presence or absence of adhesive covering the chip. The RX chip is flip-chip-mounted on a multilayer printed circuit board (PCB). Built into the PCB is a waveguide transition using double-resonant stacked patches for wideband operation. The CMOS RX module achieves the highest wireless data rate of 76 Gbit/s with 16 QAM, which is comparable to 80 Gbit/s reported previously for a CMOS RX with on-wafer probing measurement.

19 December 2024 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Open access
CLChenxin Liu
Chenxin Liu
ZLZheng Li
Zheng Li
YYYudai Yamazaki
Yudai Yamazaki
HHHans Herdian
Hans Herdian
CWChun Wang
Chun Wang
KOKenichi Okada
Kenichi Okada
This work presents a D-band (110–170 GHz) CMOS transceiver (TRX) chipset that covers a 56-GHz (114–170 GHz) signal-chain bandwidth. Both the transmitter (TX) and the receiver (RX) operate as heterodyne architectures with external intermediate frequency (IF) and local oscillator (LO) signals. An eight-way low- Q power-combined power amplifier (PA), a two-way low- Q power-combined low-noise amplifier (LNA), wideband-impedance-transformation passive mixers, common-source-based cascaded distributed amplifiers (DAs), and a low-loss wideband chip-to-waveguide printed circuit board (PCB) transition are proposed with improved bandwidth and linearity to support high-order wideband quadrature amplitude modulation (QAM) signals. The TRX chipset was fabricated using a 65-nm CMOS process. The TX achieves a 13-dBm saturated output power at 130 GHz with 1150-mW dc power. The RX achieves a 12-dB noise figure (NF) with 550-mW dc power. The proposed TRX chipset achieves a data rate of 200 Gb/s by 32QAM in the single-input–single-output (SISO) over-the-air (OTA) measurement at 0.32 m. A data rate of 150 Gb/s by 16QAM is realized with 43-dBi antennas at 15 m. Additionally, a 640-Gb/s 4 $\times$ 4 OTA line-of-sight multiinput multioutput (LOS-MIMO) is demonstrated at 0.52 m.

8 November 2022 in IEEE Transactions on Terahertz Science and Technology
Verified
Journal Article
Closed access
Ruibing DongRuibing Dong
Ruibing Dong
SHShinsuke Hara
Shinsuke Hara
STSatoru Tanoi
Satoru Tanoi
THTatsuo Hagino
Tatsuo Hagino
IWIssei Watanabe
Issei Watanabe
AKAkifumi Kasamatsu
Akifumi Kasamatsu
A novel × 6 frequency multiplier chain with center frequency of 260 GHz is developed in 40 nm CMOS and measured through this work. The multiplication is accomplished through an x3 frequency multiplier followed by a doubler successive stage. A 4-way signal combiner is employed to enhance the output power, whereas phase shifters are dedicated for compensating the possible phase deviations between the different combined ways, and consequently maintain the combining efficiency. For further output power boosting, the output matching network of 260 GHz frequency doubler is optimized, and a stacked amplifier with 11.5 dBm is employed as a driving amplifier. The multiplier has been fabricated and a peak output power of 3.0 dBm is measured at 260 GHz with a 3-dB bandwidth of 17 GHz.

29 January 2013 in physica status solidi (c)
Verified
Journal Article
Closed access
PDF file
SHShinsuke Hara
Shinsuke Hara
RMRyuto Machida
Ryuto Machida
KYKeisuke Yoshiki
Keisuke Yoshiki
KIKatsumi Irokawa
Katsumi Irokawa
HMHirofumi Miki
Hirofumi Miki
HFHiroki I. Fujishiro
Hiroki I. Fujishiro

11 July 2014 in IEEE Communications Letters
Verified
Journal Article
Open access
KNKensuke Nakanishi
Kensuke Nakanishi
SHShinsuke Hara
Shinsuke Hara
TMTakahiro Matsuda
Takahiro Matsuda
KTKenichi Takizawa
Kenichi Takizawa
FOFumie Ono
Fumie Ono
RMRyu Miura
Ryu Miura
Delay tomography has so far burdened source and receiver measurement nodes in a network with two requirements: path establishment and clock synchronization between them. In this letter, we focus on the clock synchronization problem in delay tomography and propose a synchronization-free delay tomography scheme based on compressed sensing. The proposed scheme selects a path between source and receiver measurement nodes as the reference path, which results in a loss of equation in a conventional delay tomography problem. By utilizing compressed sensing, however, the proposed scheme becomes robust to the loss. Simulation experiments confirm that the proposed scheme works comparable to a conventional delay tomography scheme in a network with no clock synchronization between source and receiver measurement nodes.

4 June 2025 in IEEE Microwave and Wireless Technology Letters
Verified
Journal Article
Open access
YMYohei Morishita
Yohei Morishita
KTKen Takahashi
Ken Takahashi
RHRyosuke Hasaba
Ryosuke Hasaba
AEAkihiro Egami
Akihiro Egami
TATomoki Abe
Tomoki Abe
KTKoji Takinami
Koji Takinami
To realize the practical application of sub-THz band wireless communication toward 6G, it is necessary to develop AiP modules with compact size and low cost. This letter discusses the design of a miniaturized AiP module for high-speed wireless communication targeting extended reality (XR) applications in medical operating rooms as an example of 6G use cases. By integrating waveguide antenna array along with a compact divider/combiner within the multilayer substrates, the module achieves a small form factor of $8.42\times 20.0\times 1.37$ mm while integrating radio frequency integrated circuit (RFIC) and peripheral surface mount components. The measurement shows a data rate of 40 Gb/s at a 3 m distance in the 150 GHz band with an excellent transmission energy efficiency of 35.7 pJ/bit.